Engineering Papers⌕ Search

Engineering topics

Ogrady, W. E.

Publications and source records attributed to Ogrady, W. E..

7 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

The effects of cations and anions on hydrogen chemisorption at Pt

Experimental evidence based on linear sweep voltammetry is presented to substantiate the view that ionic adsorption substantially shifts electrode potentials in addition to the relative heights of the hydrogen adsorption peaks. HClO4 and HF are chosen as better reference electrolytes for anion studies. The voltammetry curves for 0.1M HF and 0.1M HClO4 as well as the effect of adding successively increasing amounts of H2SO4 to these electrolytes are discussed. The measurements are also extended to alkaline solutions. Mechanisms whereby the addition of various cations and anions to electrolytes such as HF and HClO4 can induce changes in the structure of the hydrogen adsorption region in the voltammetry curves are identified: (1) blocking of sites by anion adsorption and coupling of hydrogen adsorption and anion desorption, (2) modification in the hydrogen adsorption energies for sites adjacent to adsorbed anions, (3) changes in the potential distribution across the interface, and (4) surface restructuring.

Huang, J. C.↗
NASA NTRS1977

Electrode surface studies by LEED-Auger

The role the electronic and geometric structures of the metal surface play in electrochemical surface reactions remains as yet an unknown factor. In order to investigate these surface contributions to electrochemical reactions, a low-energy-electron diffraction (LEED) and an Auger electron spectrometer (AES) have been combined with an electrochemical thin-layer cell. The surface to be studied electrochemically is first characterized by LEED-AES and then transferred into a second chamber where it becomes part of the electrochemical thin-layer cell. Electrochemical reactions are then run on this surface. The sample may then be transferred back to the LEED-AES chamber for further characterization. Data on Pt (111) will be presented.

Ogrady, W. E.↗
NASA NTRS1976

Oxygen electrocatalysts for life support systems

The irreversibility of the oxygen electrode increases by 30 to 60 percent the energy required for water electrolysis over the thermodynamic value in life support systems involving conventional water electrolysis cells. To minimize this voltage loss, high area electrocatalysts, such as platinum metal, are often used for the O2 anode, but even so, the losses are still very substantial. In an attempt to find more effective electrocatalysts for this application, a number of defect metal oxides have been examined.

Ogrady, W. E.↗
NASA NTRS1976

Catalysts for electrochemical generation of oxygen

An investigation of more effective catalysts for the electrolytic evolution of oxygen was made to understand the mechanism and kinetics for the electrocatalysis in relation to the surface electronic and lattice properties of the catalyst. An understanding was obtained for the structural features of the electrocatalysts. The kinetics and mechanism of anodic generation of O2 under well defined conditions in relation to the properties of electrode surface were evaluated.

Ogrady, W. E.↗
NASA NTRS1975

Electrochemical generation of oxygen. 1: The effects of anions and cations on hydrogen chemisorption and anodic oxide film formation on platinum electrode. 2: The effects of anions and cations on oxygen generation on platinum electrode

The effects were studied of anions and cations on hydrogen chemisorption and anodic oxide film formation on Pt by linear sweep voltammetry, and on oxygen generation on Pt by potentiostatic overpotential measurement. The hydrogen chemisorption and anodic oxide film formation regions are greatly influenced by anion adsorption. In acids, the strongly bound hydrogen occurs at more cathodic potential when chloride and sulfate are present. Sulfate affects the initial phase of oxide film formation by produced fine structure while chloride retards the oxide-film formation. In alkaline solutions, both strongly and weakly bound hydrogen are influenced by iodide, cyanide, and barium and calcium cations. These ions also influence the oxide film formation. Factors considered to explain these effects are discussed. The Tafel slope for oxygen generation was found to be independent on the oxide thickness and the presence of cations or anions. The catalytic activity indicated by the exchange current density was observed decreasing with increasing oxide layer thickness, only a minor dependence on the addition of certain cations and anions was found.

Huang, C. J.↗
NASA NTRS1975

Catalysts for electrochemical generation of oxygen

An effort was made to study the effects of cation and anion additions on oxygen evolution kinetics on platinum and the inhibitive or catalytic nature of the additions. The kinetics and mechanism of oxygen evolution on planitum metal in hydrofluoric and sulfuric acids, including the effects of foreign anions, were examined. The LEED-Auger-thin layer electrochemical system was developed for the examination of electrocatalytic surfaces. Samples for electrocatalytic LEED-Auger studies were prepared and examined.

Ogrady, W. E.↗