Flight tests have been made to determine the longitudinal stability and control and stalling characteristics of a North American P-51H airplane. The results indicate that the airplane has satisfactory longitudinal stability in all the flight conditions tested at normal loadings up to 25,000 feet altitude. At Mach numbers above 0.7, the elevator push force required for longitudinal trim decreased somewhat because of compressibility effects. The elevator stick force per g in accelerated turns at the forward center-of-gravity position of 24 percent mean aerodynamic chord above 250 miles per hour was in excess of the required limits at both 5,000 and 25,OOO feet altitude. The longitudinal-trim-force changes due to flaps and power were small, but the rudder-trim-force change with power change was high. The stalling characteristics in all the conditions tested were satisfactory.

Kraft, Christopher C., Jr.↗

NASA NTRS1948

Measurements of the Lateral and Directional Stability and Control Characteristics of a P-51H Airplane (AAF No. 44-64164)

Flight tests of a P-51H airplane with two different vertical-tail assemblies were made to determine lateral and directional stability and control characteristics. The airplane had satisfactory directional stability in the landing, approach, and wave-off conditions with either tail. In the power-on clean and glide conditions, however, the airplane had weak directional stability with the original tail. The production tail, which had a 7-inch fin extension and a shorter span rudder, improved the directional stability in the power-on clean and glide conditions, but the stability was still weak in the power-on clean condition. Increased altitude in either case caused a slight decrease in the stability. The rudder-trim-force change with speed with either vertical-tail assembly was high. The general aileron control characteristics were satisfactory but the aileron effectiveness failed to meet the Army handling-qualities requirements.

Kraft, Christopher C., Jr.↗

NASA NTRS1945

Flight Measurements of Lateral and Directional Stability and Control Characteristics of the Grumman F8F-1 Airplane

This paper presents the results of flight tests to determine the lateral and directional stability and control characteristics of the Grumman F8F-1 airplane with three vertical-tail configurations. The data presented herein have no bearing on the performance characteristics of the airplane, which were not measured but which were considered to be exceptionally good. The conclusions reached regarding the lateral and directional stability and control characteristics may be summarized as follows: 1. It was found that the directional stability was poor with the production vertical tail. Addition of a 12-inch extension to the vertical fin and rudder produced a desirable improvement in directional stability and control characteristics. However, further enlargement of the vertical tail would be required to make the directional stability satisfactory in all respects. 2. There was a tendency for the rudder control force to overbalance at large angles of right sideslip with the modified vertical tails. There was no such tendency with the production tail configuration which included a dorsal fin. It was concluded that the dorsal fin should have been retained on the modified vertical tails. 3. The aileron control characteristics were better than those of many comparable airplanes which have been tested. However, the ailerons did not satisfy the Navy requirements for satisfactory flying qualities with regard to either control forces or rolling effectiveness. 4. The power of the rudder trimming tab proved to be inadequate and the tab should be enlarged and/or be provided with an increased deflection range.

Crane, H. L.↗