Engineering Papers⌕ Search

Engineering topics

Richardson, Thomas J

Publications and source records attributed to Richardson, Thomas J.

Visualization of Charge Distribution in a Lithium Battery Electrode

We describe a method for direct determination and visualization of the distribution of charge in a composite electrode. Using synchrotron X-ray microdiffraction, state-of-charge profiles in-plane and normal to the current collector were measured. In electrodes charged at high rate, the signatures of nonuniform current distribution were evident. The portion of a prismatic cell electrode closest to the current collector tab had the highest state of charge due to electronic resistance in the composite electrode and supporting foil. In a coin cell electrode, the active material at the electrode surface was more fully charged than that close to the current collector because the limiting factor in this case is ion conduction in the electrolyte contained within the porous electrode.

25 ENERGY STORAGE↗

Overcharge Protection for 4 V Lithium Batteries at High Rates and Low Temperature

Overcharge protection for 4 V Li{sub 1.05}Mn{sub 1.95}O{sub 4}/lithium cells at charging rates in excess of 1 mA/cm{sup 2} (3C) and at temperatures as low as -20 C was achieved using a bilayer separator coated with two electroactive polymers. High rate and low temperature overcharge protection and discharge performance were improved by employing a design in which the polymer-coated portion of the separator is in parallel with the cell rather than between the electrodes. The effects of different membrane supports for the electroactive polymers are also examined.

25 ENERGY STORAGE↗

Continuity and Performance in Composite Electrodes

It is shown that the rate performance of a lithium battery composite electrode may be compromised by poor internal connectivity due to defects and inhomogeneities introduced during electrode fabrication or subsequent handling. Application of a thin conductive coating to the top surface of the electrode or to the separator surface in contact with the electrode improves the performance by providing alternative current paths to partially isolated particles of electroactive material. Mechanistic implications are discussed and strategies for improvement in electrode design and fabrication are presented.

25 ENERGY STORAGE↗

Thermal Instability of Olivine-Type LiMnP04 Cathodes

The remarkable thermal stability of LiFePO{sub 4} and its charged counterpart, FePO{sub 4}, have been instrumental in its commercialization as a lithium ion battery cathode material. Despite the similarity in composition and structure, and despite the high thermal stability of the parent compound, LiMnPO{sub 4}, we find that the delithiated phase Li{sub y}MnPO{sub 4}, (which contains a small amount of residual lithium), is relatively unstable and reactive toward a lithium ion electrolyte. The onset temperature for heat evolution in the presence of 1M LiPF{sub 6} in 1:1 ethylene carbonate/propylene carbonate is around 150 C, and the total evolved heat is 884 J/g, comparable to that produced under similar conditions by charged LiCoO{sub 2} electrodes.

25 ENERGY STORAGE↗

Solid Solution Phases in the Olivine-Type LiMnPO4/MnPO4 System

Nonstoichiometry is reported in the LiMnPO{sub 4}/MnPO{sub 4} system for the first time. As lithium is removed from crystalline LiMnPO{sub 4} by chemical or electrochemical methods, the resulting two phase mixture consists of stoichiometric LiMnPO{sub 4} and a delithiated phase, Li{sub y}MnPO{sub 4}, whose lattice parameters depend upon the global extent of delithiation and on the crystalline domain size of the delithiated phase. This behavior is reproduced during electrochemical insertion of lithium. Again, no evidence for nonstoichiometry was found in the vicinity of LiMnPO{sub 4}. Attempts to create single phase solid solutions by heating mixtures of the two phases failed due to the thermal instability of Li{sub y}MnPO{sub 4}.

25 ENERGY STORAGE↗

Electrochromically switched, gas-reservoir metal hydride devices with application to energy-efficient windows

Proof-of-principle gas-reservoir MnNiMg electrochromic mirror devices have been investigated. In contrast to conventional electrochromic approaches, hydrogen is stored (at low concentration) in the gas volume between glass panes of the insulated glass units (IGUs). The elimination of a solid state ion storage layer simplifies the layer stack, enhances overall transmission, and reduces cost. The cyclic switching properties were demonstrated and system durability improved with the incorporation a thin Zr barrier layer between the MnNiMg layer and the Pd catalyst. Addition of 9 percent silver to the palladium catalyst further improved system durability. About 100 full cycles have been demonstrated before devices slow considerably. Degradation of device performance appears to be related to Pd catalyst mobility, rather than delamination or metal layer oxidation issues originally presumed likely to present significant challenges.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗

Improving the Performance of Lithium Manganese Phosphate Through Divalent Cation Substitution

Highly crystalline samples of LiMnPO{sub 4} and its analogs with partial substitution of Mn by divalent Mg, Cu, Zn, and Ni were prepared by hydrothermal synthesis and characterized by x-ray diffraction and infrared spectroscopy. Chemical oxidation produced two-phase mixtures of the initial phases LiMn{sub (1-y)}M{sub y}PO{sub 4} and the delithiated forms, Li{sub y}Mn{sub (1-y)}M{sub y}PO{sub 4}, all with the olivine structure. The extent of oxidation depended upon the quantity of oxidizing agent used and on the identity of the substituent ions. Mg, Ni and Cu were found to increase the level of delithation relative to that in pure LiMnPO{sub 4}. Mg was also shown to reduce the tendency of the oxidized phase to absorb water.

25 ENERGY STORAGE↗