Engineering Papers⌕ Search

Engineering topics

Reid, Elliott G

Publications and source records attributed to Reid, Elliott G.

15 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1953

Performance Characteristics of Plane-Wall Two-Dimensional Diffusers

Experiments have been made at Stanford University to determine the performance characteristics of plane-wall, two-dimensional diffusers which were so proportioned as to insure reasonable approximation of two-dimensional flow. All of the diffusers had identical entrance cross sections and discharged directly into a large plenum chamber; the test program included wide variations of divergence angle and length. During all tests a dynamic pressure of 60 pounds per square foOt was maintained at the diffuser entrance and the boundary layer there was thin and fully turbulent. The most interesting flow characteristics observed were the occasional appearance of steady, unseparated, asymmetric flow - which was correlated with the boundary-layer coalescence - and the rapid deterioration of flow steadiness - which occurred as soon as the divergence angle for maximum static pressure recovery was exceeded. Pressure efficiency was found to be controlled almost exclusively by divergence angle, whereas static pressure recovery was markedly influenced by area ratio (or length) as well as divergence angle. Volumetric efficiency. diminished as area ratio increased, and at a greater rate with small lengths than with large ones. Large values of the static-pressure-recovery coefficient were attained only with long diffusers of large area ratio; under these conditions pressure efficiency was high and. volumetric efficiency low. Auxiliary tests with asymmetric diffusers demonstrated that longitudinal pressure gradient, rather than wall divergence angle, controlled flow separation. Others showed that the addition of even a short exit duct of uniform section augmented pressure recovery. Finally, it was found that the installation of a thin, central, longitudinal partition suppressed flow separation in short diffusers and thereby improved pressure recovery

Reid, Elliott G↗
NASA NTRS1930

Tests of Five Metal Model Propellers with Various Pitch Distributions in a Free Wind Stream and in Combination with Model VE-7 Fuselage

This report describes the tests of five adjustable blade metal model propellers both in a free wind stream and in combination with a model fuselage with stub wings. The propellers are of the same form and cross section but have variations in radial distributions of pitch. By making a survey of the radial distribution of air velocity through the propeller plane of the model fuselage it was found that this velocity varies from zero at the hub center to approximately free stream velocity at the blade tip. The tests show that the efficiency of a propeller when operating in the presence of the airplane is, over the working range, generally less than when operating in a free wind stream, but that a propeller with a radial distribution of pitch of the same nature as the radial distribution of air velocity through the propeller plane suffers the smallest loss in efficiency.

Lesley, E P↗
NASA NTRS1928

Preliminary Flight Tests of the N.A.C.A. Roots Type Aircraft Engine Supercharger

An investigation of the suitability of the N.A.C.A. Roots type aircraft engine supercharger to flight-operating conditions, as determined the effects of the use of the supercharger upon engine operation and airplane performance, is described in this report. Attention was concentrated on the operation of the engine-supercharger unit and on the improvement of climbing ability; some information concerning high speeds at altitude was obtained. The supercharger was found to be satisfactory under flight-operating conditions. Although two failures occurred during the tests, the causes of both were minor and have been eliminated. Careful examination of the engines revealed no detrimental effects which could be attributed to supercharging. Marked improvements in climbing ability and high speeds at altitude were effected. It was also found that the load which could be carried to a given moderate or high altitude in a fixed time was considerably augmented. A slight sacrifice of low-altitude performance was necessitated, however, by the use of a fixed-pitch propeller. From a consideration of the very satisfactory flight performance of the Roots supercharger and of its inherent advantages, it is concluded that this type is particularly attractive for use in certain classes of commercial airplanes and in a number of military types.

Gardiner, Arthur W↗
NASA NTRS1928

A Full-Scale Investigation of Ground Effect

This report describes flight tests which were made with the Vought VE-7 airplane to determine the effects of flying close to the ground. It is found that the drag of an airplane is materially reduced upon approaching the ground and that the reduction may be satisfactorily calculated according to theoretical formulas. Several aspects of ground effect which have had much discussion are explained.

Reid, Elliott G↗
NASA NTRS1927

Airfoil Lift with Changing Angle of Attack

Tests have been made in the atmospheric wind tunnel of the National Advisory Committee for Aeronautics to determine the effects of pitching oscillations upon the lift of an airfoil. It has been found that the lift of an airfoil, while pitching, is usually less than that which would exist at the same angle of attack in the stationary condition, although exceptions may occur when the lift is small or if the angle of attack is being rapidly reduced. It is also shown that the behavior of a pitching airfoil may be qualitatively explained on the basis of accepted aerodynamic theory.

Reid, Elliott G↗
NASA NTRS1927

A warning concerning the take-off with heavy load

A successful take-off can be made with an airplane so heavily loaded that it cannot climb to a height greater than the span of its wings. The explanation is that the power required to maintain level flight at an altitude of the order of the wing span may be as much as 50 per cent greater than that necessary when the airplane is just clear of the ground. The failure of heavily loaded airplanes to continue climbing at the rate attained immediately after the actual take-off is a grave hazard and has resulted in great risk or catastrophe in three notable cases which are cited.

Reid, Elliott G↗
NASA NTRS1926

Pressure Distribution Over Thick Tapered Airfoils, NACA 81, USA 27c Modified and USA 35

At the request of the United States Army Air Service, the tests reported herein were conducted in the 5-foot atmospheric wind tunnel of the Langley Memorial Aeronautical Laboratory. The object was the measurment of pressures over three representative thick, tapered airfoils which are being used on existing or forthcoming army airplanes. The results are presented in the form of pressure maps, cross-plan load and normal force coefficient curves and load contours. The pressure distribution along the chord was found very similar to that for thin wings, but with a tendency toward greater negative pressures. The characteristics of the loading across the span of the U. S. A. 27 C modified are inferior to those of the other two wings; in the latter the distribution is almost exactly elliptical throughout the usual range of flying angles. The form of tip incorporated in these models is not completely satisfactory and a modification is recommended. (author)

Reid, Elliott G↗
NASA NTRS1925

Standardization Tests of NACA No. 1 Wind Tunnel

The tests described in this report were made in the 5-foot atmospheric wind tunnel of the National Advisory Committee for Aeronautics, at Langley Field. The primary objective of collecting data on the characteristics of this tunnel for comparison with those of others throughout the world, in order that, in the future, the results of tests made in all the principle laboratories may be interpreted, compared, and coordinated on a basis of scientifically established relationships, a process hitherto impossible due to the lack of comparable data. The work includes tests of a disk, spheres, cylinders, and airfoils, explorations of the test section for static pressure and velocity distribution, and determination of the variations of air flow direction throughout the operating range of the tunnel. (author)

Reid, Elliott G↗
NASA NTRS1925

Interference Tests on NACA Pitot Tubes

In connection with the standardization of instruments used in the wind tunnel, this investigation was undertaken to determine the nature and magnitude of the errors inherent in the measurement of air speed by a pitot tube when the instrument is mounted close to some other body. The mounting of the instrument in proximity to some other body is so frequent in flight and in wind tunnel research that it seemed advisable to investigate thoroughly the magnitude of the possible errors caused by such proximity. The results of this investigation will facilitate comparisons of the errors due to interference which have been reduced to percentages of the air-speed readings obtained under conditions of no interference.

Reid, Elliott G↗
NASA NTRS1925

The Effects of Shielding the Tips of Airfoils

Tests have recently been made at Langley Memorial Aeronautical Laboratory to ascertain whether the aerodynamic characteristics of an airfoil might be substantially improved by imposing certain limitations upon the air flow about its tips. All of the modified forms were slightly inferior to the plain airfoil at small lift coefficients: however, by mounting thin plates, in planes perpendicular to the span, at the wing tips, the characteristics were improved throughout the range above three-tenths of the maximum lift coefficient. With this form of limitation the detrimental effect was slight; at the higher lift coefficients there resulted a considerable reduction of induced drag and consequently, of power required for sustentation. The slope of the curve of lift versus angle of attack was increased.

Reid, Elliott G↗
NASA NTRS1924

Tests of Rotating Cylinders

Tests were made in the no. 1 wind tunnel at Langley Memorial Aeronautical Laboratory to determine the air forces acting on rotating cylinders with axes perpendicular to the direction of motion. One cylinder had a circular cross-section, the other that of a greek cross.

Reid, Elliott G↗