Engineering Papers⌕ Search

Engineering topics

Peng, Sheng Y.

Publications and source records attributed to Peng, Sheng Y..

Printed-Circuit Cross-Slot Antenna

Coupling between perpendicular slots suppressed. Balanced feed configuration minimizes coupling between slots of printed-circuit cross-slot antenna unit. Unit and array have conventional cavity-backed-printed-circuit, crossed-slot antenna design. Strip-line feeders behind planar conductive antenna element deliver power to horizontal slot in opposite phase. As result, little or no power propagates into vertical slot. Similar considerations apply to strip lines that feed vertical slot. Units of this type elements of phased-array antennas for radar, mobile/satellite communications, and other applications requiring flush mounting and/or rapid steering of beams with circular polarization.

Foy, Wong↗

Vehicle antenna for the mobile satellite experiment

A low profile, low cost, printed circuit, electronically steered, right hand circularly polarized phase array antenna system has been developed for the Mobile Satellite Experiment (MSAT-X) Program. The success of this antenna is based upon the development of a crossed-slot element array and detailed trade-off analyses for both the phased array and pointing system design. The optimized system provides higher gain at low elevation angles (20 degrees above the horizon) and broader frequency coverage (approximately 8 1/2 percent bandwidth) than is possible with a patch array. Detailed analysis showed that optimum performance could be achieved with a 19 element array of a triangular lattice geometry of 3.9 inch element spacing. This configuration has the effect of minimizing grating lobes at large scan angles plus it improves the intersatellite isolation. The array has an aperture 20 inches in diameter and is 0.75 inch thick overall, exclusive of the RF and power connector. The pointing system employs a hybrid approach that operates with both an external rate sensor and an internal error signal as a means of fine tuning the beam acquisition and track. Steering the beam is done electronically via 18, 3-bit diode phase shifters. A nineteenth phase shifter is not required as the center element serves as a reference only. Measured patterns and gain show that the array meets the stipulated performance specifications everywhere except at some low elevation angles.

Peng, Sheng Y.↗