Engineering Papers⌕ Search

Engineering topics

Reimers, Walter

Publications and source records attributed to Reimers, Walter.

Analysis of the flow imbalance on the profile shape during the extrusion of thin magnesium sheets

The extrusion process facilitates the production of magnesium sheets featuring a very thin thickness as well as excellent surface properties by using a single process step only. However, the extrusion of the magnesium sheets applying not optimized process parameters, e.g. low billet temperature or/ and poorly deformable magnesium alloy, produce pronounced buckling and waving of the extruded sheets as well as a variation of accuracy in profile shape along the cross section. The present investigation focuses on the FEM-simulation of the extrusion of magnesium sheets in order to clarify the origin of the mentioned effects. The simulations identify the flow imbalance during extrusion as the main critical factor. Due to the flow imbalance after passing the die a large compression stress zone is formed causing the buckling and waving of the thin sheets. Furthermore, the simulations of the magnesium sheet extrusion reveal that the interaction of the material flow gradients along the width and along the thickness direction near the die orifice lead to the variation of the accuracy in profile shape.

36 MATERIALS SCIENCE↗

Analysis of the Deformation Behavior of Mg-RE and Mg-Li Alloys using In-situ Energy-dispersive Synchrotron X-ray Diffraction

EPSC-Model is able to predict the complex deformation behavior of Mg-RE and Mg-Li alloys within a wide range of strains. Modification of the texture by RE-elements and the addition of Li increases the activity of slip systems at low strains - Reorientation due to twinning is stretch over a larger range of plastic deformation. Deformation at high strains is realized mainly by the basal and the <c+a>-pyramidal slip systems.

36 MATERIALS SCIENCE↗

Grain-resolved elastic strains in deformed copper measured by three-dimensional X-ray diffraction

This X-ray diffraction study reports the grain-resolved elastic strains in about 1000 randomly oriented grains embedded in a polycrystalline copper sample. Diffraction data were collected in situ in the undeformed state and at a plastic strain of 1.5% while the sample was under tensile load. For each grain the centre-of-mass position was determined with an accuracy of 10 {mu}m, the volume with a relative error of 20%, the orientation to 0.05{sup o} and the axial strain to 10{sup -4}. The elastic strain along the tensile direction exhibited a grain orientation dependence with grains within 20 deg. of <100> carrying the largest strain. While the width of the strain distribution for all grains did not change upon plastic loading, the grain-resolved data show a significant widening of the distribution evaluated for small subsets of initially elastically similar grains. This widening appears independent of the grain orientation. - Research Highlights: {yields} X-ray diffraction study of {approx} 1000 Cu grains during in situ plastic deformation. {yields} Grain averaged positions, orientations, volumes and elastic strain tensors derived. {yields} Both lattice rotation and axial strain depend on the initial grain orientation. {yields} Grains within 20{sup o} of <100> carry the largest elastic strain along the tensile axis. {yields} The results enable evaluation and development of polycrystal plasticity models.

36 MATERIALS SCIENCE↗