Engineering Papers⌕ Search

Engineering topics

Schwartz, R. A.

Publications and source records attributed to Schwartz, R. A..

26 records · Page 2

High resolution hard X-ray spectra of solar and cosmic sources

High resolution hard X-ray observations of a large solar flare and the Crab Nebula were obtained during balloon flights using an array of cooled germanium planar detectors. In addition, high time resolution high sensitivity measurements were obtained with a 300 square cm NaI/CsI phoswich scintillator. The Crab spectrum from both flights was searched without finding evidence of line emission below 200 keV. In particular, for the 73 keV line previously reported a 3 sigma upper limit for a narrow (1 keV FWHM) line .0019 and .0014 ph square cm/sec for the 1979 and 1980 flights, respectively was obtained.

Schwartz, R. A.↗

First-order Fermi acceleration in solar flares as a mechanism for the second-step acceleration of prompt protons and relativistic electrons

Solar flare data from June 27, 1980 balloon-based observations were studied in terms of the hard X ray component. A temporal delay of 3 sec was observed for the X ray emissions above 235 keV. The delay occurred relative to the low-energy electrons and indicated a second acceleration stage. An estimation of the acceleration rate of the first-order Fermi process operating in a closed flare loop was found to be in agreement with the resulting data, including the acceleration of both protons and relativistic electrons. Additional support for the first-order Fermi process is noted in the fact that flares generally occur in magnetic loops, a condition which allows energetic particles to continually interact with the upward moving shock fronts. A correlation has also been observed between the delay times and the H-alpha areas, encouraging the interpretation that the delay times are the shock transit times.

Bai, T.↗

A new component of hard X-rays in solar flares

High-resolution (approximately 1 keV FWHM) spectral measurements from 13 to 300 keV of a solar flare hard X-ray burst observed on 1980 June 27 by a balloon-borne array of cooled germanium planar detectors are presented. At energies below about 35 keV, a new component of solar flare hard X-rays is identified. This component is characterized by an extremely steep spectrum which fits closely to that from a Maxwellian electron distribution with a maximum temperature of about 34 x 10 to the 6th K and an emission measure of 2.9 x 10 to the 48th per cu cm. This hot isothermal component appears at the peak of the normal power-law-like impulsive X-ray burst component, and it remains isothermal and dominates the X-ray emission below about 30 keV through the decay of the flare event.

Lin, R. P.↗

Enhanced effects of starlight on the interstellar medium

The photodesorption of molecules and atoms from the surfaces of interstellar grains can be an important source of heating for the interstellar medium and the origin of instabilities which may separate grains and gas. For low densities, the force exerted on the grains is proportional to the gas density and independent of the radiation intensity; for high densities, it is proportional to the radiative flux and independent of the gas density. This force may act differently on grains of different sizes. The photoelectric effect may also be an efficient mechanism for the separation of gas and dust in diffuse clouds.

Gerola, H.↗

Enhanced effects of starlight on the interstellar medium

The photodesorption of molecules and atoms from the surfaces of interstellar grains can be an important source of heating for the interstellar medium and the origin of instabilities which may separate grains and gas. For low densities, the force exerted on the grains is proportional to the gas density and independent of the radiation intensity; for high densities, it is proportional to the radiative flux and independent of the gas density. This force may act differently on grains of different sizes. The photoelectric effect may also be an efficient mechanism for the separation of gas and dust in diffuse clouds.

Gerola, H.↗

Medical Information Management System (MIMS): An automated hospital information system

An automated hospital information system that handles all data related to patient-care activities is described. The description is designed to serve as a manual for potential users, nontechnical medical personnel who may use the system. Examples of the system's operation, commentary on the examples, and a complete listing of the system program are included.

Alterescu, S.↗