Engineering Papers⌕ Search

Engineering topics

Robinson, D. L.

Publications and source records attributed to Robinson, D. L..

18 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

10-Mbps electro-optic resonant phase modulator

A resonant cavity electro-optic phase modulator has been designed and implemented to operate at a data rate of 10 Mbps. The modulator consists of an electro-optic crystal located in a highly resonant cavity. The cavity is electro-optically switched on and off resonance, and the phase dispersion near the cavity resonance provides the output phase modulation. The performance of the modulator was measured by first heterodyne-detecting the signal to an intermediate frequency and then measuring the spectral characteristics using an rf spectrum analyzer. The measured phase shift is shown to be in good agreement with the theoretical predictions. Further theoretical analysis shows that the design of the modulator can be scaled to operate at 100 Mbps.

Robinson, D. L.↗
NASA NTRS1991

An electro-optic resonant modulator for coherent optical communication

A resonant cavity electro-optic phase modulator has been designed and implemented to operate at a data rate of 10 Mbps. The modulator consists of an electro-optic crystal located in a highly resonant cavity. The cavity is electro-optically switched on and off resonance, and the phase dispersion near the cavity resonance provides the output phase modulation. The performance of the modulator was measured by first heterodyne detecting the signal to an intermediate frequency, and measuring the spectral characteristics using an RF spectrum analyzer. The measured phase shift is shown to be in good agreement with the theoretical predictions. Further theoretical analysis shows that the design of the modulator can be scaled to operate at 100 Mbps.

Robinson, D. L.↗
NASA NTRS1991

Environmental testing of a Q-switched Nd:YLF laser and a Nd:YAG ring laser

A Q-switched Nd:YLF laser (model 110-02) and a Nd:YAG ring laser (model 120-04) from Lightwave Electronics were subjected to thermal and vibration tests similar to what can be expected during launch and flight on a spacecraft. Even though these lasers were not designed for space flight, environmental tests were performed to identify major design weaknesses. Laser performance (output power, energy, pulsewidth, lasing threshold etc.) were measured prior to and after thermal vibration tests. Average output power of the Q-switched laser degraded 15-20 percent after thermal tests and an additional 20-25 percent after vibration tests. Post diagnostic tests revealed that degradation of the Q-switched laser was due to misalignment of pump focusing optics and the laser cavity.

Robinson, D. L.↗
NASA NTRS1989

Pulse-Position Modulation For Optical Communication

Report discusses schemes for pulse-position modulation of neodymium: yttrium aluminum garnet (Nd:YAG) lasers for optical transmission of data between distant spacecraft and stations on Earth.

Rayman, M. D.↗
NASA NTRS1989

Efficient Cavity-Dumped, Frequency-Doubled Nd:YAG Laser

New design expected to increase efficiency of cavity-dumped, frequency-doubled Nd:YAG laser. Frequency doubled outside primary laser resonator, and portion of fundamental-frequency light not used by doubler returned to primary laser cavity to increase efficiency. Applications of laser foreseen in data communictions, laser ranging, studies of atmosphere, remote sensing, and laboratory studies.

Robinson, D. L.↗
NASA NTRS1989

A novel approach to a PPM-modulated frequency-doubled electro-optic cavity-dumped Nd:YAG laser

A technique which can provide frequency doubling, with high efficiency, while cavity dumping a laser for pulse position M-ary modulation while being used for an optical communication link is discussed. This approach uses a secondary cavity that provides feedback of the undoubled fundamental light, which is normally lost, into the primary cavity to be recirculated and frequency doubled. Specific operations of the electrooptic modulator and frequency-doubling crystal are described along with the overall modulation scheme and experimental setup.

Robinson, D. L.↗
NASA NTRS1988

Calculations of laser cavity dumping for optical communications

For deep-space pulse-position modulation (PPM) optical communication links using Nd:YAG lasers, two types of laser transmitter modulation techniques are available for efficiently producing laser pulses over a broad range of repetition rates: Q-switching and cavity dumping. The desired modulation scheme is dependent on the required pulse repetition frequency and link parameters. These two techniques are discussed, theoretical and numerical calculations of the internal energy of the laser cavity in cavity dumping are described, and an example of cavity dumping is applied to a link for a proposed experiment package on Cassini.

Robinson, D. L.↗
NASA NTRS1988

Solid-State Single-Photon Counter

Avalanche photodiode used to detect single photons if cooled to optimum temperature and overbiased beyond breakdown voltage. Offers two to three times sensitvity of photomultiplier tubes commonly used for photon detection. When cooled to reduce number of thermal carriers, avalanche photodiode reverse-biased beyond normal breakdown voltage to give it extremely-high internal gain of 10 to seventh power to 10 to eigth power. Advantages of solid-state devices to applications requiring low-level light detection, optical communication, astronomy, remote sensing, optical metrology, and optical signal processing.

Robinson, D. L.↗
NASA NTRS1987

Frequency doubling conversion efficiencies for deep space optical communications

The theory of optical frequency doubling conversion efficiency is analyzed for the small signal input case along with the strong signal depleted input case. Angle phase matching and beam focus spot size are discussed and design trades are described which maximize conversion efficiency. Experimental conversion efficiencies from the literature, which are less than theoretical results at higher input intensities due to saturation, reconversion, and higher order processes, are applied to a case study of an optical communications link from Saturn. Double pass conversion efficiencies as high as 45 percent are expected. It is believed that even higher conversion efficiencies can be obtained using multipass conversion.

Robinson, D. L.↗
NASA NTRS1987

Photon detection with cooled avalanche photodiodes

Commercial avalanche photodiodes have been operated as single-photon detectors at an optimum operating temperature and bias voltage. These detectors were found to be 1.5-3 times more sensitive than presently available photomultiplier tubes (PMTs). Both single-photon detection probability and detector noise increase with bias voltage; detection probabilities greater than twice that of a PMT were obtained with detector noise levels below 100 counts per second. Higher probabilities were measured at higher noise levels. The sources of noise and their dependence on temperature and bias voltage are discussed.

Robinson, D. L.↗
NASA NTRS1986

A cooled avalanche photodiode with high photon detection probability

An avalanche photodiode has been operated as a photon-counting detector with 2 to 3 times the sensitivity of currently-available photomultiplier tubes. APD (avalanche photodiodes) detection probabilities that exceed 27% and approach 50% have been measured at an optimum operating temperature which minimizes noise. The sources of noise and their dependence on operating temperature and bias voltage are discussed.

Robinson, D. L.↗
NASA NTRS1986

A cost-performance model for ground-based optical communications receiving telescopes

An analytical cost-performance model for a ground-based optical communications receiving telescope is presented. The model considers costs of existing telescopes as a function of diameter and field of view. This, coupled with communication performance as a function of receiver diameter and field of view, yields the appropriate telescope cost versus communication performance curve.

Lesh, J. R.↗
NASA NTRS1986

Electroabsorption Infrared Modulators

Solid-state infrared modulator arrays fabricated and tested successfully. Arrays based on electro-absorption, and because of high speed inherent in small devices of this kind, expected to perform well at multigigahertz frequencies in such applications as multiplexing, demultiplexing, high-speed recording, and printing.

Robinson, D. L.↗
NASA NTRS1985

Photon Detection with Cooled Avalanche Photodiodes: Theory and Preliminary Experimental Results

Avalanche photodiodes (APDs) can be operated in a geiger-tube mode so that they can respond to single electron events and thus be used as photon counting detectors. Operational characteristics and theory of APDs while used in this mode are analyzed and assessed. Preliminary experimental investigation of several commercially available APDs has commenced, and initial results for dark count statistics are presented.

Robinson, D. L.↗
NASA NTRS1984

Monolithically integrated array of GaAlAs electroabsorption modulators

The operation of an eight-element monolithic array of GaAlAs electroabsorption modulators has been demonstrated. The single-mode waveguide modulators are implemented in a reverse-biased p-pi-n heterojunction configuration, with center-to-center spacing of 9 microns between adjacent channels. This device may be useful for intensity modulation in high (spatial) resolution applications.

Robinson, D. L.↗
NASA NTRS1977

NASA standard communications and data handling subsystem

The paper gives a functional description and discusses hardware implementation for the Communication and Data Handling (C&DH) subsystem of the Multimission Modular Spacecraft. The C&DH subsystem: (1) provides the command and telemetry link between the spacecraft and the terrestrial system, (2) distributes commands to and collects telemetry from all spacecraft systems via a duplex serial multiplex data bus and remote interface units, and (3) contains onboard computation capability. The C&DH is a single 4 x 4 x 1-1/2 foot module; the stuffed module weighs 270 lbs including 60 lbs of mission unique weight. The hardware is versatile and cost effective, and its modular structure permits repair, refurbishment, and even modification/updating in space

Robinson, D. L.↗
NASA NTRS1972

Applications technology satellite advanced missions study, volume 1

Four different spacecraft configurations were developed for geostationary service as a high power communications satellite. The first configuration is a Thor-Delta launch into a low orbit with a spiral ascent to synchronous altitude by ion engine propulsion. The spacecraft is earth oriented with rotating solar arrays. Configuration 2 is a direct injection Atlas/Centaur/Burner II vehicle which when in orbit is sun-oriented with a rotating transponder tower. Configurations 3 and 4 are Titan IIIC launches, and are therefore larger and heavier than Configuration 2. They are both sun-oriented, with rotating transponder towers and are directly injected into orbit. Technology discussed includes high power (up to 2 kW) transmitters with collectors radiating heat directly into space, and contoured antenna patterns designed to illuminate particular earth regions. There is also a review of potential users of the services which can be performed by this type satellite in such areas as information networking, public broadcasting and educational television.

Robinson, D. L.↗