Engineering topics

Phillips, N.

Publications and source records attributed to Phillips, N..

3 records

NASA NTRS1989

Simulation studies of improved sounding systems

Two instrument designs for indirect satellite sounding of the atmosphere in the infrared are represented by the High Resolution Infra-Red Sounder, Model 2 (HIRS-2) and by the Advanced Meteorological Temperature Sounder (AMTS). The relative capabilities of the two instruments were tested by simulating satellite measurements from a group of temperature soundings, allowing the two participants to retrieve the temperature profiles from the simulated data, and comparing the results with the original temperature profiles. Four data sets were produced from radiosondes data extrapolated to a suitable altitude, representing continents and oceans, between 30S and 30N. From the information available, temperature profiles were retrieved by two different methods, statistical regression and inversion of the radiative transfer equation. Results show the consequence of greater spectral purity, concomitant increase in the number of spectral intervals, and the better spatial resolution in partly clouded areas. At the same time, the limitation of the HIRS-2 without its companion instrument leads to some results which should be ignored in comparing the two instruments. A clear superiority of AMTS results is shown.

Yates, H.↗

NASA NTRS1988

Results of a joint NOAA/NASA sounder simulation study

This paper presents the results of a joint NOAA and NASA sounder simulation study in which the accuracies of atmospheric temperature profiles and surface skin temperature measuremnents retrieved from two sounders were compared: (1) the currently used IR temperature sounder HIRS2 (High-resolution Infrared Radiation Sounder 2); and (2) the recently proposed high-spectral-resolution IR sounder AMTS (Advanced Moisture and Temperature Sounder). Simulations were conducted for both clear and partial cloud conditions. Data were analyzed at NASA using a physical inversion technique and at NOAA using a statistical technique. Results show significant improvement of AMTS compared to HIRS2 for both clear and cloudy conditions. The improvements are indicated by both methods of data analysis, but the physical retrievals outperform the statistical retrievals.

Phillips, N.↗

NASA NTRS1975

A three-dimensional dynamical-chemical model of atmospheric ozone

A three-year integration of a global three-dimensional model including dynamics and simple photochemistry is used to predict ozone. Good agreement with observation is obtained for stratospheric motion patterns, meridional circulations, ozone density as a function of height and latitude, eddy transports of ozone, surface destruction of ozone, and correlations of ozone with other variables. The annual cycle of columnar ozone in high latitudes is present, but at a smaller amplitude than observed. Vertical transport of ozone downward from the main generation level at 30 km is accomplished primarily by small-scale eddy diffusion between 20 and 30 km and again near the ground; large-scale vertical transport dominates in between. The model predicts a secondary maximum in ozone mixing ratio at 45 km somewhat equatorward of the winter polar-night zone. This feature, recently observed from satellite measurements, is thought to be caused by the temperature dependence of reaction rates in the Chapman scheme. The principal deficiency of the model is an underprediction of the spring ozone concentration in high latitudes in the lower stratosphere.

Cunnold, D.↗