Engineering Papers⌕ Search

Engineering topics

Ren, Yang

Publications and source records attributed to Ren, Yang.

At least 577 records · Page 32

Dy-V magnetic interaction and local structure bias on the complex spin and orbital ordering in Dy₁₋ x Tb x VO₃ (x=0 and 0.2)

The spin and orbital ordering in Dy₁₋ x Tb x VO₃ (x=0 and 0.2) was studied by measuring x-ray powder diffraction, magnetization, specific heat, and neutron single-crystal diffraction. The results show that G-OO/C-AF and C-OO/G-AF phases coexist in Dy 0.8 Tb 0.20 VO 3 in the temperature range 2–60 K, and the volume fraction of each phase is temperature and field dependent. The ordering of Dy moments at T* = 12 K induces a transition from G-OO/C-AF to a C-OO/G-AF phase. Magnetic fields suppress the long-range order of Dy moments and thus the C-OO/G-AF phase below T*. The polarized moments induced at the Dy sublattice by external magnetic fields couple to the V 3d moments, and this coupling favors the G-OO/C-AF state. Also discussed is the effect of the Dy-V magnetic interaction and local structure distortion on the spin and orbital ordering in Dy₁₋ x Tb x VO₃.

Yan, J.-Q.↗

Heterogeneous in-situ nanostructure contributes to the thermoelectric performance of Zn{sub 4}Sb{sub 3}

Single-phase Zn{sub 4}Sb{sub 3} and ZnSb-containing samples were prepared by Plasma Activated Sintering. An abrupt decrease of thermal conductivity was found at about 400 K, which is attributed to the microstructure change of Zn{sub 4}Sb{sub 3}. Nanoscale inclusions and compositional inhomogeneities were found in Zn{sub 4}Sb{sub 3} sample at 473 K by high-resolution transmission electron microscopy. The phonon scattering is enhanced by increasing grain boundaries and chaotic structure, which reduces the thermal conductivity and increases the thermoelectric performance of Zn{sub 4}Sb{sub 3} at elevated temperature. The Rietveld refinement results show that large ZnSb grains in ZnSb-containing samples will accommodate excess Zn atoms, and then reduce thermoelectric performance.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Compatibility of Lithium Salts with Solvent of the Non-Aqueous Electrolyte in Li–O 2 Batteries

The stability of lithium salts, especially in the presence of reduced oxygen species, O 2 and H 2 O (even in a small amount), plays an important role in the cyclability and capacity of Li–O 2 cells. This combined experimental and computational study provides evidence that the stability of the electrolyte used in Li–O 2 cells strongly depends on the compatibility of lithium salts with solvent. In the case of the LiPF 6 -1NM3 electrolyte, the decomposition of LiPF 6 occurs in the cell as evidenced by in situ XRD, FT-IR and XPS analysis, which triggers the decomposition of 1NM3 solvent due to formation of HF from the decomposition of LiPF 6 . These reactions lead to degradation of the electrolyte and cause poor cyclability of the cell. The same reactions are not observed when LiTFSI and LiCF 3 SO 3 are used as the lithium salts in 1NM3 solvent, or LiPF 6 is used in TEGDME solvent.

25 ENERGY STORAGE↗

Role of support-nanoalloy interactions in the atomic-scale structural and chemical ordering for tuning catalytic sites

The understanding of the atomic-scale structural and chemical ordering in supported nanosized alloy particles is fundamental for achieving active catalysts by design. This report shows how such knowledge can be obtained by a combination of techniques including x-ray photoelectron spectroscopy and synchrotron radiation based x-ray fine structure absorption spectroscopy and high-energy x-ray diffraction coupled to atomic pair distribution function analysis, and how the support-nanoalloy interaction influences the catalytic activity of a ternary nanoalloy (platinum-nickel-cobalt) particles on three different supports: carbon, silica and titania. The reaction of carbon monoxide with oxygen is employed as a probe of the catalytic activity. This ternary composition, in combination with the different support materials, is demonstrated to be capable of fine-tuning the catalytic activity and stability. The support-nanoalloy interaction is shown to influence structural and chemical ordering in the nanoparticles, leading to support-tunable active sites on the nanoalloys for oxygen activation in the catalytic oxidation of carbon monoxide. A nickel/cobalt-tuned catalytic site on the surface of nanoalloy was revealed for oxygen activation, which differs from the traditional oxygen-activation sites known for oxide-supported noble metal catalysts. The discovery of such support-nanoalloy interaction enabled oxygen-activation sites introduces a very promising strategy for designing active catalysts in heterogeneous catalysis.

activation↗

Pressure-Induced Isostructural Phase Transition and Correlation of FeAs Coordination with the Superconducting Properties of 111-Type Na1-xFeAs

The effect of pressure on the crystalline structure and superconducting transition temperature (T{sub c}) of the 111-type Na{sub 1-x}FeAs system using in situ high-pressure synchrotron X-ray powder diffraction and diamond anvil cell techniques is studied. A pressure-induced tetragonal to tetragonal isostructural phase transition was found. The systematic evolution of the FeAs{sub 4} tetrahedron as a function of pressure based on Rietveld refinements on the powder X-ray diffraction patterns was obtained. The nonmonotonic T{sub c}(P) behavior of Na{sub 1-x}FeAs is found to correlate with the anomalies of the distance between the anion (As) and the iron layer as well as the bond angle of As-Fe-As for the two tetragonal phases. This behavior provides the key structural information in understanding the origin of the pressure dependence of T{sub c} for 111-type iron pnictide superconductors. A pressure-induced structural phase transition is also observed at 20 GPa.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Edge transport and turbulence reduction with lithium coated plasma facing components in the National Spherical Torus Experiment

The coating of plasma facing components (PFCs) with lithium improves energy confinement and eliminates ELMs in the National Spherical Torus Experiment, the latter due to a relaxation of the density and pressure profiles that reduces the drive for peeling-ballooning modes. 2-D interpretive transport modeling of discharges without and with lithium shows that a reduction in the PFC recycling coefficient from R {approx} 0.98 to R {approx} 0.90 is required to match the drop in D{sub {alpha}} emission with lithium coatings. A broadening of the edge barrier region showing reduced transport coefficients is observed, with a {approx}75% drop of the D and {chi}{sub e} from 0.8 < {psi}{sub N} < 0.93 needed to match the profile relaxation with lithium coatings. Turbulence measurements using an edge reflectometry system as well as high-k microwave scattering show a decrease in density fluctuations with lithium coatings. These transport changes allow the realization of very wide pedestals, with a {approx}100% width increase relative to the reference discharges.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗