Engineering topics

Potter, J. Leith

Publications and source records attributed to Potter, J. Leith.

8 records

NASA NTRS1992

Rarefied-flow aerodynamics

Means for relatively simple and quick procedures are examined for estimating aerodynamic coefficients of lifting reentry vehicles. The methods developed allow aerospace designers not only to evaluate the aerodynamics of specific shapes but also to optimize shapes under given constraints. The analysis was also studied of the effect of thermomolecular flow on pressures measured by an orifice near the nose of a Space Shuttle Orbiter at altitudes above 75 km. It was shown that pressures corrected for thermomolecular flow effect are in good agreement with values predicted by independent theoretical methods. An incidental product was the insight gained about the free molecular thermal accommodation coefficient applicable under 'real' conditions of high speed flow in the Earth's atmosphere. The results are presented as abstracts of referenced papers. One reference paper is presented in its entirety.

Potter, J. Leith↗

NASA NTRS1991

Aerodynamic calculations related to tethered sub-satellite experiments

The results are presented of four aerodynamic studies that were in support of a broader, preliminary inquiry concerning the potential use of downward-deployed tethered sub-satellites for in-flight aerothermodynamic research. There are a multitude of questions regarding the general tethered satellite concept and the present report addresses only a few of these. A method for estimating drag and local surface pressure and shear on orbiting or re-entereing bodies is described, and examples based on the planned TSS-2 (Tethered Satellite System) are given. The problem of pressure measurement are explored, taking into account thermal transpiration, lag time, and the disturbed flow field created by the satellite body. The performance of an aerodynamic stabilizer, a ring-tail design, is calculated and its influence on satellite motion is illustrated. A method for optimizing future satellite shapes for desired aerodynamic properties is transitional rarefied flow with given geometric constraints is proposed and examples are shown.

Potter, J. Leith↗

NASA NTRS1991

Local and overall aerodynamic coefficients for bodies in hypersonic, rarefied flow

A computational method is given for the prediction of local pressure and viscous shear stress on windward surfaces of bluff, convex, axisymmetric or quasi-axisymmetric, hypersonic bodies in the transitional, rarefied flow regime. Overall aerodynamic forces and moments are computed by integration of the local quantities. The method is based upon a correlation of local pressure and shear stress computed by the direct simulation Monte Carlo (DSMC) numerical technique for cold wall, real gas conditions and some supplemental data from low-density, hypersonic wind tunnels. The relative simplicity of the method makes it feasible to do the necessary calculations with a personal computer. Two-dimensional shapes and leeward surfaces are not included in the scope of the method as it is presented here. Results are compared with DSMC computations for both local and overall coefficients. The latter includes sphere and blunt cone drag as well as lift and pitching moment coefficients for the NASA AFE vehicle at various angles of attack. Very satisfactory agreement is shown.

Potter, J. Leith↗

NASA NTRS1989

Procedure for estimating aerodynamics of three-dimensional bodies in transitional flow

Based on considerations of fluid dynamic simulation appropriate to hypersonic, viscous flow over blunt-nosed lifting bodies, a method was presented earlier for estimating drag coefficients in the transitional-flow regime. The extension of the same method to prediction of lift coefficients is presented in this paper. Correlation of available experimental data by a simulation parameter appropriate for this purpose is the basis of the procedure described. Under low-density, hypersonic flow conditions, the overriding importance of projected and wetted areas, rather than details of body configuration, support this approach for finding aerodynamic forces. The ease of application of the method makes it useful for preliminary studies that involve a wide variety of three-dimensional vehicle configurations or a range of angles of attack of a given vehicle. It is also easy to examine the influence of different assumptions regarding gas/surface interaction parameters.

Potter, J. Leith↗

NASA NTRS1989

Detachment of turbulent boundary layers with varying free-stream turbulence and lower Reynolds numbers

Experiments conducted to determine if free-stream turbulence scale affects detachment of turbulent boundary layers are described. Hot-wire anemometry, liquid-film visualization, a Preston tube, and static pressure measurements were used to study flow over a two-dimensional airfoil in a subsonic wind tunnel. The free-stream turbulence intensity and scale were found to spread to the entire turbulent boundary layer. However, the effect decreased upon approaching the airfoil surface.

Potter, J. Leith↗

NASA NTRS1987

Aerodynamics of 3-dimensional bodies in transitional flow

Potter, J. Leith↗

NASA NTRS1987

Transition from laminar to turbulent flow in separated shear layers

The location of boundary layer separation may be predicted by either semiempirical criteria or by various computer codes written for such calculations; attention is presently given to the streamwide length from separation to transition, denoted by Re(sL). It is demonstrated that the unit Reynolds number, a feature of the transition phenomenon implicit in the data of Schmidt et al. (1985) and overlooked in previous investigations, must be considered in future work.

Potter, J. Leith↗

NASA NTRS1986

The influence of free-stream turbulence on separation of turbulent boundary layers in incompressible, two-dimensional flow

Experiments were conducted to determine if free-stream turbulence scale affects separation of turbulent boundary layers. In consideration of possible interrelation between scale and intensity of turbulence, the latter characteristic also was varied and its role was evaluated. Flow over a 2-dimensional airfoil in a subsonic wind tunnel was studied with the aid of hot-wire anemometry, liquid-film flow visualization, a Preston tube, and static pressure measurements. Profiles of velocity, relative turbulence intensity, and integral scale in the boundary layer were measured. Detachment boundary was determined for various angles of attack and free-stream turbulence. The free-stream turbulence intensity and scale were found to spread into the entire turbulent boundary layer, but the effect decreased as the airfoil surface was approached. When the changes in stream turbulence were such that the boundary layer velocity profiles were unchanged, detachment location was not significantly affected by the variations of intensity and scale. Pressure distribution remained the key factor in determining detachment location.

Potter, J. Leith↗