Engineering Papers⌕ Search

Engineering topics

Raag, V.

Publications and source records attributed to Raag, V..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

Effect of Ga and P dopants on the thermoelectric properties of n-type SiGe

The purpose of this study was to hot-press improved n-type Si80Ge20/GaP samples directly (without any heat treatment) and to confirm that a Ga/P ratio less than one increases the solubility of P and, hence, improves the power factor and Z. One of the three samples (Ga/P = 0.43) had an improvement in Z of about 20 percent between 400 and 1000 C over that for standard SiGe. This demonstrates that improved samples can be pressed directly and that a Ga/P ratio less than one is necessary. The other two samples (Ga/P = 0.33 and 0.50) had Z's equal to or less than that of standard SiGe but had a lower hot-pressing temperature than the improved sample.

Draper, S. L.↗
NASA NTRS1987

Thermoelectric Properties of Lanthanum Sulfide

Report describes measurement of Seebeck coefficient, electrical resistivity, thermal conductivity, and Hall effect in gamma-phase lanthanum sulfide with composition of La3-x S4. Results of study, part of search for high-temperature thermoelectric energy-conversion materials, indicate this sulfide behaves like extrinsic semiconductor over temperature range of 300 to 1,400 K, with degenerate carrier concentration controlled by stoichiometric ratio of La to S.

Wood, C.↗
NASA NTRS1985

Thermoelectric properties of rare earth chalcogenides

The rare earth chalcogenides are important thermoelectric materials due to their high melting points, self-doping capabilities, and low thermal conductivities. Lanthanum sulfides and lanthanum tellurides have been synthesized in quartz ampules, hot-pressed into samples, and measured. The n-type Seebeck coefficients, electrical resistivities, and power factors generally all increased as the temperature increased from 200 to 1000 C. The figure-of-merit for nonstoichiometric lanthanum telluride was 0.001/deg C at 1000 C, considerably higher than for silicon-germanium. Thermoelectric measurements were made for LaTe(2) and YbS(1.4), and p-type behavior was observed for these compounds from 300 to 1100 C.

Danielson, L. R.↗
NASA NTRS1984

Lanthanum sulfides as high temperature thermoelectric materials

Thermoelectric property measurements have been made for the nonstoichiometric lanthanum sulfides, LaS(R) with R in the range 1.33-1.50. The Seebeck coefficients and electrical resistivities increase with temperature from 200 to 1100 C. Power factors (defined as Seebeck coefficient squared divided by electrical resistivity) generally increase both as the temperature is increased and as the compound composition is varied from LaS(1.48) to LaS(1.35). The power factor values combined with estimates of thermal conductivities for LaS(1.38) and LaS(1.4) yield figures of merit greater than 0.0005 at 1000 C.

Danielson, L. R.↗
NASA NTRS1979

Solar thermoelectric power generation for Mercury orbiter missions

Mercury orbiter mission study results have shown that conventional silicon solar cell array technology is not adequate to produce power because of expected temperatures which range from -90 C to +285 C in about 50 minutes for 16 sun eclipses/day. The solar thermoelectric generator (STG), which requires relatively high temperatures, is being developed as a replacement power source. Several thermoelectric technologies (i.e., lead telluride alloys, bismuth telluride, selenide, and silicon-germanium alloys have been examined for their suitability. Solar concentrator configurations (i.e., flat plate, Fresnel lens, mini-cone, and Cassegrain types) were also studied as candidates for increasing incident radiation during Mercury orbital operations. Detailed results are presented, and show that an STG design based on the use of silicon-germanium alloy thermoelectric material and using high-voltage thermopiles with individual miniconical concentrators presents the optimum combination of technology and configuration for minimizing power source mass.

Swerdling, M.↗
NASA NTRS1979

Analytical predictions of RTG power degradation

The DEGRA computer code that is based on a mathematical model which predicts performance and time-temperature dependent degradation of a radioisotope thermoelectric generator is discussed. The computer code has been used to predict performance and generator degradation for the selenide Ground Demonstration Unit (GDS-1) and the generator used in the Galileo Project. Results of parametric studies of load voltage vs generator output are examined as well as the I-V curve and the resulting predicted power vs voltage. The paper also discusses the increased capability features contained in DEGRA2 and future plans for expanding the computer code performance.

Noon, E. L.↗
NASA NTRS1978

The application of solar thermoelectric generators in near-sun missions

Future planetary near-sun missions, such as those studied for low-altitude Mercury Orbiters, introduce challenges in the selection of appropriate power sources. Study results have shown that conventional silicon solar array technology is not adequate to produce power because of expected temperatures which range from -90 C to +285 C in about 40 to 50 minutes for 16 sun eclipses/day. The solar thermoelectric generator (STG), which requires relatively high temperatures, is being considered as a replacement power source. The complete STG consists of a solar concentrator and multiple thermopiles, each containing numerous thermocouples and thermal insulation material. Articulation of the STG design configurations is required at 0.45 AU to acquire maximum incident radiation and at 0.3 AU to reduce the higher incident radiation. STG thermal input to the spacecraft as it orbits Mercury (including sun eclipses) is insignificant.

Raag, V.↗
NASA NTRS1978

Analytical predictions of selenide RTG power degradation

A mathematical model for the performance and degradation analysis of an RTG using the newly developed selenide thermoelectric materials has been developed at JPL. The computerized model is quite comprehensive and enables the accurate detailing of the electrical and thermal effects that take place within the thermocouple under any desired set of operation conditions, including heat input, ambient temperature and load conditions. The paper discusses the logic flow of the computer model and presents the time and temperature dependent results for various degradation mechanisms and rates as they have been established to date.

Noon, E. L.↗
NASA NTRS1978

Comprehensive thermoelectric properties of n- and p-type 78a/o Si - 22a/o Ge alloy

The time and temperature dependence of the thermoelectric properties on n- and p-type 78 a/o Si - 22 a/o Ge alloy are presented in detail for the range of temperatures of zero to 1000 C and operating times up to twelve years. The mechanisms responsible for the time dependence of the properties are discussed and mathematical models used in the derivation of the property values from experimental data are presented. The thermoelectric properties for each polarity type of the alloy are presented as a function of temperature for various operating times.

Raag, V.↗
NASA NTRS1978

Design concepts of solar thermoelectric generators in space applications

Several thermoelectric technologies have been examined as to their suitability for use in a solar thermoelectric generator (STG) as a nonpropulsive power source for space applications. The results show that of all the presently available thermoelectric technologies, i.e., lead telluride, bismuth telluride, selenide, and silicon-germanium alloys, the latter type provides the optimum STG. Detailed results are presented on the performance and configurational characteristics of various silicon-germanium alloy STGs, including the performance of such STGs as a function of time in a Mercury orbit and the orbit of Mercury around the sun. It is shown that an STG design based on the use of silicon germanium alloy thermoelectric material, using multiple high voltage thermopiles with individual solar concentrators, presents the optimum combination of technology and configuration for minimizing power source mass. Additional concepts studied and discussed are the flat plate individual thermopile type and single concentrator compact thermopile type. The STG possesses an attractive potential for this application and represents a useful addition to the family of power sources for consideration in various space applications.

Raag, V.↗
NASA NTRS1975

The time and temperature dependence of the thermoelectric properties of silicon-germanium alloy

Experimental data on the electrical resistivity and Seebeck coefficient of n-type and p-type silicon-germanium alloys are analyzed in terms of a solid-state dopant precipitation model proposed by Lifshitz and Slyozov (1961). Experimental findings on the time and temperature dependence of the thermal conductivity of these two types of alloy indicate that the thermal conductivity of silicon-germanium alloys changes with time, contrary to previous hypothesis. A preliminary model is presented which stipulates that the observed thermal conductivity decrease in silicon-germanium alloys is due partly to dopant precipitation underlying the electrical property changes and partly to enhanced alloying of the material. It is significant that all three properties asymptotically approach equilibrium values with time. Total characterization of these properties will enable the time change to be fully compensated in the design of a thermoelectric device employing silicon-germanium alloys.

Raag, V.↗
NASA NTRS1974

Thermoelectric properties of 80 a/o Si-20 a/o Ge alloy

This paper discusses the time and temperature dependence of the thermoelectric properties of n- and p-type 80 at. % Si-20 at. % Ge alloy. It is shown that the time-temperature behavior of the properties of both polarity types of this alloy can be described by means of a diffusion-limited dopant precipitation model due to Lifshitz and Slyozov (1961). An experimental program for the determination of the long-term behavior of the properties of the alloy is described in terms of the Lifshitz-Slyozov model, and the thermoelectric properties of the alloy are given for temperatures in the range from room temperature to 1000 C as a function of time up to and including twelve years. The data given for the p-type alloy represent the first time-dependent thermoelectric property data ever published for the p-type silicon-germanium alloys.

Raag, V.↗
NASA NTRS1972

Dopant precipitation in silicon-germanium alloys.

The model commonly used to describe dopant precipitation in silicon-germanium alloys is discussed. The results of an experimental program are fit to the model in order to determine the long-term behavior of the thermoelectric properties of the n-type 80 at. % Si/20 at. % Ge alloy. Thermoelectric property projections to twelve years of operating time are given.

Raag, V.↗
NASA NTRS1972

Detailed mathematical models of a radioisotope thermoelectric generator.

Two new models for the design and performance analysis of RTG's are outlined in this paper. The first model assumes a small-signal transient-type calculational sequence that permits the separation of steady-state operation of the generator from its dynamic behavior. The second model uses a numerical (finite difference) solution of the performance equations of the RTG. Both models enable the investigation of transient and steady-state performance of RTG's. Simplifying assumptions have been kept to a minimum in the new RTG models and these models enable the inclusion of generator end losses, axial temperature gradients and heat interchange between thermoelements and thermal insulation in RTG performance calculations in a self-consistent manner.

Dewinter, F.↗