Engineering Papers⌕ Search

Engineering topics

Powell, Richard W.

Publications and source records attributed to Powell, Richard W..

At least 55 records · Page 3

The Road from the NASA Access-to-Space Study to a Reusable Launch Vehicle

NASA has established a goal of providing low-cost reliable access to space. While this goal has been around for many years, it received a major impetus when the U.S. Congress mandated the Access-to-Space study in 1993. This study concluded that a rocket powered single-state-to-orbit vehicle offered the best opportunity for low-cost reliable space transportation by the first decade of the new millennium. This required a focused technology development program before such a vehicle could be built. NASA recognized that no commercial entity would commit to the development of a single-stage-to-orbit vehicle without the U.S. Government's participation. To this end, NASA entered into a cooperative agreement with industry to mature the required technologies. This effort includes the development of an experimental subscale-vehicle known as the X-33, an extensive ground-based program to provide the required additional technology development, and conceptual through preliminary design of an operational reusable launch vehicle. Following this effort, a decision will be made whether or not to proceed with the detailed design and fabrication of an operational vehicle.

Powell, Richard W.↗

Prediction and Validation of Mars Pathfinder Hypersonic Aerodynamic Data Base

Postflight analysis of the Mars Pathfinder hypersonic, continuum aerodynamic data base is presented. Measured data include accelerations along the body axis and axis normal directions. Comparisons of preflight simulation and measurements show good agreement. The prediction of two static instabilities associated with movement of the sonic line from the shoulder to the nose and back was confirmed by measured normal accelerations. Reconstruction of atmospheric density during entry has an uncertainty directly proportional to the uncertainty in the predicted axial coefficient. The sensitivity of the moment coefficient to freestream density, kinetic models and center-of-gravity location are examined to provide additional consistency checks of the simulation with flight data. The atmospheric density as derived from axial coefficient and measured axial accelerations falls within the range required for sonic line shift and static stability transition as independently determined from normal accelerations.

Gnoffo, Peter A.↗

An Atmospheric Guidance Algorithm Testbed for the Mars Surveyor Program 2001 Orbiter and Lander

An Atmospheric Flight Team was formed by the Mars Surveyor Program '01 mission office to develop aerocapture and precision landing testbed simulations and candidate guidance algorithms. Three- and six-degree-of-freedom Mars atmospheric flight simulations have been developed for testing, evaluation, and analysis of candidate guidance algorithms for the Mars Surveyor Program 2001 Orbiter and Lander. These simulations are built around the Program to Optimize Simulated Trajectories. Subroutines were supplied by Atmospheric Flight Team members for modeling the Mars atmosphere, spacecraft control system, aeroshell aerodynamic characteristics, and other Mars 2001 mission specific models. This paper describes these models and their perturbations applied during Monte Carlo analyses to develop, test, and characterize candidate guidance algorithms.

Striepe, Scott A.↗

Numerical Roll Reversal Predictor Corrector Aerocapture and Precision Landing Guidance Algorithms for the Mars Surveyor Program 2001 Missions

This paper describes the development and evaluation of a numerical roll reversal predictor-corrector guidance algorithm for the atmospheric flight portion of the Mars Surveyor Program 2001 Orbiter and Lander missions. The Lander mission utilizes direct entry and has a demanding requirement to deploy its parachute within 10 km of the target deployment point. The Orbiter mission utilizes aerocapture to achieve a precise captured orbit with a single atmospheric pass. Detailed descriptions of these predictor-corrector algorithms are given. Also, results of three and six degree-of-freedom Monte Carlo simulations which include navigation, aerodynamics, mass properties and atmospheric density uncertainties are presented.

Powell, Richard W.↗

Six Degree-of-Freedom Entry Dispersion Analysis for the METEOR Recovery Module

The present study performs a six degree-of-freedom entry dispersion analysis for the Multiple Experiment Transporter to Earth Orbit and Return (METEOR) mission. METEOR offered the capability of flying a recoverable science package in a microgravity environment. However, since the Recovery Module has no active control system, an accurate determination of the splashdown position is difficult because no opportunity exists to remove any errors. Hence, uncertainties in the initial conditions prior to deorbit burn initiation, during deorbit burn and exo-atmospheric coast phases, and during atmospheric flight impact the splashdown location. This investigation was undertaken to quantify the impact of the various exo-atmospheric and atmospheric uncertainties. Additionally, a Monte-Carlo analysis was performed to statistically assess the splashdown dispersion footprint caused by the multiple mission uncertainties. The Monte-Carlo analysis showed that a 3-sigma splashdown dispersion footprint with axes of 43.3 nm (long), -33.5 nm (short), and 10.0 nm (crossrange) can be constructed. A 58% probability exists that the Recovery Module will overshoot the nominal splashdown site.

Desai, Prasun N.↗

Six-degree-of-freedom guidance and control-entry analysis of the HL-20

The ability of the HL-20 lifting body to fly has been evaluated for an automated entry from atmospheric interface to landing. This evaluation was required to demonstrate that not only successful touchdown conditions would be possible for this low lift-to-drag-ratio vehicle, but also the vehicle would not exceed its design dynamic pressure limit of 400 psf during entry. This dynamic pressure constraint limit, coupled with limited available pitch-control authority at low supersonic speeds, restricts the available maneuvering capability for the HL-20 to acquire the runway. One result of this analysis was that this restrictive maneuvering capability does not allow the use of a model-following atmospheric entry-guidance algorithm, such as that used by the Space Shuttle, but instead requires a more adaptable guidance algorithm. Therefore, for this analysis, a predictor-corrector guidance algorithm was developed that would provide successful touchdown conditions while not violating the dynamic pressure constraint. A flight-control system was designed and incorporated, along with the predictor-corrector guidance algorithm, into a six-DOF simulation. which showed that the HL-20 remained controllable and could reach the landing site and execute a successful landing under all off-nominal conditions simulated.

Powell, Richard W.↗

Influence of interplanetary trajectory selection on Earth atmospheric entry velocity of Mars missions

Many current manned Mars mission studies are using low lift-to-drag ratio vehicles to aerobrake at both Mars and Earth. This paper will demonstrate that if entry velocity constraints are incorporated into the interplanetary analysis of aerobraking Mars missions, more opportunities can be achieved for only a small increase in initial mass in low-Earth orbit (IMLEO). These additional opportunities result from varying the initial launch date and the encounter dates and possibly using a powered Venus swingby on either the inbound or outbound transfer. This paper not only presents unconstrained entry velocity missions but also includes results for entry velocities below 12.5 and 14 km/s on Earth return and between 6.0-8.5 km/s at Mars arrival. The results indicate that, regardless of the Mars entry velocity range selected, an Earth entry velocity below 14 km/s is easily attainable for a minimal IMLEO increase. Although there are fewer 12.5 km/s Earth entry velocity missions possible, both Mars entry velocity constraint cases have over 50 percent of their missions requiring a negligible IMLEO increase.

Striepe, Scott A.↗

Influence of interplanetary trajectory selection on Mars atmospheric entry velocity

Many current manned Mars mission studies are using low lift-to-drag ratio (L/D) vehicles to aerobrake at both Mars and Earth. The use of these low L/D vehicles could limit the allowable velocity at the atmospheric interface. This paper will demonstrate that if entry velocity constraints are incorporated into the interplanetary analysis of aerobraking Mars missions, many opportunities can be achieved for a small increase in initial mass in low-Earth orbit (IMLEO). These opportunities result from varying the initial launch date and the encounter dates and possibly using a powered Venus swingby on either the inbound or outbound transfer. This paper demonstrates this technique by using three atmospheric entry velocity ranges at Mars arrival (6.0-8.5, 6.4-8.1, and 7.2-7.3 km/s), unconstrained Mars entry velocities, and an Earth return entry velocity below 14 km/s. The results indicate that, by carefully selecting the interplanetary trajectory, an optimum IMLEO mission can be found for even highly restrictive entry velocity missions in practically all of the 15 yr studied.

Striepe, Scott A.↗

Analysis of the staging maneuver and booster glideback guidance for a two-stage, winged, fully reusable launch vehicle

One of the promising launch concepts that could replace the current space shuttle launch system is a two-stage, winged, vertical-takeoff, fully reusable launch vehicle. During the boost phase of ascent, the booster provides propellant for the orbiter engines through a cross-feed system. When the vehicle reaches a Mach number of 3, the booster propellants are depleted and the booster is staged and glides unpowered to a horizontal landing at a launch site runway. Two major design issues for this class of vehicle are the staging maneuver and the booster glideback. For the staging maneuver analysis, a technique was developed that provides for a successful separation of the booster from the orbiter over a wide range of staging angles of attack. A longitudinal flight control system was developed for control of the booster during the staging maneuver. For the booster glide back analysis, a guidance algorithm was developed that successfully guides the booster from the completion of the staging maneuver to a launch site runway while encountering many off-nominal atmospheric, aerodynamic, and staging conditions.

Naftel, J. Christopher↗

Rocket-powered single-stage vehicle configuration selection and design

A reusable rocket-powered, single-stage launch vehicle has been designed as a part of NASA's Advanced Manned Launch System (AMLS) study to examine options for a next-generation manned space transportation system. The configuration selection process utilized a response surface methodology for multidisciplinary optimization. The methodology was utilized to determine the minimum dry weight entry vehicle to meet constraints on landing velocity and on subsonic, supersonic, and hypersonic trim and stability. Once the optimum configuration was determined, a multidisciplinary conceptual vehicle design was performed. This paper presents the results of the configuration selection methodology and summarizes the overall conceptual design process with special attention given to the individual disciplines of weights/ sizing, structures/materials, configuration, flight mechanics, aerodynamics, aeroheating, propulsion, and operations.

Stanley, Douglas O.↗

Aspects of parking orbit selection in a manned Mars mission

For any round-trip Mars mission, the selection of a parking orbit at Mars must consider the precession caused by the oblateness of the planet. This precession will affect the departure condition for Earth return and, therefore, the initial mass required in low Earth orbit (LEO). In this investigation, which considers precession effects, minimum initial LEO masses were obtained for parking orbits characterized by having near-equatorial inclinations, high eccentricities, and three-dimensional departure burns (i.e., a burn with an in-plane and an out-of-plane velocity increment component). However, because near-equatorial inclination orbits have poor planetary coverage characteristics, they are not desirable from a science viewpoint. To enhance the potential for satisfying science requirements along with landing site accessibility, a penalty in the initial LEO mass is required. This study shows that there are a set of orbits characterized by low to moderate essentricities (e = 0.2 to 0.5) and nonequatorial inclinations (i = 70 to 140 deg) that reduce this initial LEO mass penalty. Therefore, careful selection of a parking orbit at Mars can enhance the potential for satisfying science requirements with minimal mass penalties.

Desai, Prasun N.↗

A six-degree-of-freedom guidance and control analysis of Mars aerocapture

A six-degree-of-freedom (6DOF) simulation is developed to investigate the control and guidance issues of a Mars aerobraking vehicle. The guidance algorithm used is a predictor-corrector guidance formulation designed to control the exit orbital apoapsis and wedge angle using bank-angle modulation. Major features of this predictor-corrector guidance algorithm include: (1) integration of the 3DOF equations of motion within an inner-loop simulation; (2) load-relief logic; (3) finite roll rates; and (4) an aerodynamic feedback multiplier. The algorithm is capable of successfully guiding the vehicle through combinations of atmospheric density dispersions, aerodynamic mispredictions, and off-nominal atmospheric interface conditions. This study demonstrated that the addition of vehicle dynamics to the Mars aerobraking simulation does not significantly impact mission feasibility. That is, a robust control system design coupled with an adaptive guidance algorithm can assure mission success in the presence of numerous off-nominal conditions.

Powell, Richard W.↗

Ascent performance of an air-breathing horizontal-takeoff launch vehicle

Simulations are conducted to investigate a proposed NASA launch vehicle that is fully reusable, takes off horizontally, and uses airbreathing propulsion in a single stage. The propulsion model is based on a cycle analysis method, and the vehicle is assumed to be a rigid structure with distributed fuel, operating under a range of atmospheric conditions. The program to optimize simulated trajectories (POST) is modified to include a predictor-corrector guidance capability and then used to generate the trajectories. Significant errors are encountered during the unpowered coast phase due to uncertainty in the atmospheric density profile. The amount of ascent propellant needed is shown to be directly related to the thrust-vector angle and the location of the center of gravity of the vehicle because of the importance of aim-drag losses to total ideal velocity.

Powell, Richard W.↗