Fine-Tuning the Superparamagnetic Properties of FeO@Fe 3 O 4 Core/Shell Nanoparticles and Superclusters by Controlling Size and Shape
Not Available
Nguyen, Minh Dang (ORCID:0000000225698279)↗
Engineering topics
Robles Hernandez, Francisco C.
Publications and source records attributed to Robles Hernandez, Francisco C..
Silver-carbon interlayers in anode-free solid-state lithium metal batteries: Current development, interfacial issues, and instability challenges
As an interlayer between the anode and the electrolyte of the all-solid-state lithium metal batteries (ASSLMBs), the silver-carbon (Ag-C) nanocomposite has been reported to significantly increase the energy density and cycle rate of solid-state lithium metal batteries. Ag-C interlayers serve as mixed ionic-electronic conductor that conducts both Li+ ions and electrons and lithium storage capacity. Unfortunately, it was unclear how the Ag-C interlayer regulated lithium plating and stripping. Moreover, the structural and chemical instabilities between the interlayer and the electrolyte, within the interlayer, or beneath the interlayer on lithium substrate are likely to cause cell failure. In this review, we discuss interfacial issues and summarize recent progress in solution strategies for ASSLMBs, with a specific focus on the use of a silver-carbon (Ag-C) nanocomposite interlayer in anode-free setups. Based on the Li transport kinetics among the Ag-C interlayers, the interfacial configurations of Ag-C interlayers are classified as either exterior or internal. Furthermore, the review concludes with a discussion of the perspectives and future prospects, allowing for the improvement of interlayer techniques for solid-state batteries.
25 ENERGY STORAGE↗
New insight into strain and composition of BaZrO 3 nanorods in REBCO superconductor
We report on strain and composition effects associated with growth of self-assembled BaZrO 3 (BZO) nanorods in REBa 2 Cu 3 O 7–δ (REBCO) superconductors (RE = rare earth = Y and Gd), which have a profound effect on flux pinning and in-field critical current performance. The a-b plane mismatch between BZO and REBCO is never fully coherently accommodated. Instead, the nanorods always assume a size at least one unit cell smaller than the corresponding 'hole' in the REBCO matrix, thus providing deep minima of in-plane mismatch strain. Next, we show that the nominal BZO nanorods are in fact solid solution Ba 2+ (Zr 4+ 1–z RE 3+ z )O 3–δ perovskite, thus strongly affecting the stoichiometry and relative amounts of REBCO and BZO. We demonstrate that by varying only the Ba content in the nominal composition of 15 mol.% BZO + REBCO, the unit cell density of BZO can be tuned from 5% to 23%, and the linear density of RE 2 O 3 (REO) precipitates from 18 to 1 μm –1 . Furthermore, the results explain the wide range of pinning performances observed for the same nominal amount of Zr addition and provide insight into the mechanisms behind the complex phenomenon of growth of nanorods by self-assembly in REBCO superconductors.
2G-HTS↗
Substitution of copper atoms into defect-rich molybdenum sulfides and their electrocatalytic activity
Colloidal technique was used to synthesize copper atom substituted molybdenum sulfides and used as a catalyst. The derived materials were characterized using several analytical methods and revalidated using DFT calculations.
37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗