Sabbagh, H A | Engineering Papers

DOE OSTI2011

Low frequency eddy current benchmark study for model validation

This paper presents results of an eddy current model validation study. Precise measurements were made using an impedance analyzer to investigate changes in impedance due to Electrical Discharge Machining (EDM) notches in aluminum plates. Each plate contained one EDM notch at an angle of 0, 10, 20, or 30 degrees from the normal of the plate surface. Measurements were made with the eddy current probe both scanning parallel and perpendicular to the notch length. The experimental response from the vertical and oblique notches will be reported and compared to results from different numerical simulation codes.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

DOE OSTI2011

Low frequency eddy current finite element model validation and benchmark studies

A finite element method (FEM) model was created to calculate the change in impedance of a coil due to the presence of a notch in a plate. The rectangular notches were created via electrical discharge machining (EDM) in a thick aluminum plate and were positioned at normal and oblique angles (10, 20, and 30 degrees) with respect to the vertical axis of the coil. The FEM method was chosen for this model due to its ability to solve problems in complicated geometries with the use of irregular mesh elements to discretize the solution domain. The change in impedance was calculated from the field variables in the simulation for each probe position along the parallel axis of the plate. The error between the model and the experimental data was approximately 5% for the majority of cases. The validated model was used to investigate more complex problems.

42 ENGINEERING↗