Engineering topics

Peters, Palmer N.

Publications and source records attributed to Peters, Palmer N..

25 records · Page 2

NASA NTRS1991

Measurements of erosion characteristics for metal and polymer surfaces using profilometry

The surfaces of many materials exposed in low earth orbit are modified due to interaction with atomic oxygen. Chemical changes and surface roughening effects can occur which alter optical and other properties. The experiment A0114 contained 128 solid surface samples, half of which were exposed on the front and half on the rear of Long Duration Exposure Facility. Each sample was subjected to many analyses, but only the methods and techniques are described which were used to measure the changes in roughness, erosion depths, and material growth using profilometry.

Christl, Ligia C.↗

NASA NTRS1991

Pinhole cameras as sensors for atomic oxygen in orbit; application to attitude determination of the LDEF

Images produced by pinhole cameras using film sensitive to atomic oxygen provide information on the ratio of spacecraft orbital velocity to the most probable thermal speed of oxygen atoms, provided the spacecraft orientation is maintained stable relative to the orbital direction. Alternatively, as it is described, information on the spacecraft attitude relative to the orbital velocity can be obtained, provided that corrections are properly made for thermal spreading and a co-rotating atmosphere. The LDEF orientation, uncorrected for a co-rotating atmosphere, was determined to be yawed 8.0 minus/plus 0.4 deg from its nominal attitude, with an estimated minus/plus 0.35 deg oscillation in yaw. The integrated effect of inclined orbit and co-rotating atmosphere produces an apparent oscillation in the observed yaw direction, suggesting that the LDEF attitude measurement will indicate even better stability when corrected for a co-rotating atmosphere. The measured thermal spreading is consistent with major exposure occurring during high solar activity, which occurred late during the LDEF mission.

Peters, Palmer N.↗

NASA NTRS1990

YBa2Cu3Ox Superconductors Doped With AgO

Improved superconductive materials made by doping compressed powder destined to become YBa2Cu3Ox superconductors with AgO prior to heat treatment. Magnetic properties unlike those of any other superconductor. Specimen suspendable below as well as above magnets, and suspension stable as long as material remains superconductive.

Peters, Palmer N.↗

NASA NTRS1989

SQUID With Integral Flux Concentrator

In improved superconducting quantum interference device (SQUID), change in size and shape of superconducting ring improves coupling to external signal coil and eases coil-positioning tolerances. More rugged and easier to manufacture than conventional SQUID's with comparable electrical characteristics. Thin-film superconducting flux concentrator utilizes Meissner effect to deflect magnetic field of signal coil into central hole of SQUID. Used in magnetometers, ammeters, analog-to-digital converters, and related electronic applications in which high signal-to-noise ratios required.

Peters, Palmer N.↗

NASA NTRS1988

Planar thin film SQUID with integral flux concentrator

A thin film SQUID is disclosed having improved flux concentration combined with simplicity of design and fabrication. The SQUID starts with a wafer like substrate having simple planar geometry. A large area of superconducting film is coated on the substrate, with a small open or uncoated area remaining at its center to define a SQUID loop, and a gap in the film formed, beginning at the outer circumferential edge of the substrate and extending radially inward to the open area. A Josephson junction is formed across the gap near the open area to interrupt the electrical continuity of the SQUID loop. A coil is attached to the surface of the substrate, electrically insulated from the superconducting film, and is energized to induce flux within the SQUID which is concentrated within the open area.

Peters, Palmer N.↗

NASA NTRS1986

Free molecule drag and lift deduced from Shuttle flight experiment

A gas surface interaction experiment was flown on the STS-8 flight of the Space Shuttle in which atomic oxygen was allowed to reflect off a glassy carbon surface. The spatial distribution of the reflected molecules was recorded showing a lobe between the specular and normal directions. Using the Nocilla treatment of the reflected molecules, the speed ratio of the reflected molecules and the angle of the drifting velocity with respect to the surface were determined. This information is used to determine the drag coefficient of a sphere and the drag and lift coefficients of a flat plate.

Karr, Gerald R.↗

NASA NTRS1986

A measurement of the angular distribution of 5 eV atomic oxygen scattered off a solid surface in earth orbit

The angular distribution of 5 eV atomic oxygen scattered off a polished vitreous carbon surface was measured on a recent Space Shuttle flight. The experimental apparatus was of novel design, completely passive, and used thin silver films as the recording device for oxygen atoms. Most of the incident oxygen was contained in the reflected beam and remained in an active form and probably still atoms. Allowance was made for 12 percent loss of incident atoms which are converted to CO at the carbon surface. The scattered distribution which is wide lobular, peaking 15 deg in the forward direction, shows almost but not quite full accommodation.

Gregory, John C.↗