Engineering topics

Schapitz, E

Publications and source records attributed to Schapitz, E.

4 records

NASA NTRS1939

Experimental and analytical investigation of a monocoque wing model loaded in bending

Bending tests with transverse loads and with pure bending were undertaken on a double-web monocoque wing model in order to establish the relation between the state of stress and the results from the elementary bending theory. The longitudinal stresses in the stiffeners were measured with tensiometers and the shear stresses in the sheet were calculated from them. The measurements were made at both moderate loads with no buckles in the covering and at loads with which the critical stress in the individual panels was exceeded. For the comparison, the wing skin was considered as stiffened sheet according to the shear panel scheme. In this way, the statistically indeterminate calculation was confirmed by the test results.

Schapitz, E↗

NASA NTRS1938

The Twisting of Thin-walled, Stiffened Circular Cylinders

On the basis of the present investigation of the twisting of thin-walled, stiffened cylinders the following conclusions can be reached: 1) there is as yet no generally applicable formula for the buckling moment of the skin; 2) the mathematical treatment of the condition of the shell after buckling of the skin is based on the tension-field theory, wherein the strain condition is considered homogenous.

Schapitz, E↗

NASA NTRS1938

Load Tests on a Stiffened Circular Cylindrical Shell

The present report describes tests in which the stress distribution may be determined in a stiffened circular cylindrical shell loaded longitudinally at four symmetrically situated points. As being of particular importance are the cases investigated of groups of bending and arching or convexing forces, respectively. From the stress measurements on the longitudinal stiffeners, the shear stresses and the bulkhead ring stresses in the skin could be evaluated. These measurements showed that the "simple shear field" used in theoretical computations in which all normal stresses in the skin are neglected, must be extended by the addition of the transverse or circumferential stresses if the bulkhead rings are not riveted to the skin.

Schapitz, E↗

NASA NTRS1937

Contributions to the theory of incomplete tension bay

The present report offers an approximate theory for the stress and deformation condition after buckling of the skin in reinforced panels and shells loaded in simple shear and compression and under combined stresses. The theory presents a unified scheme for stresses of these types. It is based upon the concept of a nonuniform stress distribution in the metal panel and its marked power of resistance against compressive stresses ("incomplete" tension bay).

Schapitz, E↗