Engineering Papers⌕ Search

Engineering topics

Payne, F. M.

Publications and source records attributed to Payne, F. M..

Recent Improvements in Semi-Span Testing at the National Transonic Facility (Invited)

Three wind tunnel investigations of a commercial transport, high-lift, semi-span configuration have recently been conducted in the National Transonic Facility at the NASA Langley Research Center. Throughout the course of these investigations multiple improvements have been developed in the facility semi-span test capability. The primary purpose of the investigations was to assess Reynolds number scale effects on a modern commercial transport configuration up to full-scale flight test conditions (Reynolds numbers on the order of 27 million). The tests included longitudinal aerodynamic studies at subsonic takeoff and landing conditions across a range of Reynolds numbers from that available in conventional wind tunnels up to flight conditions. The purpose of this paper is to discuss lessons learned and improvements incorporated into the semi-span testing process. Topics addressed include enhanced thermal stabilization and moisture reduction procedures, assessments and improvements in model sealing techniques, compensation of model reference dimensions due to test temperature, significantly improved semi-span model access capability, and assessments of data repeatability.

Gatlin, G. M.↗

Seven hole probe measurement of leading edge vortex flows

This paper discusses the use of a seven-hole probe on measurements of leading edge vortices of highly sweep delta wing planforms. Intrusive probe data taken with the pressure probe were compared with nonintrusive measurements made with laser Doppler anemometry system. In addition to probe size, the natural position of breakdown and the sweep angle of the wing are also factors in determining sensitivity of the flow to probe interference. At low angles of attach vortex breakdown does not occur in the vicinity of the model and the seven hole probe was found to yield reasonably accurate measurements. When the angle of attack of the model was increased so that vortex breakdown was near the trailing edge, introducing the probe over the wing would cause the breakdown position to move ahead of the probe. However, when breakdown naturally occurred ahead of the mid-chord of the wing the vortices were found to be less sensitive to a probe placed behind the breakdown point. Vortex breakdown on a lower swept wing is found to be more sensitive to interference. Near the breakdown region, seven hole probe measurement is less accurate due to a combination of probe interference and flow reversal.

Payne, F. M.↗

Experimental study of the velocity field on a delta wing

An experimental study of the leading edge vortices on delta wings at large angles of incidence is presented. A combination of flow visualization, seven-hole pressure probe surveys and laser velocimeter measurements were used to study the leading edge vortex formation and breakdown for a set of delta wings. The delta wing models were thin flat plates with sharp leading edges having sweep angles of 70, 75, 80, and 85 degrees. The flow structure was examined for angles of incidence from 10 to 40 degrees and chord Reynolds numbers from 85,000 to 640,000. Vortex breakdown was observed on all the wings tested. Both bubble and spiral modes of breakdown were observed. The visualization and wake survey data shows that when vortex breakdown occurs the core flow transforms abruptly from a jet-like flow to a wake-like flow. The result also revealed that probe induced vortex breakdown was more steady than the natural breakdown.

Payne, F. M.↗

Visualization of vortex breakdown on a delta wing

An account is given of the results obtained by a flow visualization study of the roll-up, breakdown position, and spiral- or bubble-type breakdown characteristics of an 85-deg sweep, flat-plate delta wing at large angles-of-attack. The two different breakdown modes were noted to metamorphose into each other, with the bubble-type phenomenon appearing to prefer a more upstream location relative to the spiral mode. In those instances when the breakdown location was changing, the breakdown took the form of a bubble when moving forward, and spiral when moving aft.

Nelson, R. C.↗

An experimental investigation of vortex breakdown on a delta wing

An experimental investigation of vortex breakdown on delta wings at high angles is presented. Thin delta wings having sweep angles of 70, 75, 80 and 85 degrees are being studied. Smoke flow visualization and the laser light sheet technique are being used to obtain cross-sectional views of the leading edge vortices as they break down. At low tunnel speeds (as low as 3 m/s) details of the flow, which are usually imperceptible or blurred at higher speeds, can be clearly seen. A combination of lateral and longitudinal cross-sectional views provides information on the three dimensional nature of the vortex structure before, during and after breakdown. Whereas details of the flow are identified in still photographs, the dynamic characteristics of the breakdown process were recorded using high speed movies. Velocity measurements were obtained using a laser Doppler anemometer with the 70 degree delta wing at 30 degrees angle of attack. The measurements show that when breakdown occurs the core flow transforms from a jet-like flow to a wake-like flow.

Payne, F. M.↗

Visualization and flow surveys of the leading edge vortex structure on delta wing planforms

In the present experimental investigation of thin delta wing vortex breakdown, for the cases of sweep angles of 70, 75, 80, and 85 deg, and smoke flow visualization/laser light sheet technique is used to obtain cross sectional views of the leading edge vortices as they break down. A combination of lateral and longitudinal cross sectional views furnishes data on the three-dimensional character of the vortex before, during, and after breakdown. Velocity measurements conducted with a laser Doppler anemometer on the 70 deg sweep delta, at 30 deg angle-of-attack, indicate that when breakdown occurs the core flow is transformed from a jet-like to a wake-like flow.

Payne, F. M.↗