Engineering topics
Senanayake, Manjula
Publications and source records attributed to Senanayake, Manjula.
Investigation of Cyrene organosolv fractionation of softwood biomass and alkaline post-incubation
Cyrene organosolv fractionation effectively extracted 78% of lignin from recalcitrant softwood biomass pine at a mild temperature of 120°C. However, the enzymatic conversion of the fractionated cellulose-rich solid did not improve significantly. Alkali post-incubation of the fractionated cellulose fraction notably enhanced the glucan conversion. This phenomenon has also been observed in other organosolv processes, but how this approach transforms pretreated biomass has not yet been comprehensively investigated. In this study, small-angle X-ray scattering (SAXS) was employed to understand the structural changes in biomass during fractionation and post-incubation at the nanometer scale. Further, no lignin aggregation was found on the microfibrils, whereas the distance between the microfibrils increased after pretreatment and decreased after alkaline post-incubation. These results suggests that the Cyrene molecules remained between the microfibrils and were removed by post-incubation. In addition, the pine lignin recovered after pretreatment was characterized by NMR to understand the impact of Cyrene pretreatment on the lignin structure.
Ectopic Production of 3,4-Dihydroxybenzoate in Planta Affects Cellulose Structure and Organization
Lignocellulosic biomass is a highly sustainable and largely carbon dioxide neutral feedstock for the production of biofuels and advanced biomaterials. Although thermochemical pretreatment is typically used to increase the efficiency of cell wall deconstruction, genetic engineering of the major plant cell wall polymers, especially lignin, has shown promise as an alternative approach to reduce biomass recalcitrance. Poplar trees with reduced lignin content and altered composition were previously developed by overexpressing bacterial 3-dehydroshikimate dehydratase (QsuB) enzyme to divert carbon flux from the shikimate pathway. In this work, three transgenic poplar lines with increasing QsuB expression levels and different lignin contents were studied using small-angle neutron scattering (SANS) and wide-angle X-ray scattering (WAXS). SANS showed that although the cellulose microfibril cross-sectional dimension remained unchanged, the ordered organization of the microfibrils progressively decreased with increased QsuB expression. This was correlated with decreasing total lignin content in the QsuB lines. WAXS showed that the crystallite dimensions of cellulose microfibrils transverse to the growth direction were not affected by the QsuB expression, but the crystallite dimensions parallel to the growth direction were decreased by ~20%. Cellulose crystallinity was also decreased with increased QsuB expression, which could be related to high levels of 3,4-dihydroxybenzoate, the product of QsuB expression, disrupting microfibril crystallization. In addition, the cellulose microfibril orientation angle showed a bimodal distribution at higher QsuB expression levels. Altogether, this study provides new structural insights into the impact of ectopic synthesis of small-molecule metabolites on cellulose organization and structure that can be used for future efforts aimed at reducing biomass recalcitrance.
From ionic clusters dynamics to network constraints in ionic polymer solutions
Physical networks formed by ionizable polymers with ionic clusters as crosslinks are controlled by coupled dynamics that transcend from ionic clusters through chain motion to macroscopic response. Here, the coupled dynamics, across length scales, from the ionic clusters to the networks in toluene swollen polystyrene sulfonate networks, were directly correlated, as the electrostatic environment of the physical crosslinks was altered. The multiscale insight is attained by coupling neutron spin echo measurements with molecular dynamics simulations, carried out to times typical of relaxation of polymers in solutions. The experimental dynamic structure factor is in outstanding agreement with the one calculated from computer simulations, as the networks are perturbed by elevating the temperature and changing the electrostatic environment. In toluene, the long-lived clusters remain stable over hundreds of ns across a broad temperature range, while the polymer network remains dynamic. In conclusion, though the size of the clusters changes as the dielectric constant of the solvent is modified through the addition of ethanol, they remain stable but morph, enhancing the polymer chain dynamics.
Clustering Effects on the Structure of Ionomer Solutions: A Combined SANS and Simulations Study
Ionic assemblies, or clusters, determine the structure and dynamics of ionizable polymers and enable their many applications. Fundamental to attaining well-defined materials is controlling the balance between van der Waals interactions that govern the backbone behavior and the forces that drive the formation of ionic clusters. Here, using small angle neutron scattering and fully atomistic molecular dynamics simulations, the structure of a model ionomer, sulfonated polystyrene in toluene solutions, was investigated as the cluster cohesion was tweaked by the addition of ethanol. The static structure factor was measured by both techniques and correlated with the size of the ionic clusters as the polymer concentration was varied. The conjunction of SANS results and molecular insight from MD simulations enabled the determination of the structure in these inhomogeneous networks on multiple length scales. Additionally, we find that across the entire concentration range studied, a network driven by the formation of ionic clusters was formed, where the size of the clusters drives the inhomogeneity of these systems. Tweaking the ionic clusters through the addition of ethanol impacts the packing of the sulfonated groups, their shape, and their size distribution, which in turn, affects the structure of these networks.
Evidence for Lignin–Carbohydrate Complexes from Studies of Transgenic Switchgrass and a Model Lignin–Pectin Composite
Lignin–carbohydrate complexes (LCCs) form through interactions of lignin with plant cell wall polysaccharides and are thought to be a significant source of biomass recalcitrance. In this work, we investigated LCCs formed between lignin and pectin homogalacturonan (HG). The structural changes in HG deficient transgenic switchgrass (GAUT4-knockdown, GAUT4-KD) after hot water pretreatment were compared to wild-type plants using small-angle neutron scattering (SANS), which showed that there were ~2.2-fold more lignin aggregates in GAUT4-KD biomass compared to the wild type. This demonstrated that decreased pectin resulted in more lignin redistribution and suggested that interactions between lignin and HG restrict lignin mobility in plant cell walls. To better understand the types of interactions between lignin and pectin, a model composite was prepared by polymerizing either protiated or partially deuterated coniferyl alcohol to form a dehydrogenation polymer (DHP) in the presence of HG. Small-angle X-ray scattering (SAXS) showed that the DHP and HG form a highly interconnected network structure that is not observed in a physical mixture of the individual polymers. Contrast matching SANS revealed the structure of DHP and HG in the composite and showed that the HG forms a swollen interconnected polymer network (power-law exponent, P = 1.5) interspersed with DHP particles (radius of gyration, Rg, 264 Å) that are composed of solvent-accessible DHP polymers (P = 2.3). Fourier transform infrared spectroscopy showed a unique ester absorption band in the DHP/HG composites. Solid-state nuclear magnetic resonance (NMR) analysis also supports interactions between DHP and HG. Overall, this study provides new insights into the relationship between primary and secondary cell wall polymers during cell wall synthesis and how LCCs formed between pectin and lignin could represent a previously unrecognized source of biomass recalcitrance. This knowledge may help develop new approaches to modulate cell wall properties to improve biofuel and bioproduct production.