Engineering topics

Scott, S. D.

Publications and source records attributed to Scott, S. D..

3 records

DOE OSTI2022

Effects of neoclassical tearing modes and toroidal field ripple on lost alpha power in the SPARC tokamak

Here, using the SPIRAL Monte Carlo, full particle-orbit simulation code, we investigate the effects of neoclassical tearing modes (NTMs) and toroidal field (TF) ripple on alpha power losses during steady-state operation of the SPARC primary reference discharge. Model perturbations for TF ripple and the $m/n = 2/1$ and $3/2$ NTMs with exaggerated widths selected based on an H-mode plasma approaching thermal quench are added to a simulated SPARC magnetic equilibrium through which marker particles are tracked. The 3/2 and 2/1 NTMs are located at $\rho_{\mathrm{pol}} \sim 0.76$ and $\rho_\mathrm{pol} \sim 0.86$ respectively, well positioned to increase alpha particle transport into and within an outer lossy region of the plasma beyond $\rho_\mathrm{pol} \sim 0.8$ where over 95% of lost alpha particles are born. Total alpha power losses are shown to increase modestly from 1.73% lost at a minimum to 2.34% lost at a maximum, and alpha particle surface power densities form localized hotspots on the first-wall near the low-field side midplane due to NTMs and TF ripple. We establish a conservative upper limit for first-wall alpha surface power densities on a toroidally symmetric wall for typical, flattop operation and motivate the consideration of NTMs in the design of three dimensional limiter surfaces for SPARC.

alpha power losses↗

DOE OSTI2020

Fast-ion physics in SPARC

Potential loss of energetic ions including alphas and radio-frequency tail ions due to classical orbit effects and magnetohydrodynamic instabilities (MHD) are central physics issues in the design and experimental physics programme of the SPARC tokamak. The expected loss of fusion alpha power due to ripple-induced transport is computed for the SPARC tokamak design by the ASCOT and SPIRAL orbit-simulation codes, to assess the expected surface heating of plasma-facing components. We find good agreement between the ASCOT and SPIRAL simulation results not only in integrated quantities (fraction of alpha power loss) but also in the spatial, temporal and pitch-angle dependence of the losses. If the toroidal field (TF) coils are well-aligned, the SPARC edge ripple is small (0.15–0.30 %), the computed ripple-induced alpha power loss is small ( ~0.25% ) and the corresponding peak surface power density is acceptable ( 244 kW m -2 ). However, the ripple and ripple-induced losses increase strongly if the TF coils are assumed to suffer increasing magnitudes of misalignment. Surface heat loads may become problematic if the TF coil misalignment approaches the centimetre level. Ripple-induced losses of the energetic ion tail driven by ion cyclotron range of frequency (ICRF) heating are not expected to generate significant wall or limiter heating in the nominal SPARC plasma scenario. Because the expected classical fast-ion losses are small, SPARC will be able to observe and study fast-ion redistribution due to MHD including sawteeth and Alfvén eigenmodes (AEs). SPARC's parameter space for AE physics even at moderate Q is shown to reasonably overlap that of the demonstration power plant ARC (Sorbom et al., Fusion Engng Des., vol. 100, 2015, p. 378), and thus measurements of AE mode amplitude, spectrum and associated fast-ion transport in SPARC would provide relevant guidance about AE behaviour expected in ARC.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2020

Overview of the SPARC tokamak

The SPARC tokamak is a critical next step towards commercial fusion energy. SPARC is designed as a high-field ( $B_0 = 12.2$ T), compact ( $R_0 = 1.85$ m, $a = 0.57$ m), superconducting, D-T tokamak with the goal of producing fusion gain $Q>2$ from a magnetically confined fusion plasma for the first time. Currently under design, SPARC will continue the high-field path of the Alcator series of tokamaks, utilizing new magnets based on rare earth barium copper oxide high-temperature superconductors to achieve high performance in a compact device. The goal of $Q>2$ is achievable with conservative physics assumptions ( $H_{98,y2} = 0.7$ ) and, with the nominal assumption of $H_{98,y2} = 1$ , SPARC is projected to attain $Q \approx 11$ and $P_{\textrm {fusion}} \approx 140$ MW. SPARC will therefore constitute a unique platform for burning plasma physics research with high density ( $\langle n_{e} \rangle \approx 3 \times 10^{20}\ \textrm {m}^{-3}$ ), high temperature ( $\langle T_e \rangle \approx 7$ keV) and high power density ( $P_{\textrm {fusion}}/V_{\textrm {plasma}} \approx 7\ \textrm {MW}\,\textrm {m}^{-3}$ ) relevant to fusion power plants. SPARC's place in the path to commercial fusion energy, its parameters and the current status of SPARC design work are presented. This work also describes the basis for global performance projections and summarizes some of the physics analysis that is presented in greater detail in the companion articles of this collection.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗