Engineering Papers⌕ Search

Engineering topics

Shaughnessy, Dawn A.

Publications and source records attributed to Shaughnessy, Dawn A..

8 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Radiochemical diagnostics at the National Ignition Facility

Since the National Ignition Facility (NIF) was commissioned in 2009, radiochemical techniques have been viewed as a potential method for diagnosing the performance of an NIF fusion shot. Radiochemical methods can also be used in conjunction with NIF shots to measure nuclear reaction cross sections in regimes that are inaccessible at accelerator facilities and can provide a route to produce radioactive tracer materials that can be used for other applications. Here, this review presents the current status of radiochemical diagnostics at the NIF. Experimental results and the status of both solid and gaseous debris collection radiochemistry are presented.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗
DOE OSTI2022

Radiochemical capabilities for astrophysics experiments at the national ignition facility

The Nuclear and Radiochemistry Group at Lawrence Livermore National Laboratory (LLNL) has developed a suite of diagnostics and techniques that can be used for astrophysics experiments at the National Ignition Facility (NIF). Capabilities have been developed to add material to the outside of NIF hohlraum assemblies as well as to the interior of NIF target capsules or the fill gas. The ability to place very small amounts of material close to the NIF target enables activation with very large, short-pulse neutron fluxes. The Solid Radiochemistry Diagnostic can be used to collect solid debris from a NIF shot within 2 h of the execution of a shot, and this can be analyzed for radioactive signatures with or without post-shot chemical processing. The Radiochemical Analysis of Gaseous Samples diagnostic system can be used to collect gaseous products produced during a NIF shot. Capsule doping and radiochemical analysis capabilities at NIF will be discussed. The application of these techniques to astrophysical measurements will be discussed as well as some preliminary results.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗
DOE OSTI2021

Measurement of the 230 Th( p ,2n)Pa229 and 230 Th( p ,3n)Pa228 reaction cross sections from 14.1 to 16.9 MeV

Actinium-225 is of interest for medical isotope production and there is on-going research into methods of producing Ac 225 , either directly or via the decay of its parent isotopes ( Th 229 , Pa 229 , and Ra 225 ). One method that has been suggested is the Th 230 ( p , 2 n ) Pa 229 reaction. However, there is no available cross-section data for this reaction in the literature. Purpose: Measure the Th 230 ( p , 2 n ) and Th 230 ( p , 3 n ) reaction cross sections in the energy range where the ( p , 2 n ) reaction is predicted to peak to determine the feasibility of Ac 225 production via the Th 230 ( p , 2 n ) reaction. Methods: Targets naturally enriched in Th 230 were irradiated at the Center for Accelerator Mass Spectrometry at Lawrence Livermore National Laboratory with energies ranging from 14.1 to 16.9 MeV. Furthermore, chemical processing was used to separate the protactinium activation products, followed by γ -ray spectroscopy to measure the activities of Pa 228 , 229 , 230 , 232 produced in the irradiation. Results: We find that excitation functions are reported for the first time in the literature for the Th 230 ( p , 2 n ) and Th 230 ( p , 3 n ) reactions in this energy range. The peak measured value of the Th 230 ( p , 2 n ) reaction was found to be 182 ± 12 mb at 14.4 ± 0.1 MeV. The Th 232 ( p , n ) Pa 232 reaction was used to verify the experimental conditions, the measured values are reported and are comparable to the existing literature values. From the γ -ray spectrometry data, the half-life of Pa 229 was measured as 1.5 ± 0.1 days, which is within the error of the half-life reported in the evaluated nuclear data as well as in the recent measurements, and the half-life of Pa 228 was measured as 19.5 ± 0.4 hours. Conclusions: Overall, the Th 230 ( p , 2 n ) Pa 229 reaction could reasonably be used for Ac 225 isotope production, although significant amounts of relatively isotopically pure Th 230 would be needed for significant production because the low alpha-decay branching ratio of Pa 229 and long half-life of Th 229 inhibit the in-growth of significant amounts of Ac 225 .

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗
DOE OSTI2021

Extraction of radium and actinium with Pb resin and Rose Bengal

The extraction of radium and actinium with Eichrom Pb resin and Rose Bengal has been studied. Radium and actinium both show a strong affinity (k’ > 10,000) for the resin at intermediate pHs (~ 5–7) from solutions with Rose Bengal. The pH range and magnitude of uptake for both radium and actinium is significantly increased by the presence of Rose Bengal compared to basic solutions without this counter ion. Additionally, radium uptake is extremely fast from basic solutions with and without Rose Bengal; actinium uptake is slower, particularly in solutions without Rose Bengal. Column studies show that despite the similar behavior of actinium and radium in this system, separations of these two elements with Pb resin and Rose Bengal solutions are possible with reasonable yields due to the differences in uptake kinetics.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗
DOE OSTI2021

Aqueous harvesting of 88 Zr at a radioactive-ion-beam facility for cross-section measurements

Isotope harvesting is a method of collecting the long-lived radioisotopes that build up during the operation of ion-beam facilities in a way that is useful for subsequent research. As a demonstration of this method for the collection of a group IV metal at a fragmentation facility, the high-energy Zr 88 secondary beam produced from a 140-MeV/u Mo 92 primary beam at the National Superconducting Cyclotron Laboratory (NSCL) was stopped in a water target. The setup aimed to mimic the aqueous beam dump that will be implemented at the Facility for Rare Isotope Beams (FRIB). The collected Zr 88 and accompanying Y 88 decay daughter were radiochemically extracted from the solution and made into target samples suitable for neutron-capture cross-section measurements. These samples were then irradiated at two reactor facilities, and the Zr 88 average thermal-neutron-capture cross section ( σ T ) and resonance integral ( I ) were determined to be σ T = ( 8.04 ± 0.63 ) × 10 5 b and I = ( 2.53 ± 0.28 ) × 10 6 b. The σ T value agrees well with previous results and I , determined for the first time here, was found to be the largest measured resonance integral by two orders of magnitude. The Y 88 thermal-neutron-capture cross section was determined to be less than 1.8 × 10 4 b. This work demonstrates the steps needed to make cross-section measurements with samples produced via aqueous isotope harvesting.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗
DOE OSTI2021

Batch and column studies of radium, actinium, thorium and protactinium on CL resin in nitric acid, hydrochloric acid and hydrofluoric acid

CL resin (TrisKem International) was characterized for separations of radium, actinium, thorium and protactinium. Batch studies are presented for radium, actinium and thorium in HCl and HNO3 as well as for radium, thorium and protactinium in HF. The uptake of thorium from dilute HNO3 (≤ 10 -4 M) and dilute HCl (≤ 10 -4 M) was found to be very high (D w > 100 in HNO 3 and > 1000 in HCl). Kinetics studies on thorium were performed in HCl and HNO 3 to determine suitably for column separations. Six column separation studies are presented including the separation of trace thorium from radium and actinium in dilute HCl and HNO 3 , the separation of radium from 1 mg 232 Th in dilute HCl, the separation of thorium and radium in the presence of HCl and excess Cl-, the separation of radium, protactinium and thorium by retention of protactinium and the separation of protactinium and thorium by retention of thorium.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2021

Science & Technology Review: The Road to Exascale Computing

At Lawrence Livermore National Laboratory, we focus on science and technology research to ensure our nation’s security. We also apply that expertise to solve other important national problems in energy, bioscience, and the environment. Science & Technology Review is published eight times a year to communicate, to a broad audience, the Laboratory’s scientific and technological accomplishments in fulfilling its primary missions. The publication’s goal is to help readers understand these accomplishments and appreciate their value to the individual citizen, the nation, and the world. The Department of Energy’s Exascale Computing Project (ECP) and Lawrence Livermore’s RADIUSS (Rapid Application Development via an Institutional Universal Software Stack) initiative benefit from strategically developed software tools. The front cover shows a simulation of advection under twisting rotation that uses high-order finite elements from Livermore’s Modular Finite Element Methods (MFEM) software library and GLVis visualization tool. On the back cover, the logo (also created with GLVis) for the MFEM project illustrates the curved mesh and sub-element resolution used in high-order simulations. MFEM and GLVis are key components of the ECP’s co-design Center for Efficient Exascale Discretizations (CEED) and RADIUSS. MFEM is also part of ECP’s Extreme-Scale Scientific Software Development Kit (xSDK).

97 MATHEMATICS AND COMPUTING↗
DOE OSTI2020

Science & Technology Review August 2020

At Lawrence Livermore National Laboratory, we focus on science and technology research to ensure our nation’s security. We also apply that expertise to solve other important national problems in energy, bioscience, and the environment. Science & Technology Review is published eight times a year to communicate, to a broad audience, the Laboratory’s scientific and technological accomplishments in fulfilling its primary missions. The publication’s goal is to help readers understand these accomplishments and appreciate their value to the individual citizen, the nation, and the world.

36 MATERIALS SCIENCE↗