Engineering topics

Owen, F. K.

Publications and source records attributed to Owen, F. K..

At least 37 records · Page 2

NASA NTRS1983

Application of laser velocimetry to unsteady flows in large scale, high speed tunnels

The optical, seeding, and data reduction procedures which have been used in the successful application of laser velocimetry to large-scale, unsteady, transonic wind-tunnel testing are described. Flowfield measurements obtained at several facilities are presented. These results include vortex flow measurements and ensemble-averaged data obtained under conditions of vortex-shedding, dynamic stall airfoil oscillation, oscillating trailing-edge control flaps, and helicopter rotor flow fields.

Owen, F. K.↗

NASA NTRS1982

An experimental verification of laser-velocimeter sampling bias and its correction

The existence of 'sampling bias' in individual-realization laser velocimeter measurements is experimentally verified and shown to be independent of sample rate. The experiments were performed in a simple two-stream mixing shear flow with the standard for comparison being laser-velocimeter results obtained under continuous-wave conditions. It is also demonstrated that the errors resulting from sampling bias can be removed by a proper interpretation of the sampling statistics. In addition, data obtained in a shock-induced separated flow and in the near-wake of airfoils are presented, both bias-corrected and uncorrected, to illustrate the effects of sampling bias in the extreme.

Johnson, D. A.↗

NASA NTRS1981

Measurements of flow quality in the Ames 2 x 2ft transonic wind tunnel

For decades, wind tunnel testing has been conducted in test section environments which have not been adequately documented. However, with the advent of the energy shortage, the need for improved fuel-efficient transports employing supercritical or LFC airfoils has increased the awareness of the possible influence of freestream turbulence on advanced experimental testing. This has already lead to detailed flow quality measurements in NASA transonic wind tunnels. The purpose of this paper is to present results of a study in the Ames 2 x 2 ft transonic wind tunnel.

Owen, F. K.↗

NASA NTRS1981

Transonic Flow Past a Symmetrical Airfoil at High Angle of Attack

The results of an experimental investigation of shock-induced stall and leading-edge stall on a 64A010 airfoil section are presented. Advanced nonintrusive techniques - laser velocimetry and holographic interferometry - were used in characterizing the inviscid and viscous flow regions. The measurements include Mach contours of the inviscid now regions, and mean velocity, flow direction, and Reynolds shear stress profiles in the separated regions. The experimental observations of this study are relevant to efforts to improve surface-pressure prediction methods for airfoils at or near stall.

Johnson, D. A.↗

NASA NTRS1980

Evaluation of flow quality in two large NASA wind tunnels at transonic speeds

Wind tunnel testing of low drag airfoils and basic transition studies at transonic speeds are designed to provide high quality aerodynamic data at high Reynolds numbers. This requires that the flow quality in facilities used for such research be excellent. To obtain a better understanding of the characteristics of facility disturbances and identification of their sources for possible facility modification, detailed flow quality measurements were made in two prospective NASA wind tunnels. Experimental results are presented of an extensive and systematic flow quality study of the settling chamber, test section, and diffuser in the Langley 8 foot transonic pressure tunnel and the Ames 12 foot pressure wind tunnel. Results indicate that the free stream velocity and pressure fluctuation levels in both facilities are low at subsonic speeds and are so high as to make it difficult to conduct meaningful boundary layer control and transition studies at transonic speeds.

Harvey, W. D.↗

NASA NTRS1980

Measurements of Unsteady Vortex Flowfields

A combined surface hot film and laser velocimeter measurement technique has been developed for the study of time-dependent turbulent flows. Data obtained in a compressible cylinder wake (M(sub infinity) = 0.6) are presented, and its structure in both the Eulerian and Lagrangian frames is discussed. Turbulence data obtained by conventional and phase averaging of the velocity fluctuations provide details of the small- and large-scale contributions to the total turbulent field.

Owen, F. K.↗

NASA NTRS1980

Separated skin-friction measurements - Source of error: An assessment and elimination

Potential sources of error in the use of heated surface gages for separated-skin-friction measurement are studied. Emphasis is placed on the interpretation of local skin-friction measurements in two- and three-dimensional separated turbulent-shear flows before they are used to test the validity of current and proposed computer codes.

Owen, F. K.↗

NASA NTRS1980

Experimental investigation of the asymmetric body vortex wake

An experimental investigation of the asymmetric body vortex wake of a circular cylinder in high subsonic flow is presented. Laser velocimeter, force and moment, and surface hot wire measurements were obtained for a freestream Mach number of 0.6 and Reynolds number (based on body diameter) of 0.62 x 10 to the 6th. Two component laser velocimeter measurements were made at three body cross-flow planes, x/d = 4, 8, and 12, and angles of attack of 25, 35, and 45 deg. Laser vapor screen photographs were also obtained at these body stations and angles of attack. Surface hot wire measurements were used to determine if any vortex switching occurred at various angles of attack of the body. The laser velocimeter measurements are related to the vapor screen photographs and side force measurements. These results show that more than one asymmetric body vortex wake configuration can exist for the same angle of attack and body roll angle.

Oberkampf, W. L.↗

NASA NTRS1980

Control of forebody vortex orientation to alleviate side forces

The paper deals with the salient phenomena of three-dimensional symmetric and asymmetric separated flows about typical forbodies at high angles of attack. Particular consideration is given to pressure, forces, and laser vapor screen measurements carried out on a 5-deg semiangle cone in a Mach 0.6 flow under turbulent conditions and supportive tests using a 16-deg semiangle tangent ogive.

Peake, D. J.↗

NASA NTRS1979

Control of forebody three-dimensional flow separations

The development of the turbulent symmetric and asymmetric vortex flow about the lee side of a 5 deg semiangle conical forebody at high relative incidence was investigated. The cone was immersed in a Mach 0.6 airstream at a Reynolds number of 13.5 x 10 to the 6th power based on the 1.4 m axial length of the cone. Small amounts of air injected normally or tangentially to the cone surface, but on one side of the leeward meridian and beneath the vortex farthest from the wall, were effective in biasing the asymmetry. With this reorientation of the forebody vortices, the amplitude of the side force could be reduced to the point where its direction was reversed. This phenomenon was obtained either by changing the blowing rate at constant incidence or by changing incidence at constant blowing rate. Normal injection appeared more effective than tangential injection. The contrarotating vortices in the penetrating jet flow were of opposite hand to the rotational directions of the forebody vortices. A distinctively organized and stable flow structure emerged with the jet vortices positioned above the forebody vortices.

Peake, D. J.↗

NASA NTRS1979

Transonic flow past a symmetrical airfoil at high angle of attack

The results of an experimental investigation of shock-induced stall and leading-edge stall on a 64A010 airfoil section are presented. Advanced nonintrusive techniques - laser velocimetry, holographic interferometry, and buried-wire anemometry - were used in characterizing the inviscid and viscous flow regions. The measurements include Mach contours of the inviscid flow regions, and mean velocity, flow direction and Reynolds shear stress profiles in the separated regions. The experimental observations of this study are relevant to efforts to improve surface pressure prediction methods for airfoils at or near stall.

Johnson, D. A.↗

NASA NTRS1979

Evaluation of flow quality in two NASA transonic wind tunnels

Tests have been conducted in the Langley Research Center 8-foot Transonic Pressure Tunnel and the Ames Research Center 12-foot pressure wind tunnel in order to measure characteristic disturbance levels and energy spectra in their respective settling chambers, test sections, and diffusers and to determine the sources of these disturbances. Results are presented and discussed along with some specific recommendations.

Owen, F. K.↗

NASA NTRS1979

Control of forebody three-dimensional flow separations

Some experiments involving the development of the turbulent symmetric vortex flow about the lee side of a 5 deg semiangle conical forebody at high relative incidence are discussed. The cone was immersed in a Mach 0.6 airstream at a Reynolds number of 13.5 million based on the 1.4 - m axial length of the cone. Novel means of controlling the degree of asymmetry using blowing very close to the nose were investigated. Small amounts of air injected normally or tangentially to the cone surface, but on one side of the leeward meridian and beneath the vortex farthest from the wall, were effective in biasing the asymmetry. With this reorientation of the forebody vortices, the amplitude of the side force could be reduced to the point where its direction was reversed. This phenomenon could be obtained either by changing the blowing rate at constant incidence or by changing incidence at constant blowing rate. Normal injection was more effective than tangential injection. An organized and stable flow structure emerged with the jet vortices positioned above the forebody vortices.

Peake, D. J.↗

NASA NTRS1979

Symmetrical and Asymmetrical separations about a yawed cone

Three-dimensional flow separations about a 5 degree (semiapex angle, theta sub C), 1.4 m long, circular cone up to moderately high relative incidence, alpha/theta sub C approximately 5, were studied in the Mach number range 0.3 M sub infinity 1.8. The cone was tested in the Ames 1.8 by 1.8 m wind tunnel at Reynolds numbers, R sub L infinity, based on the cone length, L, from 4.5 times 10 to the 6th power to 13.5 times 10 to the 6th power, under nominally zero heat transfer conditions. Overall forces and mean surface pressures were compared with earlier measurements. Supportive three-dimensional laser velocimeter measurements of mean and fluctuating velocity in a slightly asymmetric vortex wake about a slender tangent ogive cylinder at incidence having respective nose and overall body fineness ratios of 3.5 and 12, are included.

Peake, D. J.↗

NASA NTRS1978

Symmetrical and asymmetrical separations about a yawed cone

Three dimensional flow separations about a circular cone were investigated in the Mach number range 0.6 - 1.8. The cone was tested in the Ames 1.8 by 1.8 m wind tunnel at Reynolds numbers based on the cone length from 4,500,000 to 13,500,000 under nominally zero heat transfer conditions. Results indicate that: (1) the lee-side separated flow develops from initially symmetrically disposed and near-conical separation lines at angle of incidence/cone semiangle equal to approximately 1, with the free shear layers eventually rolling up into tightly coiled vortices at all Mach numbers; (2) the onset of asymmetry of the lee-side separated flow about the mean pitch plane is sensitive to Mach number, Reynolds number, and the nose bluntness; and (3) as the Mach number is increased beyond 1.8, the critical angle of incidence for the onset of asymmetry increases until at about M = 2.75 there is no longer any significant side force development.

Peake, D. J.↗

NASA NTRS1978

Measurements of unsteady vortex flow fields

A combined surface hot film and laser velocimeter measurement technique, used to obtain new information on the mean, constant phase-averaged and turbulent structure of time-dependent flow fields, is described. Data obtained in a cylinder wake are presented, and its structure in both the Eulerian and Lagrangian frames is discussed. Turbulence data obtained by conventional and conditional averaging of the velocity fluctuations are also presented. These data provide details of the small- and large-scale contributions to the total turbulent field.

Owen, F. K.↗

NASA NTRS1978

Wake vortex measurements of bodies at high angle of attack

Three-dimensional laser velocimeter measurements have been made of the wake vortices of a slender tangent-ogive body which had nose and body fineness ratios of 3.5 and 12, respectively. Data were obtained for an angle of attack to seminose angle ratio of 2.3 at a free-stream Mach number of 0.6 and unit Reynolds number of 2 million/ft. Details of the mean flow field are presented and features of the turbulent and unsteady nature of the vortex flow field are discussed. Problems associated with obtaining meaningful vortex measurements in high-speed flows are addressed.

Owen, F. K.↗

NASA NTRS1978

Applications of dynamic measurement techniques to wind-tunnel testing

The uses of laser Doppler velocimeter, hot wire, and surface hot film techniques in the study of turbulent flows are described, and data obtained in compressible flows are discussed. Applications are illustrated with measurements of wind tunnel freestream turbulence characteristics and with data obtained in transitional, turbulent, and separated shear flows. A new method which was developed for the study of time dependent and unsteady turbulent flows is also presented.

Owen, F. K.↗