Engineering Papers⌕ Search

Engineering topics

Rowe, M.

Publications and source records attributed to Rowe, M..

Nuclear-pumped CO2 laser

The He-3 (n,p)T reaction was examined as an energy source for a CO2 laser. For this purpose He-3 was added to a functioning CO2 electrically excited laser. Initially the laser was run electrically with 12 torr total pressure. The gas mixture was 1:1:8, CO2:N2:He. At zero reactor power, the laser was tested in place next to the core of the Georgia Tech. Research Reactor. After verification of laser action He-3 was added to the system. The He-3 partial pressures of 10 torr, 50 torr, and 300 torr were added in three separate reactor runs. Reactor power ranged from zero to 5 million watts, which corresponds to a peak flux of 10 to the 14th power/sq cm. At reactor powers greater than 10 kW, gain of up to 30 percent was shown. However, indications are this may be due to gamma excitation rather than caused by the He-3 (n,p)T reaction. These results do agree with the data of past CO2 nuclear pumped laser experiments.

Rowe, M.↗

Experimental setup for decomposition of UF6

The rate at which UF6 decomposes into UF5 and UF4 was determined as a function of neutron fluence. To study UF6 decomposition rate, an absorption cell for VUV and the associated VUV spectroscopy system was used to measure UF6 while under irradiation. The cell contains 50 torr of UF6 at room temperature to insure that the UF6 is in a gaseous state. It is shown that by determining the absorption coefficient below 2100A for UF6, above 2100A for F2, and at 4100A for cell degradation, UF6 decomposition can be measured at a neutron flux of 10 to the 12th power/sq cm for 72 continuous hours.

Rowe, M.↗