Engineering topics

Paillous, Alain

Publications and source records attributed to Paillous, Alain.

3 records

NASA NTRS1993

Spacecraft materials: Comparison between flight results obtained on LDEF and MIR

Two flight experiments dedicated to the study of the performance of materials in space have been carried out. Material samples have been exposed passively to low-Earth orbit (LEO) environment, then retrieved for laboratory study. The first experiment was conducted in the framework of the FRECOPA project and was flown on the trailing edge of the Long Duration Exposure Facility (LDEF) (exposure to vacuum and ultraviolet (UV) radiation for 5.5 years). The experiment COMES was installed outside of the MIR space station during an extravehicular activity; it was exposed to vacuum, O-atoms, and UV radiation for 1.1 year; and it was brought back to Earth by cosmonauts. The difference in exposure conditions and the use of transparent filters protecting some samples of COMES enable to differentiate the effects of UV radiation and oxygen atoms. The degradations of several thermal control coatings (paints, metalized polymeric films with and without ITO), structural materials, and optical components have been observed, measured, and compared after these two flight experiments. This paper summarizes various 'lessons learned' that can be used to identify aspects of space aging, to orient future research in this field, and to assist in spacecraft design.

Guillaumon, Jean-Claude↗

NASA NTRS1992

Spacecraft thermal control coatings

The Experiment AO 138-6 was located on the trailing edge of the Long Duration Exposure Facility as part of the French Cooperative Payload (FRECOPA) Experiment. It was purely passive in nature: material specimens 2 x 2 cm, independently mounted in sample-holders, with their surface in the same reference plane, were exposed to space. Thirty samples were set in a vacuum-tight canister which was opened in space a few days after LDEF deployment and closed while still in orbit ten months later; twenty-four samples were directly exposed to space for the total flight duration (preflight handling, shuttle bay environment, separation from shuttle, shuttle environment, LEO environment, docking, descent, transfer to KSC). Materials included paints (conductive or nonconductive), SSM's, polymeric films, surface coatings, composite materials, and metals. After sample retrieving, inspection and measurements were carried out in atmospheric laboratory conditions on each sample: observation with binocular lenses and scanning electron microscopy, spectral relectance and transmittance using an integrating sphere in the wavelength range 280-2300 nm, emissivity by the means of a Gier & Dunkle portable reflectometer, electron spectroscopy for chemical analysis-x-ray photoelectron spectroscopy (ESCA-XPS), and Rutherford backscattering spectroscopy (RBS) measurements on some selected samples. The results obtained from flight were compared to laboratory data obtained in UV-irradiation tests when these data were available. As a general statement a good spectral concordance is observed for all samples not in the canister so long as air recoveries are taken into account. For one material, the degradation is more important for the sample in the canister than for those of the same material mounted at the surface of the tray; for most samples in the canister the degradation is slightly higher than the one which can be predicted from laboratory standard irradiations. Contamination problems having been ruled out, the higher temperature experience by the samples on the inside of canister probably explains these phenomena.

Guillaumon, Jean-Claude↗

NASA NTRS1991

Spacecraft thermal control coatings (AO 138-6)

The experiment A0 138-6 was located on the trailing edge of LDEF as part of the Experiment FRECOPA. Material specimens 2 x 2 cm, independently mounted in sample-holders with their surface in the same reference plane, were exposed to space. Materials include paints (conductive or not), SSMs, polymeric films, surface coatings, composite materials, and metals. The results show that for some materials the degradation was higher for samples in the canister than for those directly mounted on the tray; contamination problems were ruled out, the higher temperature experienced by the samples inside the canister probably explains this phenomenon.

Paillous, Alain↗