Engineering PapersSearch

Engineering topics

Piersol, A. G.

Publications and source records attributed to Piersol, A. G..

At least 19 records

The Proposed NASA Pyroshock Test Criteria Standard - Part I

The National Aeronautics and Space Administration has traditionally left the task of specifying design and test criteria to each of the several NASA Centers. Faced with the wide variety fo resulting criteria used for resolving similar or identical problems, the NASA Office of Chief Engineer initiated a program to develop consistent NASA-wide standards if the various NASA Centers could agree to a set of common requirements.

pyrotechnic shock shock testing pyrotechnic testin

Handbook for Dynamic Data Acquisition and Analysis - IES Recommended Practices 012.1

The original motivation for this Handbook came from personnel of The Aerospace Corporation (TAC), who are technical advisors to the Air Force Space and Missile Systems Center. Over the preceding two decades, TAC has observed a seemingly endless series of errors and anomalies in the acquisition and analysis of structural dynamic and aeroacoustic data.

Shock vibration acoustic noise

Summary of

A 325-page Guidelines document [1], whose objectives are to increase the accuracy and reduce the errors and variability commonly found in the measurement of structural shock and vibration and of acoustic and aerodynamic noise, wea recently submitted to the Air Force Space and Missile Systems Center.

scope

Acoustic Load Considerations for Spacecraft Structures

An analytical model to predict the space averaged sound pressure levels in the payload bay of the Space Shuttle orbiter vehicle at lift-off was developed. A modified form of the model can also be used to predict vibration levels of the orbiter mid fuselage and to evaluate noise control concepts for the interior of the proposed Aft Cargo Carrier (ACC). The analytical model is presented and predicted payload bay sound pressure levels are compared with launch data for an empty bay. Estimated and measured sound pressure levels for regions above large diameter payloads are found to be significantly higher than those for the empty bay. The use of helium as a purge gas to reduce sound pressure levels in the ACC is proposed.

Wilby, J. F.

Analytical and experimental evaluations of Space Shuttle TPS tile vibration response

Analytical studies and laboratory experiments have been performed to evaluate the vibration response of the Space Shuttle Thermal Protection System (TPS) tiles due to the intense rocket generated acoustic noise during lift-off. The TPS tiles are mounted over the exterior of the Space Shuttle Orbiter structure through Strain Isolation Pads (SIP) which protect the tiles from thermal induced shear loads at their interface. The analytical predictions indicate that the response of a typical tile is governed by the structural vibration inputs through the SIP under the tile at frequencies below 250 Hz, and by the direct acoustic excitation over the exterior surface of the tile at frequencies above 250 Hz. An evaluation of the laboratory test data for this same tile, in which conditioned (partial) coherent output spectral analysis procedures were used, leads to exactly the same conclusion. The results demonstrate the power of conditioned spectral analysis procedures in identifying vibration response mechanisms when two or more of the inputs are highly correlated.

Piersol, A. G.

An evaluation of Space Shuttle STS-2 payload bay acoustic data and comparison with predictions

Space average sound pressure levels computed from measurements at 18 locations in the payload bay of the Space Shuttle orbiter vehicle during the STS-2 launch were compared with predicted levels obtained using the PACES computer program. The comparisons were performed over the frequency range 12.5 Hz to 1000 Hz, since the test data at higher frequencies are contaminated by instrumentation background noise. In general the PACES computer program tends to overpredict the space average sound levels in the payload bay, although the magnitude of the discrepancy is usually small. Furthermore the discrepancy depends to some extent on the manner in which the payload is modeled analytically, and the method used to determine the "measured' space average sound pressure levels. Thus the difference between predicted and measured sound levels, averaged over the 20 one third octave bands from 12.5 Hz to 1000 Hz, varies from 1 dB to 3.5 dB.

Wilby, J. F.

An evaluation of Space Shuttle STS-1 payload bay acoustic data and comparison with predictions

During the first launch (STS-1) of the Space Shuttle orbiter vehicle, sound pressure levels were measured at several locations in the payload bay of the vehicle and on the exterior surface. The data were obtained in order to provide validation for prediction procedures for interior and exterior sound pressure levels and to determine, independently, the acoustic environment in the payload bay during actual launch conditions.

Wilby, J. F.

Analytical prediction of aerospace vehicle vibration environments

Considerable attention has been given recently to the formulation and validation of analytical models for the prediction of aerospace vehicle vibration response to acoustic and fluctuating pressures. This paper summarizes the development of such analytical models for two applications, (1) structural vibrations of the Space Shuttle orbiter vehicle due to broadband rocket noise and aerodynamic boundary layer turbulence, and (2) structural vibrations of general aviation aircraft due to discrete frequency propeller and reciprocating engine exhaust noise. In both cases, the spatial exterior excitations are convected pressure fields which are described on the basis of measured cross spectra (coherence and phase) information. Structural modal data are obtained from analytical predictions, and structural responses to appropriate excitation fields are calculated. The results are compared with test data, and the strengths and weaknesses of the analytical models are assessed.

Wilby, J. F.

Evaluation of Aero Commander sidewall vibration and interior acoustic data: Static operations

Results for the vibration measured at five locations on the fuselage structure during static operations are presented. The analysis was concerned with the magnitude of the vibration and the relative phase between different locations, the frequency response (inertance) functions between the exterior pressure field and the vibration, and the coherent output power functions at interior microphone locations based on sidewall vibration. Fuselage skin panels near the plane of rotation of the propeller accept propeller noise excitation more efficiently than they do exhaust noise.

Piersol, A. G.

Evaluation of aero commander propeller acoustic data: Taxi operations

The acoustic data from ground tests performed on an Aero Commander propeller driven aircraft are analyzed. An array of microphones flush mounted on the side of the fuselage were used to record data. The propeller blade passage noise during operations at several different taxi speeds is considered and calculations of the magnitude and phase of the blade passage tones, the amplitude stability of the tones, and the spatial phase and coherence of the tones are included. The measured results are compared to theoretical predictions for propeller noise and various evaluations which reveal important details of propeller noise characteristics are presented.

Piersol, A. G.

Characteristics of propeller noise on an aircraft fuselage related to interior noise transmission

Exterior noise was measured on the fuselage of a twin-engine, light aircraft at four values of engine rpm in ground static tests and at forward speeds up to 36 m/s in taxi tests. Propeller noise levels, spectra, and correlations were determined using a horizontal array of seven flush-mounted microphones and a vertical array of four flush-mounted microphones in the propeller plane. The measured levels and spectra are compared with predictions based on empirical and analytical methods for static and taxi conditions. Trace wavelengths of the propeller noise field, obtained from point-to-point correlations, are compared with the aircraft sidewall structural dimensions, and some analytical results are presented that suggest the sensitivity of interior noise transmission to variations of the propeller noise characteristics.

Mixson, J. S.

Shuttle bay acoustics

Acoustic energy generated during Shuttle liftoff will propagate up the orbiter vehicle, transmit through the payload bay structure, and produce an intense acoustic field inside the bay with the potential for damaging relatively fragile payload components. This paper describes three experimental programs aimed at investigating Shuttle bay acoustics. The first two experiments, conducted in July 1976 and January 1977 respectively, were concerned primarily with establishing the noise reduction of the OV101 payload bay structure; the third set of experiments, carried out during April and May 1978, was concerned with the influence of payloads on the bay acoustic levels. Test results are summarized, and comparisons with analytical model predictions are presented.

Piersol, A. G.

Evaluation of aero Commander propeller acoustic data: Static operations

Acoustic data are analyzed from a series of ground tests performed on an Aero Commander propeller-driven aircraft with an array of microphones flush-mounted on one side of the fuselage. The analyses were concerned with the propeller blade passage noise during static operation at several different engine speeds and included calculations of the magnitude and phase of the blade passage tones, the amplitude stability of the tones, and the spatial phase and coherence of the tones. The results indicate that the pressure field impinging on the fuselage represents primarily aerodynamic (near field) effects in the plane of the propeller at all frequencies. Forward and aft of the propeller plane aerodynamic effects still dominate the pressure field at frequencies below 200 Hz; but at higher frequencies, the pressure field is due to acoustic propagation from an equivalent center located about 0.15 to 0.30 blade diameters inboard from the propeller hub.

Piersol, A. G.

Use of coherence and phase data between two receivers in evaluation of noise environments

For certain types of noise control problems, where transducers cannot be mounted on suspected sources, valuable information can often be obtained by comparing the coherence and phase data measured between two closely spaced microphones with analytical models deduced from the physics of the problem. However, the application of such analysis techniques must be pursued with care, particularly when the measurements are made in a reverberant area. A simple illustration is presented where the acoustic field in the test section of a wind tunnel is evaluated by modelling the field as a combination of diffuse noise due to the boundary layer turbulence in the test section and propagating noise generated by the tunnel fan and possible flow disturbances outside the test section. The coherence and phase between two closely spaced microphones in the tunnel test section are predicted for various ratios of diffuse to propagating noise contributions and compared to actual measurements under several different tunnel operating conditions.

Piersol, A. G.