Engineering PapersSearch

Engineering topics

Parker, D. S.

Publications and source records attributed to Parker, D. S..

Nanometric modulations of the magnetic structure of the element Nd

The rare earth neodymium arguably exhibits the most complex magnetic ordering and series of magnetic phase transitions of the elements. Here we report the results of small-angle neutron scattering (SANS) measurements as a function of temperature and applied magnetic field to study magnetic correlations on nanometer length scales in Nd. We support these results with additional neutron diffraction, thermodynamic and synchrotron x-ray measurements. The SANS measurements reveal the presence of modulation vectors characterizing the ordered spin configuration which exhibit changes in magnitude and direction that are phase dependent. Between 5.9 and 7.6 K an additional modulation vector is observed with magnitude Q = 0.12 Å -1 . This scattering appears to originate from order of the Nd layers which contain a center of inversion. Tracking this modulation vector as a function of magnetic field indicates a phase boundary at ≈1 T. The modulation vectors observed in this study establish the presence of nanometer length scale spin textures which are likely stabilized by frustrated Ruderman–Kittel–Kasuya–Yosida (RKKY) interactions.

36 MATERIALS SCIENCE

A petrographic thin sectioning technique for evaluating composite materials

Petrographic thin sectioning by a low-speed diamond saw has been used in conjunction with transmission polarized light microscopy for the characterization of the microstructure and deformation mechanisms of a variety of polymer systems. It has proven possible by these means to study three types of thermoplastic matrices for composite applications: PEEK, BPA-based polycarbonate (PC), and a rubber-modified PC. The reinforcing fibers for these matrices were in all cases AS4 carbon fibers, unidirectionally arrayed. Superior analyzability of matrix morphology and subsurface fracture processes is achieved by thin sectioning.

Parker, D. S.

Factors influencing the Mode I interlaminar fracture toughness of a rubber toughened thermoplastic matrix composite

The use of a rubber modified thermoplastic resin has been investigated as a method to improve the Mode I interlaminar fracture toughness of a unidirectional continuous carbon fiber composite. Test results show that the improvement in the fracture toughness is less than expected due to rubber particle agglomeration, solvent and molding induced crystallization of the matrix and poor fiber/matrix adhesion. The plastic zone in composites utilizing tough matrices can extend well beyond a single interfibrillar spacing. However, the development of the plastic zone is limited due to the failure of the fiber/matrix interface. In order to fully evaluate the potential of tough composites using toughened matrices, any improvement made in the matrix toughness must be coupled with improvements in the fiber/matrix adhesion.

Parker, D. S.

Toughening of a thermoplastic matrix composite - Processing issues

The use of a rubber modified thermoplastic resin has been investigated as a method to improve the impact damage and the Mode I interlaminar fracture toughness of a unidirectional continuous carbon fiber composite. Test results show that the improvement in the fracture toughness is less than expected due to rubber particle agglomeration, poor fiber/matrix adhesion and the induced crystallization of the matrix. These restrictions must be eliminated in order to evaluate the maximum potential of a rubber toughened thermoplastic matrix on a composite's fracture toughness.

Parker, D. S.