Engineering topics
Publications and source records attributed to Pankove, J. I..
Thirty-five elements were implanted in GaN. Their photoluminescence spectra were measured and compared to those of an unimplanted control sample. Most impurities emit a peak at about 2.15 eV. Mg, Zn, Cd, Ca, As, Hg, and Ag have more characteristic emissions. Zn provides the most efficient recombination center. A set of midgap states is generated during the damage-annealing treatment.
The photoluminescence spectrum of Zn-implanted GaN peaks at 2.87 eV at room temperature. The emission efficiency decreases linearly with the logarithm of the Zn concentration in the range from 1 x 10 to the 18th to 20 x 10 to the 18th Zn/cu cm.
It is shown that zinc in gallium nitride forms an efficient radiative center emitting blue light at 2.86 plus or minus 0.02 eV and acts as a deep acceptor that can render the crystal insulating. A systematic variation of growth conditions indicates that an optimization of the photoluminescence efficiency is possible. Under nonoptimal conditions lower photon energy emission is obtained.
In order to improve the synthesis of GaN the effect of various growth and doping parameters has been studied. Although Be, Li, Mg, and Dy can be used to overcompensate native donors, the most interesting acceptor element is Zn. The emission spectrum and the luminescence efficiency depend on the growth temperature (below 800 C), on the partial pressure of the doping impurity, and on the duration of growth. Blue-green electroluminescence with a power efficiency of 0.1 percent and a brightness of 850 fL (at 0.6 mA and 22.5 V) was obtained. Some diodes allow the color of the emitted light to change by reversing the polarity of the bias. Continuous operation of a diode over a period of 5 months showed no evidence of degradation. The luminescence properties of ion-implanted GaN were studied. Delay effects were found in the electroluminescence of diodes, although, with a dc bias, a 70-MHz modulation was possible.
Injection lasers of gallium arsenic phosphide alloys studied for threshold current densities and emission efficiency
Electroluminescent diodes emission efficiency factor for application to lasers
Injection luminescent pumping of dysprosium doped calcium fluoride laser