Engineering Papers⌕ Search

Engineering topics

Schwemmer, G. K.

Publications and source records attributed to Schwemmer, G. K..

17 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2000

Raman Lidar Measurements of Water Vapor and Cirrus Clouds During the Passage of Hurricane Bonnie

The NASA/GSFC Scanning Raman Lidar (SRL) was stationed on Andros Island in the Bahamas during August - September, 1998 as a part of the third Convection and Moisture Experiment (CAMEX-3) which focussed on hurricane development and tracking. During the period August 21 - 24, hurricane Bonnie passed near Andros Island and influenced the water vapor and cirrus cloud measurements acquired by the SRL. Two drying signatures related to the hurricane were recorded by the SRL (Scanning Raman Lidar) and other sensors. Cirrus cloud optical depths (at 351 nm) were also measured during this period. Optical depth values ranged from approximately 0.01 to 1.4. The influence of multiple scattering on these optical depth measurements was studied with the conclusion that the measured values of optical depth are less than the actual value by up to 20% . The UV/IR cirrus cloud optical depth ratio was estimated based on a comparison of lidar and GOES measurements. Simple radiative transfer model calculations compared with GOES satellite brightness temperatures indicate that satellite radiances are significantly affected by the presence of cirrus clouds if IR optical depths are approximately 0.02 or greater. This has implications for satellite cirrus detection requirements.

Whiteman, D. N.↗
NASA NTRS2000

Raman Lidar Measurements of Water Vapor and Cirrus Clouds During the Passage of Hurricane Bonnie

The NASA/GSFC Scanning Raman Lidar (SRL) was stationed on Andros Island in the Bahamas during August - September, 1998 as a part of the third Convection and Moisture Experiment (CAMEX-3) which focussed on hurricane development and tracking. During the period August 21 - 24, hurricane Bonnie passed near Andros Island and influenced the water vapor and cirrus cloud measurements acquired by the SRL. Two drying signatures related to the hurricane were recorded by the SRL and other sensors. Cirrus cloud optical depths (at 351 nm) were also measured during this period. Optical depth values ranged from approximately 0.01 to 1.4. The influence of multiple scattering on these optical depth measurements was studied with the conclusion that the measured values of optical depth are less than the actual value by up to 20%. The UV/lR cirrus cloud optical depth ratio was estimated based on a comparison of lidar and GOES measurements. Simple radiative transfer model calculations compared with GOES satellite brightness temperatures indicate that satellite radiances are significantly affected by the presence of cirrus clouds if IR optical depths are approximately 0.02 or greater. This has implications for satellite cirrus detection requirements.

Whiteman, D. N.↗
NASA NTRS2000

Raman Lidar Measurements of Water Vapor and Cirrus Clouds During The Passage of Hurricane Bonnie

The NASA/GSFC Scanning Raman Lidar (SRL) was stationed on Andros Island in the Bahamas during August - September, 1998 as a part of the third Convection and Moisture Experiment (CAMEX-3) which focussed on hurricane development and tracking. During the period August 21 - 24, hurricane Bonnie passed near Andros Island and influenced the water vapor and cirrus cloud measurements acquired by the SRL. Two drying signatures related to the hurricane were recorded by the SRL and other sensors. Cirrus cloud optical depths (at 351 nm) were also measured during this period. Optical depth values ranged from less than 0.01 to 1.5. The influence of multiple scattering on these optical depth measurements was studied. A correction technique is presented which minimizes the influences of multiple scattering and derives information about cirrus cloud optical and physical properties. The UV/IR cirrus cloud optical depth ratio was estimated based on a comparison of lidar and GOES measurements. Simple radiative transfer model calculations compared with GOES satellite brightness temperatures indicate that satellite radiances are significantly affected by the presence of cirrus clouds if IR optical depths are approximately 0.005 or greater. Using the ISCCP detection threshold for cirrus clouds on the GOES data presented here, a high bias of up to 40% in the GOES precipitable water retrieval was found.

Whiteman, D. N.↗
NASA NTRS1992

Wavemeter measurements of frequency stability of an injection seeded alexandrite laser for pressure and temperature lidar

The GSFC pressure-temperature lidar is a differential absorption lidar operating in the oxygen A band absorption region (760 to 770 nm), and utilizes two tunable pulsed alexandrite lasers. For obtaining temperature measurements with an accuracy of less than or = 1 K, it has been determined that the stability of the online laser frequency over a period of time corresponding to a set of measurements, 0.1 to 30 min, has to be better than +/- 0.002/cm. In addition, the requirements on laser spectral bandwidth and spectral purity are less than or = 0.02/cm and greater than or = 99.9 percent, respectively. Injection seeding with a stabilized AlGaAs diode laser was used to achieve the required frequency stability and spectral bandwidth. A high resolution Fizeau wavemeter was employed to determine the frequency stability of the pulsed alexandrite laser and determine its bandwidth, mode structure. We present the results of measurements of the frequency stability and the spectrum of the injection seeded alexandrite laser.

Prasad, C. R.↗
NASA NTRS1991

Theoretical and experimental analysis of injection seeding a Q-switched alexandrite laser

Injection seeding is a method for achieving linewidths of less than 500 MHz in the output of broadband, tunable, solid state lasers. Dye lasers, CW and pulsed diode lasers, and other solid state lasers have been used as injection seeders. By optimizing the fundamental laser parameters of pump energy, Q-switched pulse build-up time, injection seed power and mode matching, one can achieve significant improvements in the spectral purity of the Q-switched output. These parameters are incorporated into a simple model for analyzing spectral purity and pulse build-up processes in a Q-switched, injection-seeded laser. Experiments to optimize the relevant parameters of an alexandrite laser show good agreement.

Prasad, C. R.↗
NASA NTRS1986

Airborne Lidar measurements of the atmospheric pressure profile with tunable Alexandrite lasers

The first remote measurements of the atmospheric pressure profile made from an airborne platform are described. The measurements utilize a differential absorption lidar and tunable solid state Alexandrite lasers. The pressure measurement technique uses a high resolution oxygen A band where the absorption is highly pressure sensitive due to collision broadening. Absorption troughs and regions of minimum absorption were used between pairs of stongly absorption lines for these measurements. The trough technique allows the measurement to be greatly desensitized to the effects of laser frequency instabilities. The lidar system was set up to measure pressure with the on-line laser tuned to the absorption trough at 13147.3/cm and with the reference laser tuned to a nonabsorbing frequency near 13170.0/cm. The lidar signal returns were sampled with a 200 range gate (30 vertical resoltion) and averaged over 100 shots.

Korb, C. L.↗
NASA NTRS1986

Measurements of the effect of horizontal variability of atmospheric backscatter on dial measurements

The horizontal variability of atmospheric backscatter may have a substantial effect on how Differential Absorption Lidar (DIAL) data must be taken and analyzed. To minimize errors, lidar pulse pairs are taken with time separations which are short compared to the time scales associated with variations in atmospheric backscatter. To assess the atmospheric variability for time scales which are long compared to the lidar pulse repetition rate, the variance of the lidar return signal in a given channel can be computed. The variances of the on-line, off-line, and ration of the on-line to off-line signals at given altitudes obtained with the dual solid-state Alexandrite laser system were calculated. These evaluations were made for both down-looking aircraft and up-looking ground-based lidar data. Data were taken with 200 microsecond separation between on-line and off-line laser pulses, 30 m altitude resolution, 5 Hz repetition rate, and the signal were normalized for outgoing laser energy.

Schwemmer, G. K.↗
NASA NTRS1986

Real-time atmospheric absorption spectra for in-flight tuning of an airborne dial system

Real-time measurements of atmospheric absorption spectra are displayed and used to precisely calibrate and fix the frequency of an Alexandrite laser to specific oxygen absorption features for airborne Differential Absorption Lidar (DIAL) measurements of atmospheric pressure and temperature. The DIAL system used contains two narrowband tunable Alexandrite lasers: one is electronically scanned to tune to oxygen absorption features for on-line signals while the second is used to obtain off-line (nonabsorbed) atmospheric return signals. The lidar operator may select the number of shots to be averaged, the altitude, and altitude interval over which the signals are averaged using single key stroke commands. The operator also determines exactly which oxygen absorption lines are scanned by comparing the line spacings and relative strengths with known line parameters, thus calibrating the laser wavelength readout. The system was used successfully to measure the atmospheric pressure profile on the first flights of this lidar, November 20, and December 9, 1985, aboard the NASA Wallops Electra aircraft.

Dombrowski, M.↗
NASA NTRS1986

Electro-optical Tuning of Fabry-Perot Interferometers

Compact unit operates much faster than conventional piezoelectric scanners. High voltage creates electric field in Pockels cell, changing refractive properties. Cell changes optical path length between mirrors without mechanically moving anything in gap. High voltage varied rapidly to scan interferometer. Voltage applied longitudinally or transversely, depending on type of Pockels cell. New electro-optic scanner scans given range in one-millionth time of piezoelectric scanner - tens to hundreds of nanoseconds per interferometer order. Also reducing size of interferometer.

Schwemmer, G. K.↗
NASA NTRS1985

Remote sensing with a tunable alexandrite laser transmitter

A high-resolution, tunable alexandrite laser system is described. Two alexandrite lasers are continuously tunable from 725-790 nm and have a bandwidth of 0.02/cm. The stability of the two lasers is evaluated. The line shape of the laser emission and spectral purity of the system were measured. The data reveal that the output consists of three axial modes with an overall width of 0.026/cm, and the spectral impurity of the alexandrite laser output is less than 0.01 percent. The ground-based lidar system is utilized for measuring atmospheric pressure profiles; the integrated absorption in the wings of lines in the O2 A band is studied to produce the profiles. An example of lidar-collected atmospheric pressure data is presented and compared with radiosonde data; only a 0.3 percent deviation between the data is observed.

Korb, C. L.↗
NASA NTRS1983

Atmospheric pressure and temperature profiling using near IR differential absorption lidar

The present investigation is concerned with differential absorption lidar techniques for remotely measuring the atmospheric temperature and pressure profile, surface pressure, and cloud top pressure-height. The procedure used in determining the pressure is based on the conduction of high-resolution measurements of absorption in the wings of lines in the oxygen A band. Absorption with respect to these areas is highly pressure sensitive in connection with the mechanism of collisional line broadening. The method of temperature measurement utilizes a determination of the absorption at the center of a selected line in the oxygen A band which originates from a quantum state with high ground state energy.

Korb, C. L.↗
NASA NTRS1981

Laser remote sensing of atmospheric temperature by observing resonant absorption of oxygen

A dual-frequency system is used to demonstrate the measurement of atmospheric temperature, through laser energy absorption monitoring at the center of an O2 resonant absorption line near 770 nm. It is shown that the average temperature of a 1 km path can be determined within 1.0 C, with a noise level of 0.3 C. An iterative algebraic expression for this method was developed, and is shown to be applicable in the troposphere; the effects of pressure and humidity on temperature determination were made clear by the algorithm and found to be small near the earth's surface.

Kalshoven, J. E., Jr.↗
NASA NTRS1981

Meteorological lidar developments

A research program on remote optical measurements of humidity and temperature is summarized, and new results are given of such measurements as well as new data on the near IR absorption spectrum of H2O. The basic atmospheric technique is differential absorption lidar (DIAL) using narrow band, tunable dye lasers. Approximate wavelengths are 720, 820, 940 nm (H2O) and 690, 760 nm (O2; temperature). The requisite absorption line strengths and widths are measured in a controlled environment by means of grating spectroscopy and tunable lasers. Prospects for routine lidar meteorology, even from airplane and satellite platforms, appear excellent in several important applications; the conditions and the optical properties of the atmosphere can be obtained remotely by these means.

Wilkerson, T. D.↗
NASA NTRS1979

Lidar temperature profiling - Performance simulations of Mason's method

In Mason's method (1975) atmospheric temperatures are inferred from a measure of the Boltzmann distribution of rotational states in one of the vibrational bands of O2. Differential absorption is measured using three tunable, narrowband pulse lasers. The outputs of two are tuned to wavelengths at the centers of absorption lines at either end of a particular branch in the band; the third wavelength is in a region of no absorption. The temperature-altitude profile can be calculated from the ratio of the two line absorption coefficients plus a priori knowledge of the line parameters. In the present paper, computer simulations of various lidar configurations are made, using different line pairs in the atmospheric bands of O2 (approximately 630, 690, and 760 nm). Simulated results are presented for temperature profiles measured from a Space Shuttle lidar.

Schwemmer, G. K.↗
NASA NTRS1979

Lidar temperature profiling: Performance simulations of Masons method

Several methods of using lasers to measure atmospheric temperature profiles were described. Mason's suggestion was analyzed here to assess its capabilities for various lidar configurations. Temperatures were inferred from a measure of the Boltzmann distribution of rotational states in one of the vibrational bands of O2. Differential absorption was measured using three tunable, narrowband pulsed lasers. The outputs of two were tuned to wavelengths at the centers of absorption lines at either end of a particular branch in the band. The third wave-length was in a region of no absorption; its lidar return measured only the atmospheric backscatter, and therefore allowed calculations of the absorption coefficients at the other two wavelengths as a function of altitude. From the ratio of the two line absorption coefficients plus a priori knowledge of the line parameters, the temperature-altitude profile were calculated.

Schwemmer, G. K.↗