Engineering PapersSearch

Engineering topics

Schuchardt, J. M.

Publications and source records attributed to Schuchardt, J. M..

Multispectral radiation detection of small changes in target emissivity

An investigation into the multispectral radiation detection of small changes in target emissivity has been performed by Georgia Tech. A series of ice detection measurements on the shuttle external tank (ET) were performed using an advanced instrumentation radiometer operating at 35/95 GHz. Actual shuttle ET ice detection measurements were run at NASA's National Space Technology Laboratory (NSTL) during cryogenic fueling operations prior to orbiter engine firing tests. Investigations revealed that ET icing caused an increase in surface brightness temperature and the test results further demonstrated the usefulness of millimeter wave radiometry for the detection of ice on the ET.

Gagliano, J. A.

High accuracy radiation efficiency measurement techniques

The relatively large antenna subarrays (tens of meters) to be used in the Solar Power Satellite, and the desire to accurately quantify antenna performance, dictate the requirement for specialized measurement techniques. The error contributors associated with both far-field and near-field antenna measurement concepts were quantified. As a result, instrumentation configurations with measurement accuracy potential were identified. In every case, advances in the state of the art of associated electronics were found to be required. Relative cost trade-offs between a candidate far-field elevated antenna range and near-field facility were also performed.

Kozakoff, D. J.

Moisture sounding at millimeter wavelengths /94/183 GHz/ at high altitudes

A moisture sounding radiometer at millimeter wavelengths has been developed for high altitude measurements onboard NASA's WB-57F aircraft. Three channels about the 183.3 GHz water vapor line permit measurement of the atmospheric water vapor profile. A single window channel at 94 GHz provides correction for clouds over the ocean and for surface emissivity variations over land. The instrument is an imaging radiometer operating under microprocessor control throughout each data flight. The system is contained within two packages integrated into the WB-57F pallet. A ground support system was used to perform a quick-look analysis of the data collected immediately following each flight.

Gagliano, J. A.

Consideration for high accuracy radiation efficiency measurements for the Solar Power Satellite (SPS) subarrays

The transmit beam and radiation efficiency for 10 metersquare subarray panels were quantified. Measurement performance potential of far field elevated and ground reflection ranges and near field technique were evaluated. The state-of-the-art of critical components and/or unique facilities required was identified. Relative cost, complexity and performance tradeoffs were performed for techniques capable of achieving accuracy objectives. It is considered that because of the large electrical size of the SPS subarray panels and the requirement for high accuracy measurements, specialized measurement facilities are required. Most critical measurement error sources have been identified for both conventional far field and near field techniques. Although the adopted error budget requires advances in state-of-the-art of microwave instrumentation, the requirements appear feasible based on extrapolation from today's technology. Additional performance and cost tradeoffs need to be completed before the choice of the preferred measurement technique is finalized.

Kozakoff, D. J.

Solar Power Satellite /SPS/ antenna measurement considerations

An investigation carried out by the Georgia Institute of Technology that quantified the error contributors associated with both far-field and near-field antenna measurement concepts is discussed. Measurement errors are quantified into four sources: antenna range, structural/environmental, transmitter, and receiver. The study is carried out so as to control error sources to yield an overall gain uncertainty of plus or minus 0.04 dB. With regard to antenna positioners, it is found that a small angle positioner provides highly accurate scan capability over a plus or minus 1.5 deg sector for the purpose of beam integration. With regard to near-field measurement techniques, it is found that with adequate probe calibration and precision mechanical scanning, full 30 by 30 m mechanical module antenna measurements may be performed. The performance and relative cost considerations between planar near-field and conventional far-field methods indicate that the overall costs are roughly the same.

Kozakoff, D. J.

A 94/183 GHz aircraft radiometer system for Project Storm Fury

A radiometer design suitable for use in NASA's WB-57F aircraft to collect data from severe storm regions was developed. The design recommended was a 94/183 GHz scanning radiometer with 3 IF channels on either side of the 183.3 GHz water vapor line and a single IF channel for a low loss atmospheric window channel at 94 GHz. The development and construction of the 94/183 GHz scanning radiometer known as the Advanced Microwave Moisture Sounder (AMMS) is presented. The radiometer scans the scene below the aircraft over an angle of + or - 45 degrees with the beamwidth of the scene viewed of approximately 2 degrees at 94 GHz and 1 degree at 183 GHz. The AMMS data collection system consists of a microcomputer used to store the radiometer data on the flight cartridge recorder, operate the stepper motor driven scanner, and collect housekeeping data such as thermistor temperature readings and aircraft time code.

Gagliano, J. A.

Advanced millimeter wave imaging systems

Unique techniques are being utilized to develop self-contained imaging radiometers operating at single and multiple frequencies near 35, 95 and 183 GHz. These techniques include medium to large antennas for high spatial resolution, lowloss open structures for RF confinemnt and calibration, wide bandwidths for good sensitivity plus total automation of the unit operation and data collection. Applications include: detection of severe storms, imaging of motor vehicles, and the remote sensing of changes in material properties.

Schuchardt, J. M.

Considerations for high accuracy radiation efficiency measurements for the Solar Power Satellite (SPS) subarrays

The relatively large apertures to be used in SPS, small half-power beamwidths, and the desire to accurately quantify antenna performance dictate the requirement for specialized measurements techniques. Objectives include the following: (1) For 10-meter square subarray panels, quantify considerations for measuring power in the transmit beam and radiation efficiency to + or - 1 percent (+ or - 0.04 dB) accuracy. (2) Evaluate measurement performance potential of far-field elevated and ground reflection ranges and near-field techniques. (3) Identify the state-of-the-art of critical components and/or unique facilities required. (4) Perform relative cost, complexity and performance tradeoffs for techniques capable of achieving accuracy objectives. the precision required by the techniques discussed below are not obtained by current methods which are capable of + or - 10 percent (+ or - dB) performance. In virtually every area associated with these planned measurements, advances in state-of-the-art are required.

Kozakoff, D. J.

A 94/183 GHz multichannel radiometer for Convair flights

A multichannel 94/183 GHz radiometer was designed, built, and installed on the NASA Convair 990 research aircraft to take data for hurricane penetration flights, SEASAT-A underflights for measuring rain and water vapor, and Nimbus-G underflights for new sea ice signatures and sea surface temperature data (94 GHz only). The radiometer utilized IF frequencies of 1, 5, and 8.75 GHz about the peak of the atmospheric water vapor absorption line, centered at 183.3 GHz, to gather data needed to determine the shape of the water molecule line. Another portion of the radiometer operated at 94 GHz and obtained data on the sea brightness temperature, sea ice signatures, and on areas of rain near the ocean surface. The radiometer used a multiple lens antenna/temperature calibration technique using 3 lenses and corrugated feed horns at 94 GHz and 183 GHz. Alignment of the feed beams at 94 GHz and 183 GHz was accomplished using a 45 deg oriented reflecting surface which permitted simultaneous viewing of the feeds on alternate cycles of the chopping intervals.

Gagliano, J. A.

Detected noise levels guide radiometer design

A survey of component demands and design techniques for radiometers is presented. The design of a typical radiometer is traced from the antenna through the video and data-collection stages. Key design equations are given. An example is considered that shows how IF amplifier gain must be chosen to mask video noise. The influence of front-end losses on back-end design is studied.

Schuchardt, J. M.

Computer analysis speeds corrugated horn design

A computer analysis program is developed for selecting the optimum flare angle and horn length of a corrugated horn design, the horn diameter, and the radiation pattern, before resorting to machining operations. The calculated antenna pattern is best suited to narrowband designs, and averaging of the E and H planes is recommended for wideband work. The program language used is BASIC. Some design examples are provided with representative data, printouts, and a rundown of the equations programmed.

Loefer, G. R.

Dual-frequency feed-horn antenna

Antenna with novel two-port diplexer separates high power /31.65 GHz/ transmitted signal from low power /15.2 GHz/ received signal. Two-port network feeds dual-frequency horn and excites antenna with minimal loss in power. Isolation between transmit port and receive port ranges from 60 db to 80 db.

Schuchardt, J. M.