Engineering topics
Publications and source records attributed to Saylor, C. R..
Microcomputer controlled system gather current and voltage data. System consists of light source, microcomputer, programable dc power supply, analog/ digital interface, and data storage display equipment. Applies series of test loads to cell via programable dc power supply to obtain I/V characteristic curve and key cell-peformance parameter. Apparatus and programming technique are applicable to devices such as batteries and sensors.
Major effort during this reporting period was devoted to two tasks: improvement of the electrical measurement instrumentation through the design and construction of a microcomputer controlled short interval tester, and better understanding of second quadrant behavior by developing a mathematical model relating cell temperature to electrical characteristics. In addition, some preliminary work is reported on an investigation into color changes observed after stressing.
A drawback of conventional electrical evaluation procedures regarding solar cells is related to time consuming operations required in the determination of specific parameters, such as the maximum power point, from the plotted curves, and to the transfer of data to a large digital computer for analysis and manipulation. This is especially true when large numbers of cells must be measured. To overcome such drawbacks, a digital short interval tester was designed and constructed. The new tester provides rapid and accurate measurements at constant temperature. The utilization of a light shutter makes it possible to measure up to 200 data points along the I-V curve in less than a second, thus avoiding thermal effects. Because the system is digital, parameters such as the maximum power may be calculated directly from the data.