Engineering Papers⌕ Search

Engineering topics

Shinn, J. L.

Publications and source records attributed to Shinn, J. L..

67 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1990

Risk assessment methodologies for target fragments produced in high-energy nucleon reactions

Collisions of energetic protons with target nuclei yield nuclear products of large linear energy transfer, and it is usually assumed that the energy of the heavy products is absorbed locally with a quality factor of 20. Past methods of risk assessment have relied on the Bertini (1969) model to evaluate the nuclear reaction products. If the Q(F) of 20 is correct, then a significant underestimate of biological risk from the nuclear products could result from the use of Bertini's model. On the other hand, a Q(F) of 20 is probably too large for some of the lighter fragments, leaving prior risk estimates as possibly correct or even conservative. This issue is discussed here in the context of the recently proposed nuclear data set of Wilson et al. (1989).

Shinn, J. L.↗
NASA NTRS1990

Radiation protection effectiveness of a proposed magnetic shielding concept for manned Mars missions

The effectiveness of a proposed concept for shielding a manned Mars vehicle using a confined magnetic field configuration is evaluated by computing estimated crew radiation exposures resulting from galactic cosmic rays and a large solar flare event. In the study the incident radiation spectra are transported through the spacecraft structure/magnetic shield using the deterministic space radiation transport computer codes developed at Langley Research Center. The calculated exposures unequivocally demonstrate that magnetic shielding could provide an effective barrier against solar flare protons but is virtually transparent to the more energetic galactic cosmic rays. It is then demonstrated that through proper selection of materials and shield configuration, adequate and reliable bulk material shielding can be provided for the same total mass as needed to generate and support the more risky magnetic field configuration.

Townsend, Lawrence W.↗
NASA NTRS1987

Extension of a semi-implicit shock-capturing algorithm for 3-D fully coupled, chemically reacting flows in generalized coordinates

A semiimplicit high-resolution shock-capturing method for multidimensional systems of hyperbolic conservation laws with stiff source terms has been developed by Yee and Shinn (1987). The goal of this work is to extend this method to solve the three-dimensional fully coupled Navier-Stokes equations for a hypersonic chemically reacting flow in generalized coordinates. In this formulation, the global continuity equation was replaced by all the species continuity equations. The shock-capturing technique is a second-order-accurate, symmetric total-variation-diminishing method which accounts fully and directly for the coupling among the fluid and all the species. To verify the current approach, it was implemented into an existing computer code which contained the MacCormack method. Test results for a five-species reacting flow are shown to be oscillation-free around the shock, and the time spent per iteration only doubles when compared to the result using classical way of supplying numerical dissipation. The extra computation is more than justified by the elimination of spurious oscillation and nonlinear instability associated with the classical shock-capturing schemes in computing hypersonic reacting flows.

Shinn, J. L.↗
NASA NTRS1986

Semi-implicit and fully implicit shock-capturing methods for hyperbolic conservation laws with stiff source terms

Some numerical aspects of finite-difference algorithms for nonlinear multidimensional hyperbolic conservation laws with stiff nonhomogenous (source) terms are discussed. If the stiffness is entirely dominated by the source term, a semi-implicit shock-capturing method is proposed provided that the Jacobian of the soruce terms possesses certain properties. The proposed semi-implicit method can be viewed as a variant of the Bussing and Murman point-implicit scheme with a more appropriate numerical dissipation for the computation of strong shock waves. However, if the stiffness is not solely dominated by the source terms, a fully implicit method would be a better choice. The situation is complicated by problems that are higher than one dimension, and the presence of stiff source terms further complicates the solution procedures for alternating direction implicit (ADI) methods. Several alternatives are discussed. The primary motivation for constructing these schemes was to address thermally and chemically nonequilibrium flows in the hypersonic regime. Due to the unique structure of the eigenvalues and eigenvectors for fluid flows of this type, the computation can be simplified, thus providing a more efficient solution procedure than one might have anticipated.

Yee, H. C.↗
NASA NTRS1984

Comparison of viscous-shock-layer heating analysis with Shuttle flight data in slip flow regime

Comparison of STS-2 Shuttle flight heating data along the windward centerline has been made with two-dimensional nonequilibrium viscous shock-layer solutions obtained with shock and wall-slip conditions at an altitude range of 90 to 110 km. The shock slip condition used is the modified Rankine-Hugoniot relations of Cheng as used by Davis, and the wall-slip conditions are based on the first order consideration derived from kinetic theory as given by Scott and Hendricks. The results indicate that the calculated heating distributions with slip boundary conditions agree better with the flight data than those without slip conditions. The agreement improves when the accommodation coefficient or freestream density is decreased to one-half, suggesting the possibility of less than full accommodation for the tile surface and (or) an overestimate of freestream density using the Jacchia-Roberts model. Heating reduction due to the slip effect becomes very pronounced as the flow becomes more rarefied, and the effect is more significant for the stagnation region than the aft region of the vehicle.

Shinn, J. L.↗
NASA NTRS1983

Space Shuttle heating analysis with variation in angle of attack and surface condition

The effects of variations in the angle of attack and surface catalycity condition on the Space Shuttle surface heating along the windward centerline are evaluated. Further, the time history of the nonequilibrium-to-equilibrium surface heating ratio and the boundary edge quantities are analyzed. Results show that a + or - 5% change in the angle of attack does not appreciably influence either the nonequilibrium heating or the nonequilibrium-to-equilibrium heat transfer ratio at higher (75 km) or lower (48 km) altitudes. The variation in the recombination rate parameter is found to affect the surface heating most at an altitude of about 75 km for the STS-2 flight. A maximum reduction of 49% in heating due to nonequilibrium chemistry is obtained at about a 75 km altitude in the nose region of the Orbiter for the STS-2 flight data. In addition, the nonequilibrium effects at the boundary layer edge are found to become less significant for altitudes less than 65 km even though the boundary layer flow may still be in nonquilibrium.

Gupta, R. N.↗
NASA NTRS1983

Chemical nonequilibrium effects on flowfields for aeroassist orbital transfer vehicles

Acceptable altitude and velocity ranges for the perigee of aeroassist orbital transfer vehicles (AOTV) have been determined for various values of ballistic coefficient and lift-to-drag ratio. The chemical nonequilibrium effect on the flowfield of a simple but representatively high-drag, blunt configuration was investigated for these perigee conditions, ranging from 73 to 90 km in altitude and 8 to 9.3 km/s in velocity. The analysis was performed using a two-dimensional viscous-shock-layer code which had previously demonstrated good success in predicting nonequilibrium heating on the Space Shuttle. The results indicate lower ratio of nonequilibrium/equilibrium heating for the present AOTV perigee conditions than for the Shuttle flight conditions, due to higher velocity. The trend for the degree of nonequilibrium with the effect of varying wall catalycity and configuration was determined over the altitude range. Some implications to future design consideration are stated.

Shinn, J. L.↗
NASA NTRS1982

Viscous-shock-layer heating analysis for the shuttle windward-symmetry plane with surface finite catalytic recombination rates

The paper demonstrates the capability of a reacting, two-dimensional viscous-shock-layer solution using the equivalent axisymmetric body concept to predict heating rates on the shuttle windward centerline for a wide range of altitudes. Results indicate that the nonequilibrium effects persist through most of the STS-2 entry heating pulse down to an altitude of about 50 km. When results are compared to those of the inviscid flowfield plus boundary layer solution of Scott (1980), agreement is fair to poor for nonequilibrium calculations, although very good for equilibrium calculations. A parametric study to demonstrate the effect of uncertainties in oxygen surface recombination rate for RCG coated HRSI on heating, indicates favorable results when a wall recombination rate of 100 cm/sec is used in the temperature range 1400-900 K.

Shinn, J. L.↗
NASA NTRS1981

Optical absorption of carbon and hydrocarbon species from shock heated acetylene and methane in the 135-220 nm wavelength range

Absorption spectroscopy of carbon and hydrocarbon species has been performed in a shock tube at an incident shock condition for a wavelength range of 135-220 nm, in order to obtain information needed for calculating radiation blockage ahead of a planetary probe. Instrumentation consisted of high frequency response pressure transducers, thin-film heat transfer gages, or photomultipliers coupled by light pipes. Two test-gas mixtures, one with acetylene and the other with methane, both diluted with argon, were used to provide a reliable variation of C3 and C2H concentration ratio. Comparison of tests results of the two mixtures, in the temperature range of 3750 + or - 100 K, showed the main absorbing species to be C3. The wavelength for maximum absorption agrees well with the theoretical values of 7.68 eV and 8.03 eV for the vertical excitation energy, and a value of 0.90 for the electronic oscillator strength, obtained from the measured absorption band, is also in good agreement with the predicted value of 0.92.

Shinn, J. L.↗
NASA NTRS1980

Comparison of predicted and experimental real-gas pressure distributions on space shuttle orbiter nose for shuttle entry air data system

An experimental investigation of inviscid real-gas effects on the pressure distribution along the Space Shuttle Orbiter nose center line up to an angle of attack of 32 deg was performed in support of the Shuttle Entry Air Data System (SEADS). Free-stream velocities from 4.8 to 6.6 kn/s were generated at hypersonic conditions with helium, air, and CO2, resulting in normal-shock density ratios from 3.7 to 18.4. The experimental results for pressure distribution agreed closely with numerical results. Modified Newtonian theory deviates from both experiment and the numerical results as angle of attack increases or shock density ratio decreases. An evaluation of the use of modified Newtonian theory for predicting SEADS pressure distributions in actual flight conditions was made through comparison with numerical predictions.

Shinn, J. L.↗
NASA NTRS1978

Experimental perfect-gas study of expansion-tube flow characteristics

Results of an experimental investigation of expansion tube flow characteristics performed with helium test gas and acceleration gas are presented. The use of helium, eliminates complex real gas chemistry in the comparison of measured and predicted flow quantities. The driver gas was unheated helium at a nominal pressure of 33 MN sq m. The quiescent test gas pressure and quiescent acceleration gas pressure were varied from 0.7 to 50 kN/sq m and from 2.5 to 53 N/sq m, respectively. The effects of tube-wall boundary layer growth and finite secondary diaphragm opening time were examined through the variation of the quiescent gas pressures and secondary diaphragm thickness. Optimum operating conditions for helium test gas were also defined.

Shinn, J. L.↗