Engineering Papers⌕ Search

Engineering topics

Paul M Danehy

Publications and source records attributed to Paul M Danehy.

63 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRSDate not supplied

Spatially-Resolved Freestream Velocity Measurements at the NASA Langley 31-Inch Mach 10 Air Tunnel Using FLEET

Freestream velocity measurements in the NASA Langley 31-inch Mach 10 wind tunnel are reported in this paper using Femtosecond Laser Electronic Excitation Tagging (FLEET). The freestream measurements acquired during the January 2023 test campaign were the first direct measurement of freestream velocity in this hypersonic wind tunnel facility. Spatial distributions of time-averaged and instantaneous velocity measurements were obtained at all three typical wind tunnel freestream unit Reynolds number conditions of Re∞/L = 1.8∙106 m-1, 3.6∙106 m-1, and 6.4∙106 m-1, though the current paper focuses on centerline measurements for the three Re∞/L and spatial distributions for one Re∞/L. Measured values for time-averaged velocity and mean of the instantaneous velocity at the wind tunnel centerline agree within 5 m/s or 0.4% of the calculated velocity from the facility data acquisition system. Measurements acquired at locations away from the wind tunnel centerline reveal the spatial extent of the core flow of the hypersonic facility.

FLEET↗
NASA NTRSDate not supplied

Scaling Laws of Ejecta Streaks in Lunar Landings

From the crewed Apollo missions of the 1960s to the recent Chang’e uncrewed lunar missions, the interaction between the supersonic exhaust and the lunar surface generates a striking ray system of ejecta particles that travel radially outward at high speeds. While this intriguing pattern has been observed in experiments and simulations, the underlying mechanism remains unclear. These radial ejecta streaks were also observed during an experimental campaign using a Mach 5.3 jet impinging on a granular bed within a large-scale vacuum chamber. Our findings reveal that the radial ejecta streaks are caused by the Gortler instability, which, due to the curvature of the extremely underexpanded jet, induces counter-rotating streamwise vortices within the jet shear layer. These vortices impact the ground and entrain particles in their upwash regions. Experimental measurements from both ground tests and the literature show that the number of streaks strongly depends on the jet diameter at impact and the shear layer thickness, further revealing a power-law scaling with the jet pressure ratio. These insights highlight the pivotal role of fluid dynamics in extraterrestrial landings and provide a foundation for mitigating risks in future planetary missions.

Lunar Landing↗
NASA NTRSDate not supplied

Wake Velocimetry of a Sphere-Cone Model in a Mach 10 Air Freestream using FLEET

Velocity measurements in the wake behind a sphere-cone-shaped vehicle wind tunnel model in a Mach 10 hypersonic air flow using femtosecond laser electronic excitation tagging (FLEET) are reported in this work. The FLEET measurements were performed at 1 kHz using a femtosecond laser centered at 800 nm and an ultrahigh-speed intensified camera system. The results reported here are for a single freestream condition corresponding to approximately Re ∞ /L = 3.6∙10 6 m -1 . The performance of the velocimetry instrument was evaluated in the quiescent test section at conditions relevant to the wake measurements. For velocity measurements in the wake, the FLEET measurement volume was translated to several radial locations from the model centerline in the vertical direction and at a streamwise location corresponding to approximately 12 mm from the payload. Reverse flow with mean velocities ranging from -12 m/s to -48 m/s were observed in the recirculating region of the wake, whereas hypersonic velocities in the range of 1079 m/s to 1183 m/s were observed in the free shear layer. A velocity uncertainty methodology is also outlined and applied for the reported measurements. The velocity data reported in this work is expected to play a significant role in the validation of computational codes modeling the hard-to-predict separated hypersonic wake.

FLEET↗
NASA NTRSDate not supplied

Towards Simultaneous Multi-Parameter Measurements Using Burst-Mode Frequency-Scanning Planar Laser-Induced Fluorescence

While planar laser-induced fluorescence (PLIF) can provide valuable flow visualization, there are many challenges in extracting quantitative measurements from the fluorescence intensity. To overcome the multi-parameter dependence of the signal intensity, frequency scanning planar laser-induced fluorescence (FS-PLIF) provides the potential for 2D temperature, pressure, and velocity measurements by spectrally resolving the excitation spectrum of one or more fluorescence transitions to extract the Doppler shift, Doppler- and collisional-broadening of absorption lines, and the relative signal intensities of multiple transitions. This work aims to characterize a burst-mode FS-PLIF system consisting of a Spectral Energies, LLC burst-mode laser coupled with a Spectral Energies, LLC optical parametric oscillator using nitric oxide (NO) static pressure cell measurements. The effect of the OPO cavity on intensity fluctuations during frequency-scanning is investigated. A NO PLIF model is implemented to investigate the feasibility of property measurements using single- and two-NO-line scans.

burst-mode laser↗
NASA NTRSDate not supplied

Wall-Jet Evolution During Plume-Surface Interaction Using PLIF Imaging

Planar laser-induced fluorescence (PLIF) flow visualization was used to examine the spatial evolution for the wall-jet formed by an impinging supersonic jet in a large-scale vacuum environment. This canonical configuration is representative of the plume-surface interaction induced by a rocket exhaust plume impinging on the planetary surface at lunar-relevant and Martian-relevant environments. PLIF flow visualization of the very low-density environment (as low as ~0.006% of standard atmospheric density) was performed using seeded nitric oxide in a nitrogen flow at three test conditions. Two conditions are representative of the lunar environment, and one is representative of the Martian environment. The combined images from two simultaneous PLIF views were used to construct a 2D slice of the flowfield spanning approximately 150 mm in height (determined by the laser sheet) and 500 mm in width (determined by the camera views). The three test conditions showed different behavior for the wall-jet, largely due to the different levels of lifting above the surface and the appearance of a physical process similar to a Kelvin–Helmholtz instability for the Martian-relevant case, which appeared to create a dramatic expansion of the wall-jet height with increased radial distance.

PSI↗
NASA NTRSDate not supplied

Directed Illumination of Sunlight Collimated and Observed Beneath A Lunar Lander (DISCOBaLL): Structured Illumination for a Lunar Surface Photogrammetry System

A lighting system has been developed to provide structured illumination allowing photogrammetry to be performed during and after landing on extraterrestrial bodies. The system, known as Directed Illumination of Sunlight Collimated and Observed Beneath a Lunar Lander (DISCOBaLL), provides patterned lighting suitable for two- and multiple-camera photogrammetry, allowing several different measurements to be obtained including pre-landing terrain shape, visualization and localization of the ejecta sheet during landing, and post-landing terrain shape enabling quantitative measurement of plume-induced cratering. The paper explains the methodology of designing the DISCOBaLL, describes multiple prototypes, and shows the performance of these prototypes using actual solar radiation in a laboratory setting.

Plume-Surface Interaction↗
NASA NTRSDate not supplied

Fiber-Based Multi-Resolution Imaging and Multidimensional X-ray Diagnostics for Ejecta Dynamics in Plume Surface Interactions

The interaction of a rocket exhaust plume with a particulate-laden surface creates a complex, multiphase flow field that can destabilize the vehicle and damage nearby equipment. This study investigates two methods for capturing the particulate dynamics of plume-surface interaction (PSI): optical fiber-based multi-resolution Mie scattering and multi-dimensional X-ray radiography. Mie scattering was used to track PSI-interacted particles, trace their paths, and measure velocities. While effective for the jet periphery and early PSI stages, the technique becomes limited as the scattering cross-section increases over time due to particle displacement from the soil bed, causing the core to become optically dense and appear as a luminous, opaque region. To address this, X-ray radiography was explored as a complementary method for visualizing the optically dense core. PSI experiments were conducted with both reacting and non-reacting jets to evaluate these approaches across a range of optical and flow parameters. The results demonstrated the capability of the fiber-based multi-resolution imaging system to capture simultaneous fields of view at varying magnifications (1x, 2x, 4x), and the ability of X-ray imaging to penetrate the optically dense plume, revealing flow structures that would otherwise be obscured in scattering-based methods. Data were collected for various PSI parameters, including three different heights above the surface, to analyze the ejecta properties and the plume’s temporal evolution. These results provide the first imaging strategy capable of resolving flow structures over a wide spatial dynamic range while also offering the first visualization of the optically dense core.

Ejecta↗
NASA NTRSDate not supplied

Wake Velocimetry of a Sphere-Cone Model in a Mach 10 Air Freestream using FLEET

Velocity measurements in the wake behind a sphere-cone-shaped vehicle wind tunnel model in a Mach 10 hypersonic air flow using femtosecond laser electronic excitation tagging (FLEET) are reported in this work. The FLEET measurements were performed at 1 kHz using a femtosecond laser centered at 800 nm and an ultrahigh-speed intensified camera system. The results reported here are for a single freestream condition corresponding to approximately Re ∞ /L = 3.6∙10 6 m -1 . The performance of the velocimetry instrument was evaluated in the quiescent test section at conditions relevant to the wake measurements. For velocity measurements in the wake, the FLEET measurement volume was translated to several radial locations from the model centerline in the vertical direction and at a streamwise location corresponding to approximately 12 mm from the payload. Reverse flow with mean velocities ranging from -12 m/s to -48 m/s were observed in the recirculating region of the wake, whereas hypersonic velocities in the range of 1079 m/s to 1183 m/s were observed in the free shear layer. A velocity uncertainty methodology is also outlined and applied for the reported measurements. The velocity data reported in this work is expected to play a significant role in the validation of computational codes modeling the hard-to-predict separated hypersonic wake.

FLEET↗