Engineering topics

Saric, William S.

Publications and source records attributed to Saric, William S..

25 records · Page 2

NASA NTRS1989

Crossflow-vortex instability and transition on a 45 deg swept wing

A crossflow vortex experiment on a 45 deg swept wing is currently being conducted in the Arizona State University Unsteady Wind Tunnel. The experimental apparatus is designed to produce crossflow-dominated transition by simulating infinite swept wing flow using contoured end liners in a closed throat wind tunnel. Stationary fixed-wavelength crossflow vortices are observed at several chord Reynolds numbers. The vortex wavelength which is fixed for a given Reynolds number varies with Reynolds number approximately as predicted by linear stability theory, but with the predicted wavelengths about 30 percent larger than the observed wavelengths. Travelling waves are observed both in the frequency range predicted by linear stability theory and at higher frequencies. These higher frequency waves may be harmonics of the primary crossflow waves generated by a nonlinear parametric resonance phenomena.

Dagenhart, J. Ray↗

NASA NTRS1989

Stability and transition of three-dimensional boundary layers

The most recent efforts on the stability and transition of three-dimensional flows are reviewed. These include flows over swept wings, rotating disks, and attachment lines. The generic similarities of their stability behavior is discussed. It is shown that the breakdown process if very complex, often leading to contradictory results. Particular attention is paid to opposing observations of stationary and traveling wave distances.

Saric, William S.↗

NASA NTRS1989

Stability of three-dimensional boundary layers

The present evaluation of three-dimensional flows notes that the presence of such disturbance sources as roughness could favor the stationary mode, and that end-conditions may inhibit traveling disturbances in the experiments reported; alternatively, the theory could be inadequate. In general, uncertainties remain as to the definition of transition in three dimensions. It remains important to ascertain whether the formation of three-dimensional structures and characteristic stages will occur, as in two-dimensional flow transition. The possibilities and mechanisms for secondary instabilities also remain to be determined.

Reed, Helen L.↗

NASA NTRS1989

Experiments in swept-wing transition

Stability and transition experiments are conducted on a 45 degree sweep airfoil in the ASU Unsteady Wind Tunnel. Combined flow-visualization techniques and hot-wire measurements are used in conjuction with stability-code calculations to map out transition behavior for this flow geometry. Both steady and unsteady crossflow vortices are observed and at this time there is no contradiction with the theoretical predictions.

Saric, William S.↗

NASA NTRS1988

Design of high-Reynolds-number flat-plate experiments in the NTF

The design of an experiment to measure skin friction and turbulent boundary layer characteristics at Reynolds numbers exceeding 1 x 10 to the 9th is described. The experiment will be conducted in a zero-pressure-gradient flow on a flat plate in the National Transonic Facility (NTF). The development of computational codes to analyze the aerodynamic loads and the blockage is documented. Novel instrumentation techniques and models, designed to operate in cryogenic environments, are presented. Special problems associated with aerodynamic loads, surface finish, and hot-wire anemometers are discussed.

Saric, William S.↗

NASA NTRS1988

Experiments to verify nonparallel stability theory at Virginia Polytechnic Institute and State University, Blacksburg, Virginia

The effects of normal mass injection and suction on boundary-layer stability and transition are studied on a flat plate. Titanium panels, in which 0.063 mm diameter holes were drilled on 0.635 mm centers, are inserted in the plate. Suction level and distribution are variable. Disturbances are introduced by means of a vibrating ribbon and measurements of both mean- and disturbance-flow velocities are made with a hot wire. Disturbance amplitudes are measured as a function of Reynolds number, frequency, and suction characteristics, and are compared with the previous results obtained over a Dynapore surface. Transition measurements under natural and forced conditions are also made. The stabilizing effects of suction are documented. It is also shown that very high local flow rates through the suction holes (which approach a hole Reynolds number of 300) do not destabilize the flow. On the other hand, weak blowing lowers the transition Reynolds number, but is found not to cause serious problems.

Saric, William S.↗

NASA NTRS1987

Three-dimensional stability of boundary layers

The most recent efforts on the stability and transition of three-dimensional flows are reviewed. These include flows over swept wings, rotating disks, rotating cones, yawed bodies, corners, and attachment lines. The generic similarities of their stability behavior is discussed. It is shown that the breakdown process is very complex, often leading to contradictory results. Particular attention is paid to opposing observations of stationary and traveling wave disturbances.

Saric, William S.↗