Engineering Papers⌕ Search

Engineering topics

Sellers, William L., III

Publications and source records attributed to Sellers, William L., III.

17 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2016

Numerical Simulation of a Complete Low-Speed Wind Tunnel Circuit

A numerical simulation of the complete circuit of the NASA Langley 14 x 22-ft low-speed wind tunnel is described. Inside the circuit, all turning vanes are modeled as well as the five flow control vanes downstream of the 1st corner. The fan drive system is modeled using an actuator disk for the fan blades coupled with the fan nacelle. All the surfaces are modeled as viscous walls except the turning vanes, which were modeled as inviscid surfaces. NASA Langley's TetrUSS unstructured grid software was used for grid generation and flow simulation. Two turbulence models were employed in the present study, namely, the one-equation Spalart-Allmaras model and the shear stress transport (SST) model of Menter. The paper shows the flow characteristics in the circuit and compares the results with experimental data where available.

Nayani, Sudheer N.↗
NASA NTRS2015

Numerical Study of the High-Speed Leg of a Wind Tunnel

The paper describes the numerical study of the high-speed leg of the NASA Langley 14 by 22-foot Low Speed Wind Tunnel. The high-speed leg consists of the Settling Chamber, Contraction, Test Section, and First Diffuser. Results are shown comparing two different exit boundary conditions and two different methods of determining the surface geometry.

Nayani, Sudheer↗
NASA NTRS2004

Active Flow Control Activities at NASA Langley

NASA Langley continues to aggressively investigate the potential advantages of active flow control over more traditional aerodynamic techniques. This paper provides an update to a previous paper and describes both the progress in the various research areas and the significant changes in the NASA research programs. The goals of the topics presented are focused on advancing the state of knowledge and understanding of controllable fundamental mechanisms in fluids as well as to address engineering challenges. An organizational view of current research activities at NASA Langley in active flow control as supported by several projects is presented. On-center research as well as NASA Langley funded contracts and grants are discussed at a relatively high level. The products of this research are to be demonstrated either in bench-top experiments, wind-tunnel investigations, or in flight as part of the fundamental NASA R&D program and then transferred to more applied research programs within NASA, DOD, and U.S. industry.

Anders, Scott G.↗
NASA NTRS2004

LDV Surveys Over a Fighter Model at Moderate to High Angles of Attack

The vortex flowfield over an advanced twin-tailed fighter configuration was measured in a low-speed wind tunnel at two angles of attack. The primary test data consisted of 3-component velocity surveys obtained using a Laser Doppler Velocimeter. Laser light sheet and surface flow visualization were also obtained to provide insight into the flowfield structure. Time-averaged velocities and the root mean square of the velocity fluctuations were obtained at two cross-sections above the model. At 15 degrees angle of attack, the vortices generated by the wing leading edge extension (LEX) were unburst over the model and passed outboard of the vertical tail. At 25 degrees angle of attack, the vortices burst in the vicinity of the wing-LEX intersection and impact directly on the vertical tails. The RMS levels of the velocity fluctuations reach values of approximately 30% in the region of the vertical tails.

Sellers, William L., III↗
NASA NTRS2003

Aerodynamics for Revolutionary Air Vehicles

Aeronautics research has seriously declined partly because of the perception that it is a mature science and only incremental improvements are possible. Recent aeronautics roadmapping activities at NASA Langley paint a different picture of the future. Breakthroughs are still felt to be possible if we expand the current design space of today's vehicles and optimize the airspace and vehicles as a system. The paper describes some of the challenges that the aircraft and airline industry face. These challenges include political, technical and environmental issues. Examples of the opportunities and technologies that could provide a different vision for the future are discussed.

Sellers, William L., III↗
NASA NTRS2002

Flow Control Research at NASA Langley in Support of High-Lift Augmentation

The paper describes the efforts at NASA Langley to apply active and passive flow control techniques for improved high-lift systems, and advanced vehicle concepts utilizing powered high-lift techniques. The development of simplified high-lift systems utilizing active flow control is shown to provide significant weight and drag reduction benefits based on system studies. Active flow control that focuses on separation, and the development of advanced circulation control wings (CCW) utilizing unsteady excitation techniques will be discussed. The advanced CCW airfoils can provide multifunctional controls throughout the flight envelope. Computational and experimental data are shown to illustrate the benefits and issues with implementation of the technology.

Sellers, William L., III↗
NASA NTRS1994

Effect of non-Poisson samples on turbulence spectra from laser velocimetry

Spectral analysis of laser velocimetry (LV) data plays an important role in characterizing a turbulent flow and in estimating the associated turbulence scales, which can be helpful in validating theoretical and numerical turbulence models. The determination of turbulence scales is critically dependent on the accuracy of the spectral estimates. Spectral estimations from 'individual realization' laser velocimetry data are typically based on the assumption of a Poisson sampling process. What this Note has demonstrated is that the sampling distribution must be considered before spectral estimates are used to infer turbulence scales.

Sree, Dave↗
NASA NTRS1992

Requirements for facilities and measurement techniques to support CFD development for hypersonic aircraft

The design of a hypersonic aircraft poses unique challenges to the engineering community. Problems with duplicating flight conditions in ground based facilities have made performance predictions risky. Computational fluid dynamics (CFD) has been proposed as an additional means of providing design data. At the present time, CFD codes are being validated based on sparse experimental data and then used to predict performance at flight conditions with generally unknown levels of uncertainty. This paper will discuss the facility and measurement techniques that are required to support CFD development for the design of hypersonic aircraft. Illustrations are given of recent success in combining experimental and direct numerical simulation in CFD model development and validation for hypersonic perfect gas flows.

Sellers, William L., III↗
NASA NTRS1990

Detailed flow-field measurements over a 75 deg swept delta wing

Results from an experimental investigation documenting the flowfield over a 75 deg swept delta wing at an angle-of-attack of 20.5 deg are presented. Results obtained include surface flow visualization, off-body flow visualization, and detailed flowfield surveys for various Reynolds numbers. Flowfield surveys at Reynolds numbers of 0.5, 1.0, and 1.5 million based on the root chord were conducted with both a Pitot pressure probe and a 5-hole pressure probe; and 3-component laser velocimeter surveys were conducted at a Reynolds number of 1.0 million. The Pitot pressure surveys were obtained at 5 chordwise stations, the 5-hole probe surveys were obtained at 3 chordwise stations and the laser velocimeter surveys were obtained at one station. The results confirm the classical roll up of the flow into a pair of primary vortices over the delta wing. The velocity measurements indicate that Reynolds number has little effect on the global structure of the flowfield for the Reynolds number range investigated. Measurements of the non-dimensional axial velocity in the core of the vortex indicate a jet like flow with values greater than twice freestream. Comparisons between velocity measurements from the 5-hole pressure probe and the laser velocimeter indicate that the pressure probe does a reasonable job of measuring the flowfield quantities where the velocity gradients in the flowfield are low.

Kjelgaard, Scott O.↗
NASA NTRS1990

An embedded grid formulation applied to a delta wing

Applications using a three-dimensional embedded grid scheme are made to high angle of attack viscous flow over two bodies: a slender cone using the conical approximation and a 75 deg swept delta wing. The embedded grids are used principally to improve the numerical resolution of the separated vortical flow above the body. Detailed comparisons are made with experimental measurements of the velocity field over the delta wing. The prediction of the maximum steamwise velocity is improved using two levels of embedded grid refinement but is still less than the experimental measurements available from a laser velocimeter.

Krist, Sherrie L.↗
NASA NTRS1988

Detailed flowfield measurements over a 75 deg swept delta wing for code validation

Selected results from an experimental investigation documenting the flowfield over 75 deg swept delta wing at an angle-of-attack of 20.5 deg are presented. Results obtained in the investigation include surface flow visualization, off-body flow visualization, and detailed flowfield surveys for various Reynolds numbers. Flowfield surveys at Reynolds numbers of 0.5, 1.0 and 1.5 million were conducted with both a pitot pressure probe and a 5-hole pressure probe; and 3-component laser Doppler velocimeter surveys were conducted at a Reynolds number of 1.0 million. The pitot pressure surveys were obtained at 5 longitudinal stations, the 5-hole probe surveys were obtained at 3 longitudinal stations and the laser Doppler velocimeter surveys were obtained at one station. The accuracy of each instrumentation system is discussed, as well as, discrepancies in the calculation of vorticity using various algorithms.

Kjelgaard, Scott O.↗
NASA NTRS1988

LDV surveys over a fighter model at moderate to high angles of attack

The vortex flowfield over an advanced twin-tailed fighter configuration has been studied in a low-speed wind tunnel at two angles of attack using LDV, along with laser light sheet and surface flow visualizations. At 15 deg angles of attack, the vortices generated by the wing leading edge extension (LEX) were found to be unburst over the model and to pass outboard of the vertical tail. At 25 deg angle of attack, the vortices were shown to burst in the vicinity of the wing-LEX intersection and to impact directly on the vertical tails.

Sellers, William L., III↗
NASA NTRS1988

The Basic Aerodynamics Research Tunnel - A facility dedicated to code validation

Computational fluid dynamics code validation requirements are discussed together with the need for close interaction between experiment and code development. Code validation experiments require a great deal of data and for the experiments to be successful, a highly-productive research facility is required. A description is provided of the NASA Langley Basic Aerodynamics Research Tunnel (BART); especially the instrumentation and experimental techniques that make the facility ideally suited to code validation experiments. Results are presented from recent tests which illustrate the techniques used in BART.

Sellers, William L., III↗
NASA NTRS1988

Riblet drag reduction at flight conditions

Paper describes perforated and nonperforated riblet tests on the fuselage of a modified Learjet Model 28/29 twin-engine business jet at Reynolds numbers 1.0-2.75 x 10 to the 6th/ft and Mach numbers 0.3-0.7. Drag reductions of the order of 6 percent at nondimensional wall spacings of 12 were obtained using boundary-layer rakes and direct drag balances. At the measurement locations the Reynolds number based on distance was 1.0-46 x 10 to the 6th. The nondimensional wall spacing for maximum drag reduction was well-predicted by low-speed wind-tunnel data, but the maximum drag reduction was lower. The low drag is tentatively ascribed to various instrumentation difficulties and the flow field on the aircraft. Riblets with 0.010-in. perforations at center spacings of 0.25 in. were found to give the same drag reduction as nonperforated riblets.

Walsh, Michael J.↗
NASA NTRS1987

Inflow velocity measurements made on a helicopter rotor using a two-component Laser Velocimeter

An experimental investigation was conducted in the 14- by 22-Foot Subsonic Tunnel at NASA Langley Research Center to measure the inflow into a scale model helicopter rotor in forward flight. The measurements were made with a two component Laser Velocimeter (LV) one chord above the plane formed by the path of the rotor tips (tips path plane). A conditional sampling technique was employed to determine the position of the rotor at the time that each velocity measurement was made so that the azimuthal fluctuations in velocity could be determined. The results of these tests were compared with inflow velocities predicted by a current technology rotor wake analysis program.

Elliott, Joe W.↗
NASA NTRS1986

Measurement of leading edge vortices from a delta wing using a three component laser velocimeter

An investigation of the flow field above a 75-deg swept delta wing at a 20.5-deg angle of attack is described. The experiment was performed in the NASA Langley Basic Aerodynamic Research Tunnel (BART) using an orthogonal three-component laser velocimeter. Preliminary laser velocimeter results show velocity vectors in the cross flow plane at x/c = 0.5, revealing the formation of the primary and secondary vortices over the upper surface of the wing.

Meyers, James F.↗