Engineering topics

Ruoff, A. L.

Publications and source records attributed to Ruoff, A. L..

26 records · Page 2

NASA NTRS1979

A split sphere 60,000 ton press

A split sphere press which can have a total force of 60,000 tons applied to its exterior by a 0.55 GPa hydrostatic pressure vessel is described. The inner anvils are made of tungsten carbide and show considerable plastic deformation under load. Much greater pressures, in the 100 GPa range, are possible if diamond tipped anvils are used. Because of the uniformly loaded multi-anvil arrangement, the diamond tips can be maintained under a high degree of compressive load and therefore prevent fracture which may occur in a conventional opposed anvil arrangement. Press operation on CdS, ZnSe, ZnS, GaP, and BP samples is described, and their resistance versus external pressure on the sphere are plotted.

Wanagel, J.↗

NASA NTRS1976

The sodium chloride primary pressure gauge

The failure of a central force model for sodium chloride is discussed. It is noted that it does not closely satisfy the Cauchy conditions at low temperatures, and that it fails the central force requirement of the Love condition. The available shock data for sodium chloride and its analysis is examined, and two reasons why the Hugoniot transformation pressure is likely to be less than 231 kbar are discussed. The important (but unjustified) theoretical assumptions made in converting Hugoniot to isothermal data is discussed; it is noted that serious error can enter for very large pressures for a given material and that at such high pressures the isothermal data should thus be considered only semiquantitative even if the Hugoniot data itself is accurate. An alternate method of estimating the isothermal transformation pressure from the Hugoniot transformation pressure is used. This method is based on the temperature derivative of the transformation pressure. On this basis it is concluded that an upper bound for the isothermal transformation of NaCl (to a CsCl-type structure) at room temperature is 257 kbar; it is noted that the actual value may be considerably less than this.

Ruoff, A. L.↗

NASA NTRS1976

Analysis of contact pressures attainable using indentors which are bodies of revolution

The elastic behavior of a conical indentor with a rounded tip pressed against a flat anvil has been analyzed. It is found that when the radius of contact extends beyond the rounded tip, the contact radius increases much more rapidly as the pressure increases than it does for the case of a fully spherical or parabolic tip. Consequently, the pressure achieved for a rounded conical tip for a given applied force is considerably less than for a spherical or parabolic tip.

Ruoff, A. L.↗

NASA NTRS1976

Pressure transition of AlP to a conductive phase

A direct simultaneous electric resistance method of comparison with ZnS and GaP is used to show that AlP becomes conductive at a pressure equal to or less than that of ZnS, which has been shown to transform at a pressure slightly less than that for ZnS and at a pressure considerably less than that for GaP. There are two possible explanations for this behavior: (1) the conductive phase of AlP observed is not the beta-tin phase, or (2) the theoretical predictions are in error.

Wanagel, J.↗

NASA NTRS1975

Yield stress of cemented tungsten carbide

Cemented tungsten carbide yields plastically at room temperature in the presence of a large hydrostatic pressure component. By approximate analysis of the state of stress in supported opposed anvils and by measurement of the pressure at which the anvil tips exhibit a permanent deviation from planarity, we have obtained the yield stress of such materials. Our value for the yield stress of a 3% cobalt cemented tungsten carbide is 86 kbar.

Ruoff, A. L.↗

NASA NTRS1974

Elastic moduli of precompressed pyrophyllite used in ultrahigh pressure research

The propagation of ultrasonic pulses in pyrophyllite specimens was studied to determine the effect of specimen precompression on the measured elastic moduli. Measurements were made at room pressure and, for the precompressed specimens, to pressures of 3 kbar. Pyrophyllite was found to be elastically anisotropic, apparently the result of the fabric present in our material. The room pressure adiabatic bulk modulus as measured on specimens made of isostatically compacted powered pyrophyllite was determined to be 96.1 kbar. The wave speeds of ultrasonic pulses in pyrophyllite were found to decrease with increasing specimen precompression. A limiting value of precompression was found, above which no further decrease in wave speed was observed. For the shear wave speeds this occurs at 10 kbar while for the longitudinal wave at 25 kbar. In the limit, the shear waves propagate 20% slower than in the unprecompressed samples; for the longitudinal wave the difference is 30%.

Sachse, W.↗

NASA NTRS1974

Stress anisotropy and concentration effects in high pressure measurements

Sodium chloride is used as an internal pressure standard in high pressure research. Possible corrections are discussed which are needed in the calibration of this standard due to the independent effects of stress anisotropy and stress concentration in pressure vessels. The first is due to the lack of a truly hydrostatic state of stress in solid state pressure vessels. The second is due to the difference in the compressibilities between the pressure transmitting substances (sodium chloride) and a stiffer test specimen. These two corrections are then combined and a total correction, as a function of measured pressure, is discussed for two systems presently in use. The predicted value of the combined effect is about 5-10% of the pressure at 30 GPa.

Nelson, D. A., Jr.↗

NASA NTRS1974

Plastic flow around rigid spherical inclusions

The extent of plastic flow in a spherical solid (assumed to be homogeneous and elastically and plastically isotropic), surrounding a concentric rigid sphere was calculated as a function of applied external pressure. The applied pressure necessary to cause plastic deformation throughout the solid was obtained.

Ruoff, A. L.↗