Engineering PapersSearch

Engineering topics

Pogorzelski, Ronald J.

Publications and source records attributed to Pogorzelski, Ronald J..

At least 19 records

Coupled Oscillator Based Agile Beam Transmitters and Receivers: A Review of Work at JPL

This is a review of the work done at Caltech's Jet Propulsion Laboratory during the past decade on development of the coupled oscillator technology in phased array applications to spacecraft telecommunications. First, some historical background is provided to set the work in context. However, this is by no means intended to be a comprehensive review of all work in this area. Rather, the focus is on the JPL contribution with some mention of other work which provided either insight or motivation. In the mid 1990's, R. A. York, and collaborators proposed that an array of mutually injection locked electronic oscillators could provide appropriately phased signals to the radiating elements of an array antenna such that the radiated beam could be steered merely by tuning the end or perimeter oscillators of the array. York, et al. also proposed a receiving system based on such oscillator arrays in which the oscillators provide properly phased local oscillator signals to be mixed with the signals received by the array elements to remove the phase due to angle of arrival of the incident wave. These concepts were viewed as a promising simplification of the beam steering control system that could result in significant cost, mass, and prime power reduction and were therefore attractive for possible space application.

mutual injection locking

A Range Compensating Feed Motion Concept for Spaceborne Radar

Tropical cyclones can cause major loss of both life and property, so that improvements in forecasting motion, intensity, and rainfall are needed. Such forecasting requires accurate measurements of the current state of the cyclone. Ground-based Doppler radars have long been used as an effective means of monitoring severe precipitating storms. Because of the oceanic nature of tropical cyclones, remote monitoring from space is desirable. Recently, the Precipitation Radar (PR) [1] aboard the Tropical Rainfall Measuring Mission (TRMM) [2] satellite has demonstrated an unprecedented capacity for 3-D imaging of precipitating storms. Nonetheless, due to the relatively long TRMM return cycle (less than once per day) the value of PR data has primarily been limited to the understanding of climatological properties of tropical cyclones [3]. The return cycle can be substantially reduced by sensing from a geostationary platform.

reflector antennas

An exact solution for the steady state phase distribution in an array of oscillators coupled on a hexagonal lattice

When electronic oscillators are coupled to nearest neighbors to form an array on a hexagonal lattice, the planar phase distributions desired for excitation of a phased array antenna are not steady state solutions of the governing non-linear equations describing the system. Thus the steady state phase distribution deviates from planar. It is shown to be possible to obtain an exact solution for the steady state phase distribution and thus determine the deviation from the desired planar distribution as a function of beam steering angle.

injection locking

Helicopter Rotor Antenna

This effort was directed toward demonstration of the efficacy of a concept for mitigation of the rotor blade modulation problem in helicopter communications. An antenna is envisioned with radiating elements mounted on the rotor and rotating with it. The rf signals are coupled to the radio stationary with respect to the airframe via a coupler of unique design. The coupler has an rf cavity within which a mode is established and the field distribution of this mode is sampled by probes rotating with the radiating elements. In this manner the radiated pattern is "despun" with respect to the rotor. Theoretical analysis has indicated that this arrangement will be less susceptible to rotor blade modulation that would be a conventional fixed mounted antenna. A small coupler operating at S-band was designed, fabricated, and mounted on a mockup representative of a helicopter body. A small electric motor was installed to rotate the rotor portion of the coupler along with a set of radiating elements during testing. This test article was be evaluated using the JPL Mesa Antenna Measurement Facility to establish its ability to mitigate rotor blade modulation. It was found that indeed such a coupler will result in a despun pattern and that such a pattern can be effective in mitigation of rotor blade modulation.

Pogorzelski, Ronald J.

Beam scanning reflectarray antenna with circular polarization

A novel means of scanning a circularly polarized reflectarray antenna. The reflectarray is an array of metallic elements arranged on a surface designed to compensate for the various path lengths of the optical rays from an illuminating feed to the reflecting surface and then to the antenna aperture. With appropriate design, the phase in the aperture can be made to vary linearly in any desired direction and also to produce a radiated beam normal to the constant phase surface. In the case of circular polarization, this path length compensation can be accomplished by rotation of the individual elements.

Huang, John

Two-Dimensional Array Beam Scanning Via Externally and Mutually Injection Locked Coupled Oscillators

Some years ago, Stephan proposed an approach to one dimensional (linear) phased array beam steering which requires only a single phase shifter. This involves the use of a linear array of voltage-controlled electronic oscillators coupled to nearest neighbors. The oscillators are mutually injection locked by controlling their coupling and tuning appropriately. Stephan's approach consists of deriving two signals from a master oscillator, one signal phase shifted with respect to the other by means of a single phase shifter. These two signals are injected into the end oscillators of the array. The result is a linear phase progression across the oscillator array. Thus, if radiating elements are connected to each oscillator and spaced uniformly along a line, they will radiate a beam at an angle to that line determined by the phase gradient which is, in turn, determined by the phase difference between the injection signals.The beam direction is therefore controlled by adjusting this phase difference. Recently, Pogorzelski and York presented a formulation which facilitates theoretical analysis of the above beam steering technique. This was subsequently applied by Pogorzelski in analysis of two dimensional beam steering using perimeter detuning of a coupled oscillator array. The formulation is based on a continuum model in which the oscillator phases are represented by a continuous function satisfying a partial differential equation of diffusion type. This equation can be solved via the Laplace transform and the resulting solution exhibits the dynamic behavior of the array as the beam is steered. Stephan's beam steering technique can be similarly generalized to two-dimensional arrays in which the beam control signals are applied to the oscillators on the perimeter of the array. In this paper the continuum model for this two-dimensional case is developed and the dynamic solution for the corresponding aperture phase function is obtained. The corresponding behavior of the resulting far-zone radiation pattern is displayed as well.

Pogorzelski, Ronald J.

Recent Developments in the Analysis of Couple Oscillator Arrays

This presentation considers linear arrays of coupled oscillators. Our purpose in coupling oscillators together is to achieve high radiated power through the spatial power combining which results when the oscillators are injection locked to each other. York, et. al. have shown that, left to themselves, the ensemble of injection locked oscillators oscillate at the average of the tuning frequencies of all the oscillators. Coupling these arrays achieves high radiated power through coherent spatial power combining. The coupled oscillators are usually designed to produce constant aperture phase. Oscillators are injection locked to each other or to a master oscillator to produce coherent radiation. Oscillators do not necessarily oscillate at their tuning frequency.

Pogorzelski, Ronald J.

The Potential of Phased Arrays for Planetary Exploration

Phased array antennas provide a set of operational capabilities which are very attractive for certain mission applications and not very attractive for others. Such antennas are by no means a panacea for telecommunications. In this paper the features of phased arrays are reviewed and their implications for space missions are considered in terms of benefits and costs. The primary capability provided by a phased array is electronic beam agility. The beam direction may be controlled at electronic speeds (vs. mechanical actuation) permitting time division multiplexing of multiple "users." Moreover, the beam direction can be varied over a full hemisphere (for a planar array). On the other hand, such antennas are typically much more complicated than the more commonly used reflectors and horns and this implies higher cost. In some applications, this increased cost must be accepted if the mission is to be carried out at all. The SIR-C radar is an example of such a case albeit not for deep space. Assuming for the sake of argument that the complexity and cost of a phased array can be significantly reduced, where can such antennas be of value in the future of planetary exploration? Potential applications to be discussed are planetary rovers, landers, and orbiters including both the areosynchronous and low orbit varieties. In addition, consideration is given to links from deep space to earth. As may be fairly obvious, the deep space link to earth would not benefit from the wide angle steering capability provided by a phase array whereas a rover could gain advantage from the capability to steer a beam anywhere in the sky. In the rover case, however, physical size of the aperture becomes a significant factor which, of course, has implications regarding the choice of frequency band. Recent research work concerning phased arrays has suggested that future phased arrays might be made less complex and, therefore, less costly. Successful realization of such phased arrays would enable many of the planetary missions discussed in this paper and significantly broaden the telecommunications capabilities available to the mission designers of the future.

Pogorzelski, Ronald J.

Continuum Modeling of the Dynamics of Externally Injection-locked Coupled Oscillator Arrays

Mutually injection-locked arrays of electronic oscillators provide a novel means of controlling the aperture phase of a phased-array antenna, thus achieving the advantages of spatial power combining while retaining the ability to steer the radiated beam. In a number of design concepts, one or more of the oscillators are injection locked to a signal from an external master-oscillator. The behavior of such a system has been analyzed by numerical solution of a system of nonlinear differential equations which, due to its complexity, yields limited insight into the relationship between the injection signals and the aperture phase. In this paper, we develop a continuum model, which results in a single partial differential equation for the aperture phase as a function of time. Solution of the equation is effected by means of the Laplace transformation and yields detailed information concerning the dynamics of the array under the influence of the external injection signals.

injection locked

A Fresh Look at Spatial Power Combining Oscillators

Spatial Power Combining is an enabling technology for achieving useful power levels from solid state devices at millimeter wavelengths. Oscillator-based combining came first, historically, but has been passed over for what practitioners believe to be more reliable amplifier based technology. Recent results in oscillator-based. combining systems offer possibilities for technology breakthrough.

Pearson, L. Wilson

Two-dimensional Array Beam Scanning via Externally and Mutually Injection Locked Coupled Oscillators

Some years ago, Stephan proposed an approach to one dimensional (linear) phased array beam steering which requires only a single phase shifter. This involves the use of a linear array of voltage-controlled electronic oscillators coupled to nearest neighbors. The oscillators are mutually injection locked by controlling their coupling and tuning appropriately.Stephan's approach consists of deriving two signals from a master oscillator, one signal phase shined with respect to the other by means of a single phase shifter. These two signals are injected into the end oscillators of the array as shown in Figure 1. The result is a linear phase progression across the oscillator array. Thus, if radiating elements are connected to each oscillator and spaced uniformly along a line, they will radiate a beam at an angle to that line determined by the phase gradient which is, in turn, determined by the phase difference between the injection signals. The beam direction is therefore controlled by adjusting this phase difference.

Pogorzelski, Ronald J.

Microstrip Reflectarray with Elements Having Variable Rotation Angles

Two Ka-band, half-meter diameter, circularly polarized microstrip reflectarrays have been developed. Although both antennas demonstrated excellent efficiencies, adequate bandwidths, and low average sidelobe and cross-pol levels, the one with variable rotation angles achieved superior overall performance. It is believed that these are electrically the largest microstrip reflectarrays (6924 elements with 42 dB gain) ever developed. It is also the first time that circular polarization has been actually demonstrated using microstrip patch elements. All these reflectarrays have dual-linear and dual-circular polarization capabilities, but only linear polarizations were demonstrated.

antennas

Microstrip Reflectarray with Elements Having Variable Rotation Angles

Two Ka-band, half-meter diameter, circularly polarized microstrip reflectarrays have been developed. One has identical square patches with variable-length phase delay lines. The other uses identical square patches and delay lines with variable element rotation angles. Although both antennas demonstrated excellent efficiencies, adequate bandwidths, and low average sidelobe and cross-pol levels, the one with variable rotation angles achieved superior overall performance. It is believed that these are electrically the largest microstrip reflectarrays (6924 elements with 42 dB gain) ever developed. It is also the first time that circular polarization has been actually demonstrated using microstrip patch elements. Recent advances in reflectarray technology include the following: An X-band 0.75 m diameter microstrip reflectarray using variable-length phase delay lines which demonstrated a relatively high efficiency of 70% with peak gain of 35 dB; a partial microstrip reflectarray with beam scanning capability; A 27 GHz 0.23m diameter microstrip reflectarray using variable-size patches which achieved a gain of 31 dB at an efficiency of 31%. All these reflectarrays have dual-linear and dual-circular polarization capabilities, but only linear polarizations were demonstrated.

Huang, John

On the High-Frequency Asymptotic Evaluation of the Potentials of Elemental Sources on an Anisotropic Impedance Cylinder

In an effort to formulate the high-frequency coupling between antennas located on airframes composed of multilayer imperfectly conducting materials a general model was sought which would embody the electromagnetic properties of the layers and would apply over a broader range of separations of the antennas. Such a model is described here. This work is a generalization of the work of Pearson [1986, 1987a] concerning the high-frequency asymptotic representation of the fields of elemental sources diffracted by a multilayer cylinder. In that work the source and field points were located off the cylinder surface, and they were sufficiently separated to permit the effective use of the residue series representation of the spectral integrals involved. Here the source and field points are located on the cylinder surface and are permitted to be sufficiently close as to render the residue series poorly convergent. To obtain a more effective representation in this situation, the cylinder is modeled by an anisotropic impedance cylinder, and the resulting spectral integrals are evaluated by reduction to forms amenable to multiple applications of techniques described in the literature in connection with treatment of axially uniform sources in this context.

Pogorzelski, Ronald J.

On the Character of the Zeros of Polynomials Relevant to the Small Curvature Approximation in Asymptotic Diffraction Theory

In dealing with the problem of estimating the high frequency coupling between two antennas mounted on a non-metallic aircraft skin, one is faced with approximation of the spectral integrals representing the propagation of rays along the geodesics of the surface between the antennas. When the antennas are sufficiently separated, the integrals can be conveniently represented as a rapidly convergent residue series. On the other hand, when the antennas are in close proximity, the residue series fails to converge rapidly and a power series representation proves to be efficacious. [Paknys and Wang, IEEE Trans. AP-35(3), 1987, 293-298]. When the effective surface impedance is not small, an intermediate region of separation appears in which neither the residue series nor the power series is effective. Recently, an asymptotic formalism was presented [Pogorzelski, National Radio Science Meeting, Boulder, CO, January 1995] which extends the earlier work of Bremmer [IRE Trans. AP-6, 1958, 267-272] and Wait curvature approximation' to the case of general (non-azimuthal) ray directions on the surface of a cylinder (excluding only axial propagation). Based on the formulation of Pearson [Radio Sci. 21(4), 1986] this asymptotic formalism provided a means of approximating the spectral integrals in the intermediate region of separation.

Zeros Polynomials