Engineering Papers⌕ Search

Engineering topics

Propp, Timothy

Publications and source records attributed to Propp, Timothy.

Space Station Power Generation Investigated in Support of the Beta Gimbal Anomaly Resolution

The International Space Station (ISS) is the largest and most complex spacecraft ever assembled and operated in orbit. The first U.S. photovoltaic module, containing two solar arrays, was launched, installed, and activated in early December 2000. After the first week of continuously rotating the U.S. solar arrays, engineering personnel in the ISS Mission Evaluation Room observed higher than expected electrical currents on the drive motor in one of the Beta Gimbal Assemblies (BGA), the mechanism used to maneuver a U.S. solar array (see the on-orbit photograph). The magnitude of the motor currents continued to increase over time on both BGAs, creating concerns about the ability of the gimbals to continue pointing the solar arrays towards the Sun, a function critical for continued assembly of the ISS. The BGA provides two critical capabilities to the ISS: (1) transfer of electrical power across a rotating joint and (2) positioning of the solar arrays. A number of engineering disciplines convened in May 2001 to address this on-orbit hardware anomaly. Over the course of a year, many scenarios were developed and used. Only two are discussed here: parked arrays and dual-angle mode.

Delleur, Ann M.↗

A satellite-borne radar wind sensor (RAWS)

Modeling global atmospheric circulations and forecasting the weather would improve if worldwide information on winds aloft were available. Accurate prediction of weather is important to agriculture, shipping, air traffic, and many other fields. Global system models of climate are of great importance. Current global atmospheric models use pressure measurements and thermodynamic properties to calculate the effects of wind for use in Numerical Weather Prediction (NWP) models. Inputs to the NWP models are temperature, pressure and wind velocities at different heights. Clearly direct wind measurements could significantly improve the NWP model performance. The RAdar Wind Sounder (RAWS) program at the University of Kansas is a study of the feasibility and the trade-offs in the design of a space-based radar system to measure wind vectors. This can be done by measuring the Doppler shift of cloud and rain returns from three or more points and calculating the components of the wind vector. The RAWS study to date uses the candidate system selected after preliminary study of frequencies and sensitivities. Two frequencies chosen, 10 and 35 GHz, allow higher sensitivity for clouds and more penetration for rain. The past year was devoted to modeling the signal-to-noise ratio (SNR) achievable for the two frequencies. The determination of SNR versus cloud penetration depth used a cloud backscattering and attenuation model in the appropriate radar equation. Calculations assumed reasonable losses in reception and transmission, in addition to the atmospheric attenuation. We discovered that ice clouds provide a higher SNR than previously calculated, but some water clouds give lower SNRs than we calculated before. One of the primary issues in the SNR calculation was the choice of the drop size distribution. Although Xin used several distributions (e.g., log normal, Khrigian and Mazin), this year we used the Deirmendjian cloud model. SNR versus cloud penetration plots were generated to validate the candidate system. Rain, which appears in the cloud models at the lower altitudes, provides ample SNR, as do the higher clouds composed of ice particles. However, in some cloud situations we found the sensitivity for the clouds was marginal or inadequate. At 35 GHz, two of the cloud models characterized by 1 to 2 g/cu m of water content at altitudes extending from 150 to 1500 meters, produced a sufficient SNR. Other models, however, with water contents ranging from 0.5 to 4 g/cu m and altitudes up to 4000 meters, exhibit SNR of -3 to -23 dB, largely because of attenuation in the upper cloud layers. These results coupled with the lower SNR at 10 GHz, led to an investigation of alternate frequencies. The rain present beneath these clouds provides adequate SNR at 10 GHz, and in most cases, at GHz.

Moore, Richard K.↗

A satellite-borne radar wind sensor (RAWS)

The Laser Wind Sounder (LAWS) measures Doppler shifts from aerosols in the plan for the Earth Observation System (EOS). Gaps exist in LAWS coverage where heavy clouds are present. The radar wind sensor (RAWS) can be utilized to fill these gaps by measuring Doppler shifts from clouds and rain. It is shown that RAWS is a feasible instrument. The antenna required is large and the power is comparable with a spaceborne synthetic aperture radar (SAR). Studies show that such an instrument could measure winds at about 1-km height intervals in denser clouds and rain.

Moore, Richard K.↗