Engineering Papers⌕ Search

Engineering topics

Rasmussen, R. A.

Publications and source records attributed to Rasmussen, R. A..

41 records · Page 3

Interlaboratory calibration of atmospheric nitrous oxide measurements

Samples representative of Northern Hemispheric conditions in mid-1976 were analyzed by 11 laboratories to resolve the question of the absolute tropospheric concentration of nitrous oxide. The laboratories all employed electron capture-gas chromatography for the analysis. After exclusion of one anomalously low determination, the calibration results showed a mean concentration of 323.5 + or - 8.7 ppb v/v nitrous oxide.

Rasmussen, R. A.↗

Global and regional N2O measurements

Real-time N2O measurements have been made in situ at the South Pole, Antarctica, north and south of the equator from on board the Alpha Helix and over the Pacific Ocean on several aircraft flights from the U.S. to New Zealand, Australia and 90 deg S. In addition, an automated EC-GC has been operated for the past year intermittently monitoring N2O in surface air at a rural site in the wheatlands of eastern Washington state. The data obtained are consistent and in agreement with the data obtained from the analyses of a large number of samples collected both from ground stations and a variety of aircraft flights made in the southern and northern hemisphere. The observed global data show no interhemispheric differences. The present concentration of N2O in the troposphere is measured to be 330 + or - 3 ppbv. Its vertical distribution in the troposphere is very uniform. A small decrease (2-3 percent) across the tropopause is characteristically observed in the high-altitude flights.

Rasmussen, R. A.↗

N2O analysis in the atmosphere via electron capture-gas chromatography

The potential of commercially available pulse-modulated electron capture detector (ECD)-equipped gas chromatographs for direct measurement of ambient levels of N2O is assessed. Since the sensitivity of ECD to N2O is directly proportional to the detector operating temperature and detector standing current, it is necessary to use a 'hot' ECD (250-350 C). The method is shown to be very precise with a standard error not exceeding 1% for automated analysis of ambient air samples. The technology is available to permit highly accurate routine direct analysis of N2O in the troposphere and stratosphere. Both captured air samples or direct real-time measurement from research vessels or airborne platforms are possible.

Rasmussen, R. A.↗

Clocking connector replaces adapter cables

Single cable using simplified, versatile clocking connector satisfies clocking variations that previously required many cables. Connector consists of specially fabricated grommet follower dial housing, dial assembly, and modified insert.

Arriola, S.↗