Engineering Papers⌕ Search

Engineering topics

Pearson, J

Publications and source records attributed to Pearson, J.

31 records · Page 2

Optical design of Argonne/KICP detectors for CMB polarization.

We present simulations and measurements of a new optical coupling scheme for bolometric detectors for cosmic microwave background (CMB) polarization under development by Argonne National Labs and the University of Chicago. We show simulations of the performance and a tolerance analysis of this device along with measurements that validate its performance. Optical measurements of a prototype point to a 90% coupling efficiency with a cross-polarization below -20 dB.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Optical properties of Argonne/KICP TES bolometers for CMB polarimetry.

We present optical data on prototype polarization sensitive Argonne/KICP detectors fabricated at Argonne National Labs which are designed to be installed on the South Pole Telescope and used to measure the polarization of the Cosmic Microwave Background radiation. The detectors are Mo/Au transition edge sensors (TES) suspended on silicon nitride, with radiation coupled to the TES using a gold bar absorber. Two stacked detectors with bars in orthogonal directions will be used to measure both polarizations. We discuss measurements of the optical bandpass, time constants and cross-polarization of the detectors.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

{beta}-Delayed Deuteron Emission from {sup 11}Li: Decay of the Halo

The deuteron-emission channel in the {beta} decay of the halo nucleus {sup 11}Li was measured at the Isotope Separator and Accelerator facility at TRIUMF by implanting postaccelerated {sup 11}Li ions into a segmented silicon detector. The events of interest were identified by correlating the decays of {sup 11}Li with those of the daughter nuclei. This method allowed the energy spectrum of the emitted deuterons to be extracted, free from contributions from other channels, and a precise value for the branching ratio B{sub d}=1.30(13)x10{sup -4} to be deduced for E{sub c.m.}>200 keV. The results provide the first unambiguous experimental evidence that the decay takes place essentially in the halo of {sup 11}Li and that it proceeds mainly to the {sup 9}Li+d continuum, opening up a new means to study the halo wave function of {sup 11}Li.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Scanning tunneling microscope design with a confocal small field permanent magnet.

The field of ultra-sensitive measurements with scanning probes requires the design and construction of novel instruments. For example, the combination of radio frequency detection and scanning probe can be exploited to measure thermal properties and mechanical resonances at a very low scale. Very recent results by Komeda and Manassen (2008 Appl. Phys. Lett. 92 212506) on the detection of spin noise with the scanning tunneling microscopy (STM) have further expanded previous results reported by one of the authors of this manuscript (Messina et al 2007 J. Appl. Phys. 101 053916). In a previous publication, one of the authors used a new STM instrument (Messina et al J. Appl. Phys. 2007 101 053916 and Mannini et al 2007 Inorg. Chim. Acta 360 3837-42) to obtain the detection of electron spin noise (ESN) from individual paramagnetic adsorbates. The magnetic field homogeneity at the STM tip-sample region was limited. Furthermore, vacuum operation of the STM microscope was limited by the heat dissipation at the electromagnet and the radio frequency (RF) recovery electronics. We report here on a new STM head that incorporates a specially designed permanent magnet and in-built RF amplification system. The magnet provides both a better field homogeneity and freedom to operate the instrument in vacuum. The STM microscope is vacuum compatible, and vertical stability has been improved over the previous design (Messina et al 2007 J. Appl. Phys. 101 053916), despite the presence of a heat dissipative RF amplifier in the close vicinity of the STM tip.

47 OTHER INSTRUMENTATION↗

Tunable transport in magnetically coupled MoGe/permalloy hybrids.

We demonstrate controlled magnetotransport anisotropy of magnetically coupled superconductor-ferromagnet MoGe/Permalloy hybrids. The rotatable anisotropy Permalloy ferromagnet with stripe domain structure induces in-plane anisotropy in superconducting order parameter. We show that near the superconductor-normal state phase boundary the superconductivity in MoGe is localized in narrow mesoscopic channels just above the magnetic domain walls. Changing the in-plane direction of magnetic stripe domains it is possible to reconfigure the direction of the superconducting channels and controllably rotate the direction of the in-plane anisotropy axis in the superconductor.

36 MATERIALS SCIENCE↗

Frequency selective bolometer development at Argonne National Laboratory.

We discuss the development, at Argonne National Laboratory, of a four-pixel camera suitable for photometry of distant dusty galaxies located by Spitzer and SCUBA, and for study of other millimeter-wave sources such as ultra-luminous infrared galaxies, the Sunyaev-Zeldovich (SZ) effect in clusters, and galactic dust. Utilizing Frequency Selective Bolometers (FSBs) with superconducting Transition-Edge Sensors (TESs), each of the camera's four pixels is sensitive to four colors, with frequency bands centered approximately at 150, 220, 270, and 360 GHz. The current generation of these devices utilizes proximity effect superconducting bilayers of Mo/Au or Ti/Au for TESs, along with frequency selective circuitry on membranes of silicon nitride 1 cm across and 1 micron thick. The operational properties of these devices are determined by this circuitry, along with thermal control structures etched into the membranes. These etched structures do not perforate the membrane, so that the device is both comparatively robust mechanically and carefully tailored in terms of its thermal transport properties. In this paper, we report on development of the superconducting bilayer TES technology and characterization of the FSB stacks. This includes the use of new materials, the design and testing of thermal control structures, the introduction of desirable thermal properties using buried layers of crystalline silicon underneath the membrane, detector stability control, and optical and thermal test results. The scientific motivation, FSB design, FSB fabrication, and measurement results are discussed.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Soft magnetic lithography and giant magnetoresistance in superconducting/ferromagnetic hybrids.

We demonstrate an approach to create a tunable pinning potential in a superconducting/ferromagnetic (SC/FM) hybrid, allowing the switching of their electronic properties through the application of a small magnetic field. Using direct magneto-optical imaging, macroscopic transport, and magnetic measurements, we show that the alignment of stripe domains in the ferromagnet provides a remarkable directionality for the superconducting vortex motion. An analysis of the anisotropic flux motion demonstrates a substantial critical current anisotropy in the superconductor. The possibility of aligning stable lattices of stripe domains in select directions using in-plane magnetic fields allows the realization of soft magnetic lithography for efficient manipulation of supercurrent flow in SC/FM bilayers. Furthermore, in our samples we observed a pronounced magnetoresistance effect yielding 4 orders of magnitude resistivity change in a few millitesla in-plane field.

36 MATERIALS SCIENCE↗

Magnetoresistance anisotropy of a one-dimensional superconducting niobium strip.

We investigated confinement effects on the resistive anisotropy of a superconducting niobium strip with a rectangular cross section. When its transverse dimensions are comparable to the superconducting coherence length, the angle dependent magnetoresistances at a fixed temperature can be scaled as R({theta},H) = R(H/H{sub c{theta}}) where H{sub c{theta}} = H{sub c0}(cos{sup 2} {theta} + {gamma}{sup -2} sin{sup 2}{theta}){sup -1/2} is the angular dependent critical field, {gamma} is the width to thickness ratio, and H{sub c0} is the critical field in the thickness direction at {theta} = 0{sup o}. The results can be understood in terms of the anisotropic diamagnetic energy for a given field in a one-dimensional superconductor.

36 MATERIALS SCIENCE↗

Plasmon scanner and multiplexer.

Nanoholes and nanoslits are efficient sources of plasmons on metal surfaces. We use arc-shaped nanoslits in thin silver films for generating sub-wavelength plasmon spots with enhanced optical near-fields. Introduction of a continuous phase delay along the nanoslits shifts the position of the plasmon focus spot. We show experimentally that such a phase control allows to scan the plasmon focus by micrometers with a nanometer precision and to launch it on separate silver nanowires placed in the focal plane. These experiments, demonstrating scanning and multiplexing functionality, show the feasibility of the nanoscale manipulation with optical fields.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Charged-particle channels in the {beta}-decay of {sup 11}Li

We measured the {beta}-decay of the halo-nucleus {sup 11}Li, with particular attention to the deuteron- and triton-emission channels. We employed a post-accelerated beam of {sup 11}Li ions, and the implantation technique in a finely-segmented silicon detector. The channels of interest were identified through the time and space correlations between the implantation events and the parent and daughter decays. We obtained the branching ratios, as well as the spectra of the emitted ions.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗