Engineering Papers⌕ Search

Engineering topics

Sankar, L. N.

Publications and source records attributed to Sankar, L. N..

34 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1991

Effects of leading and trailing edge flaps on the aerodynamics of airfoil/vortex interactions

A numerical procedure based on the unsteady 2D full potential equation is presently used to simulate the effects of leading-edge and trailing-edge flaps on the aerodynamics of airfoil-vortex interactions. Attention is given to unsteady flap-motion effects, which alleviate those interactions at sub- and supercritical onset flows. For subcritical interactions, the results obtained indicate that trailing-edge flaps can be used to alleviate the impulsive loads experienced by the airfoil; for supercritical interactions, a leading- rather than trailing-edge flap must be used to alleviate the interaction.

Hassan, Ahmed A.↗
NASA NTRS1990

Simulation of unsteady rotational flow over propfan configuration

During the past decade, aircraft engine manufacturers and scientists at NASA have worked on extending the high propulsive efficiency of a classical propeller to higher cruise Mach numbers. The resulting configurations use highly swept twisted and very thin blades to delay the drag divergence Mach number. Unfortunately, these blades are also susceptible to aeroelastic instabilities. This was observed for some advanced propeller configurations in wind tunnel tests at NASA Lewis Research Center, where the blades fluttered at cruise speeds. To address this problem and to understand the flow phenomena and the solid fluid interaction involved, a research effort was initiated at Georgia Institute of Technology in 1986, under the support of the Structural Dynamics Branch of the NASA Lewis Research Center. The objectives of this study are: (1) the development of solution procedures and computer codes capable of predicting the aeroelastic characteristics of modern single and counter-rotation propellers; and (2) the use of these solution procedures to understand physical phenomena such as stall flutter, transonic flutter, and divergence.

Srivastava, Rakesh↗
NASA NTRS1990

Euler solutions for self-generated rotor blade-vortex interactions

A finite-difference procedure was developed, on the basis of the conservation form of the unsteady three-dimensional Euler equations, for the prediction of rotor blade-vortex interactions (BVIs). Numerical solution procedures were obtained for the analysis of the model parallel BVIs and the more realistic helicopter self-generated-rotor BVIs. It was found that, for self-generated subcritical interactions, the accuracy of the predicted leading edge pressures relied heavily on the user-specified vortex core radius and on the CAMRAD-code-predicted geometry of the interaction vortex elements and their relative orientation with respect to the blade. It was also found that the free-wake model used in CAMRAD to predict the tip vortex trajectory for use in the Euler solution yields lower streamwise and higher axial wake convective velocities than those inferred from the experimental data.

Hassan, A. A.↗
NASA NTRS1990

An assessment of full potential and Euler solutions for self-generated rotor blade-vortex interactions

An assessment is made of the accuracy and suitability of the three-dimensional full potential and Euler equations in the modeling of subcritical and supercritical rotor blade-vortex interactions (BVI). The interaction velocity fields are obtained through a nonlinear superposition of the rotor and the vortex wake flow fields. Vortex effects are simulated using the velocity 'transpiration' approach. A modified surface condition is prescribed and enforced at each time step of the computations to satisfy the tangency boundary condition. Potential blade-vortex encounters are identified and tracked in time at equal increments of rotor azimuth using the lifting-line helicopter/rotor trim code CAMRAD. This information is then utilized in interpolation routines within the flow solvers to compute the instantaneous position(s) of the interaction vortex element(s) with respect to the blade for the time-accurate calculations. Results for subcritical self-generated BVI and for supercritical interactions resulting from an upstream-generated vortex are presented.

Hassan, A. A.↗
NASA NTRS1990

An airfoil design method for viscous flows

An airfoil design procedure is described that has been incorporated into an existing two-dimensional Navier-Stokes airfoil analysis method. The resulting design method, an iterative procedure based on a residual-correction algorithm, permits the automated design of airfoil sections with prescribed surface pressure distributions. This paper describes the inverse design method and the technique used to specify target pressure distributions. An example airfoil design problem is described to demonstrate application of the inverse design procedure. It shows that this inverse design method develops useful airfoil configurations with a reasonable expenditure of computer resources.

Malone, J. B.↗
NASA NTRS1989

Evaluation of three turbulence models for the prediction of steady and unsteady airloads

Two dimensional quasi-three dimensional Navier-Stokes solvers were used to predict the static and dynamic airload characteristics of airfoils. The following three turbulence models were used: the Baldwin-Lomax algebraic model, the Johnson-King ODE model for maximum turbulent shear stress, and a two equation k-e model with law-of-the-wall boundary conditions. It was found that in attached flow the three models have good agreement with experimental data. In unsteady separated flows, these models give only a fair correlation with experimental data.

Wu, Jiunn-Chi↗
NASA NTRS1988

Application of Navier-Stokes analysis to stall flutter

A solution procedure was developed to investigate the two-dimensional, one- or two-dimensional flutter characteristics of arbitrary airfoils. This procedure requires a simultaneous integration in time of the solid and fluid equations of motion. The fluid equations of motion are the unsteady compressible Navier-Stokes equations, solved in a body-fitted moving coordinate system using an approximate factorization scheme. The solid equations of motion are integrated in time using an Euler implicit scheme. Flutter is said to occur if small disturbances imposed on the airfoil attitude lead to divergent oscillatory motions at subsequent times. The flutter characteristics of airfoils in subsonic speed at high angles of attack and airfoils in high subsonic and transonic speeds at low angles of attack are investigated. The stall flutter characteristics are also predicted using the same procedure.

Wu, J. C.↗
NASA NTRS1988

Evaluation of three turbulence models for the prediction of steady and unsteady airloads

Two dimensional quasi-three dimensional Navier-Stokes solvers were used to predict the static and dynamic airload characteristics of airfoils. The following three turbulence models were used: the Baldwin-Lomax algebraic model, the Johnson-King ODE model for maximum turbulent shear stress, and a two equation k-e model with law-of-the-wall boundary conditions. It was found that in attached flow the three models have good agreement with experimental data. In unsteady separated flows, these models give only a fair correlation with experimental data.

Wu, Jiunn-Chi↗
NASA NTRS1987

Analysis of viscous transonic flow over airfoil sections

A full Navier-Stokes solver has been used to model transonic flow over three airfoil sections. The method uses a two-dimensional, implicit, conservative finite difference scheme for solving the compressible Navier-Stokes equations. Results are presented as prescribed for the Viscous Transonic Airfoil Workshop to be held at the AIAA 25th Aerospace Sciences Meeting. The NACA 0012, RAE 2822 and Jones airfoils have been investigated for both attached and separated transonic flows. Predictions for pressure distributions, loads, skin friction coefficients, boundary layer displacement thickness and velocity profiles are included and compared with experimental data when possible. Overall, the results are in good agreement with experimental data.

Huff, Dennis L.↗
NASA NTRS1987

Studies of unsteady viscous flows using a two-equation model of turbulence

A two equation model of turbulence, based on the turbulent kinetic energy and energy dissipation, suitable for prediction of unsteady viscous flows, was developed. Also, the performance of the two equation model was compared with simpler algebraic models such as the Baldwin-Lomax two layer eddy viscosity model, and a model by Johnson and King which accounts for upstream history of the turbulent kinetic energy. A brief discussion of this study is given.

Sankar, L. N.↗
NASA NTRS1987

A technique for the prediction of airfoil flutter characteristics in separated flow

A solution procedure is described for determining the two-dimensional, one- or two-degree-of-freedom flutter characteristics of arbitrary airfoils at large angles of attack. The same procedure is used to predict stall flutter. This procedure requires a simultaneous integration in time of the solid and fluid equations of motion. The fluid equations of motion are the unsteady compressible Navier-Stokes equations, solved in a body-fitted moving coordinate system using an approximate factorization scheme. The solid equations of motion are integrated in time using an Euler implicit scheme. Flutter is said to occur if small disturbances imposed on the airfoil attitude lead to divergent oscillatory motions at subsequent times. Results for a number of special cases are presented to demonstrate the suitability of this scheme to predict flutter at large mean angles of attack. Some stall flutter applications are also presented.

Wu, Jiunn-Chi↗
NASA NTRS1987

Analysis of viscous transonic flow over airfoil sections

A full Navier-Stokes solver has been used to model transonic flow over three airfoil sections. The method uses a two-dimensional, implicit, conservative finite difference scheme for solving the compressible Navier-Stokes equations. Results are presented as prescribed for the Viscous Transonic Airfoil Workshop to be held at the AIAA 25th Aerospace Sciences Meeting. The NACA 0012, RAE 2822 and Jones airfoils have been investigated for both attached and separated transonic flows. Predictions for pressure distributions, loads, skin friction coefficients, boundary layer displacement thickness and velocity profiles are included and compared with experimental data when possible. Overall, the results are in good agreement with experimental data.

Huff, Dennis L.↗
NASA NTRS1986

Euler calculations for rotor configurations in unsteady forward flight

A solution procedure is presented for the lifting transonic flow past modern rotor configurations in forward flight. In this procedure, the three-dimensional, unsteady Euler equations are solved in strong conservation form on a body-fitted moving coordinate system. A hybrid procedure of second order spatial accuracy and first order temporal accuracy is used to integrate the governing equations. In lifting flows, the effect of the elements of wake not captured by the computational procedure, and other aeroelastic effects are accounted for as local angle of attack corrections. Detailed comparisons with experimental data are presented for a 1/7 scale model of the Cobra OLS rotor, and for a three-bladed rotor tested in France. Some preliminary results are also presented for a three-dimensional blade vortex interaction problem.

Sankar, L. N.↗