Characterization of Mybrid Rocket Internal Heat Flux and HTPB Fuel Pyrolysis
As an assistance in the development and verification of CFD models of the hybrid rocket (.
CFD models hybrid rocket colid fuel soot heat flux↗
Engineering topics
Ray, R. L.
Publications and source records attributed to Ray, R. L..
Hybrid rocket combustion study
The objectives of this study of 'pure' or 'classic' hybrids are to (1) extend our understanding of the boundary layer combustion process and the critical engineering parameters that define this process, (2) develop an up-to-date hybrid fuel combustion model, and (3) apply the model to correlate the regression rate and scaling properties of potential fuel candidates. Tests were carried out with a hybrid slab window motor, using several diagnostic techniques, over a range of motor pressure and oxidizer mass flux conditions. The results basically confirmed turbulent boundary layer heat and mass transfer as the rate limiting process for hybrid fuel decomposition and combustion. The measured fuel regression rates showed good agreement with the analytical model predictions. The results of model scaling calculations to Shuttle SRM size conditions are presented.
Strand, L. D.↗
Hybrid rocket fuel combustion and regression rate study
The objectives of this study are to develop hybrid fuels (1) with higher regression rates and reduced dependence on fuel grain geometry and (2) that maximize potential specific impulse using low-cost materials. A hybrid slab window motor system was developed to screen candidate fuels - their combustion behavior and regression rate. Combustion behavior diagnostics consisted of video and high speed motion pictures coverage. The mean fuel regression rates were determined by before and after measurements of the fuel slabs. The fuel for this initial investigation consisted of hydroxyl-terminated polybutadiene binder with coal and aluminum fillers. At low oxidizer flux levels (and corresponding fuel regression rates) the filled-binder fuels burn in a layered fashion, forming an aluminum containing binder/coal surface melt that, in turn, forms into filigrees or flakes that are stripped off by the crossflow. This melt process appears to diminish with increasing oxidizer flux level. Heat transfer by radiation is a significant contributor, producing the desired increase in magnitude and reduction in flow dependency (power law exponent) of the fuel regression rate.
Strand, L. D.↗
Long-term storage test of a Syncom solid rocket motor
After 7.5 years of storage at ambient temperature, a solid propellant apogee motor was tested successfully. The performance of the motor did not deteriorate as a result of prolonged storage. Tabular performance data and graphic thrust and pressure variations are given.
Ray, R. L.↗