Palko, R. L. | Engineering Papers

NASA NTRS1986

In-flight photogrammetric measurement of wing ice accretions

A photographic instrumentation system was developed for the Lewis icing research aircraft to measure wind ice accretions during flight. The system generates stereo photographs of the accretions which are then photogrammetrically measured by the Air Force Arnold Engineering and Development Center. The measurements yield a survey of spatial coordinates of an accretion's surface to an accuracy of at least + or - 0.08 cm. The accretions can then be matched to corresponding icing cloud and aerodynamic measurements. The system is being used to measure rime, mixed, and clear natural ice accretions.

Mcknight, R. C.↗

NASA NTRS1986

In-flight photogrammetric measurement of wing ice accretions

A photographic instrumentation system was developed for the Lewis icing research aircraft to measure wind ice accretions during flight. The system generates stereo photographs of the accretions which are then photogrammetrically measured by the Air Force Arnold Engineering and Development Center. The measurements yield a survey of spatial coordinates of an accretion's surface to an accuracy of at least + or - 0.08 cm. The accretions can then be matched to corresponding icing cloud and aerodynamic measurements. The system is being used to measure rime, mixed, and clear natural ice accretions.

Mcknight, R. C.↗

NASA NTRS1984

Documentation of ice shapes on the main rotor of a UH-1H helicopter in hover

A helicopter icing flight test program in the hover mode was conducted with a UH-1H aircraft. The ice formations were documented after landing by means of silicone rubber molds, stereo photography and outline tracings for later use in aerodynamic analyses. The documentation techniques are described and the results presented for a typical flight.

Lee, J. D.↗

NASA NTRS1979

Supercritical tests of a self-optimizing, variable-Camber wind tunnel model

A testing procedure was used in a 16-foot Transonic Propulsion Wind Tunnel which leads to optimum wing airfoil sections without stopping the tunnel for model changes. Being experimental, the optimum shapes obtained incorporate various three-dimensional and nonlinear viscous and transonic effects not included in analytical optimization methods. The method is a closed-loop, computer-controlled, interactive procedure and employs a Self-Optimizing Flexible Technology wing semispan model that conformally adapts the airfoil section at two spanwise control stations to maximize or minimize various prescribed merit functions subject to both equality and inequality constraints. The model, which employed twelve independent hydraulic actuator systems and flexible skins, was also used for conventional testing. Although six of seven optimizations attempted were at least partially convergent, further improvements in model skin smoothness and hydraulic reliability are required to make the technique fully operational.

Levinsky, E. S.↗

NASA NTRS1976

Utilization of the AEDC three-dimensional potential flow computer program

A potential flow computer program which has been in use for several years, was discussed. This program has been used primarily as a tool for flow-field analysis in support of test activities in transonic wind tunnels. Analyses have been made over a Mach number range from 0 to 0.9 for a variety of configurations from aircraft to wind tunnels, with excellent agreement between calculated flow fields and measured wind tunnel data. Analytical and experimental data for seven different flow analysis problems are presented in this paper.

Palko, R. L.↗