Engineering topics
Publications and source records attributed to Pauckert, R. P..
Data on the performance, stability, and thermal characteristics of an OME operating with an alternate injector configuration and with alternate propellants was obtained. The design, manufacturing, and operating characteristics of an electroformed, regeneratively cooled thrust chamber were also derived. Subscale and full scale tests provide data relating to off-design and transient operation.
Analyses and preliminary designs of candidate OME propellant combinations and corresponding engine designs were conducted and evaluated in terms of performance, operating limits, program cost, risk, inherent life and maintainability. For the Rocketdyne recommended and NASA approved propellant combination and cooling concept (NTO/MMH regeneratively cooled engine), a demonstration thrust chamber was designed, fabricated, and experimentally evaluated to define operating characteristics and limits. Alternate fuel (50-50) operating characteristics were also investigated with the demonstration chamber. Adverse operating effects on regenerative cooled operation were evaluated using subscale electrically heated tubes and channels. An investigation of like doublet element characteristics using subscale tests was performed. Full scale 8- and 10-inch diameter like-doublet injectors for the OME were designed, fabricated, and tested. Injector stability was evaluated analytically and experimentally.
An analytical and design study was conducted to compare the high and low contraction ratio thrust chambers for regenratively cooled orbit maneuvering engines for the space shuttle was conducted. The design concepts were evaluated on the basis of weight, pressure drop, and performance. Only the basic thrust chamber assembly was considered. The assembly consists of the injector, the regeneratively cooled thrust chamber, and the radiation cooled nozzle. A two dimensional thermal analysis of the channel section is provided.
A subscale injector test program conducted with a ten-inch diameter like-doublet injector to determine performance and heat flux profiles vs chamber pressure and propellant mixture ratio, and to determine stability characteristics with various acoustic cavity configurations is described. Results are presented.
The characteristics and performance of the orbit maneuvering engine for the space shuttle are discussed. Emphasis is placed on the regeneratively cooled thrust chamber of the engine. Tests were conducted to determine engine operating parameters during the start, shutdown, and restart. Characteristics of the integrated thrust chamber and the performance and thermal conditions for blowdown operation without supplementary boundary layer cooling were investigated. The results of the test program are presented.
The test program conducted to characterize the steady state stability, thermal, and performance characteristics of the integrated thrust chamber assembly, as well as limited tests to investigate transient characteristics are described.
The performance and heat transfer characteristics of a doublet element type injector for the space shuttle orbiter maneuvering engine thrust chamber were investigated. Ths stability characteristics were evaluated over a range of chamber pressures and mixture ratios. The specific objectives of the test were: (1) to determine whether stability has been influenced by injection of boundary layer coolant across the cavity entrance, (2) if the injector is stable, to determine the minimum cavity area required to maintain stability, and (3) if the injector is unstable, to determine the effects of entrance geometry and increased area on stability.
The stability characteristics of the like-doublet injector were defined over the range of OME chamber pressures and mixture ratios. This was accomplished by bomb testing the injector and cavity configurations in solid wall thrust chamber hardware typical of a flight contour with fuel heated to regenerative chamber outlet temperatures. It was found that stability in the 2600-2800 Hz region depends upon injector hydraulics and on chamber acoustics.
Tests were conducted on the regenerative cooled thrust chamber of the space shuttle orbit maneuvering engine. The conditions for the tests and the durations obtained are presented. The tests demonstrated thrust chamber operation over the nominal ranges of chamber pressure mixture ratio. Variations in auxiliary film coolant flowrate were also demonstrated. High pressure tests were conducted to demonstrate the thrust chamber operation at conditions approaching the design chamber pressure for the derivative space tug application.
Analysis to determine regenerative cooling limits of light hydrocarbons used with FLOX and OF2 over wide range of operating conditions
Regenerative cooling capabilities of light hydrocarbon fuels used with FLOX and oxygen fluorides