Engineering topics

Nowak, R. J.

Publications and source records attributed to Nowak, R. J..

10 records

NASA NTRS1991

Studies of shock/shock interaction on smooth and transpiration-cooled hemispherical nosetips in hypersonic flow

Experimental studies are conducted to examine the utilization of transpiration cooling to reduce the peak-heating loads in areas of shock/shock interaction. Smooth and transpiration-cooled nosetip models, 12 inches in diameter, were employed in these studies, which focused on defining the pressure distributions and heat transfer in type III and IV interaction areas. Transpiration cooling was determined to significantly increase the size of the shock layer and to move the peak-heating point around the body. A transpiration-cooling rate of more than 30 percent of the freestream maximum flux did not lower the peak-heating level more than 10 percent, but the integrated heating loads were reduced.

Holden, M. S.↗

NASA NTRS1984

Aerothermal tests of a 12.5 percent cone at Mach 6.7 for various Reynolds numbers, angles of attack and nose shapes

The effects of free-stream unit Reynolds number, angle of attack, and nose shape on the aerothermal environment of a 3-ft basediameter, 12.5 deg half-angle cone were investigated in the Langley 8-foot high temperature tunnel at Mach 6.7. The average total temperature was 3300 R, the freestream unit Reynolds number ranged from 400,000 to 1,400,000 per foot, and the angle of attack ranged from 0 deg to 10 deg. Three nose configurations were tested on the cone: a 3-in-radius tip, a 1-in-radius tip on an ogive frustum, and a sharp tip on an ogive frustum. Surface-pressure and cold-wall heating-rate distributions were obtained for laminar, transitional temperature in the shock layer were obtained. The location of the start of transition moved forward both on windward and leeward sides with increasing free-stream Reynolds numbers, increasing angle of attack, and decreasing nose bluntness.

Nowak, R. J.↗

NASA NTRS1983

Developing mass spectrometric techniques for boundary layer measurement in hypersonic high enthalpy test facilities

Thermodynamic flow properties of gases in the boundary layer or the flowfield have been mainly deduced from pressures and temperatures measured on a model. However, further progress with respect to an understanding of these properties requires a more complete characterization of the layer including determination of the gas composition and chemistry. Most attempts to measure boundary layer chemistry involve the employment of a mass spectrometer and an associated gas sampling system. The three major limiting factors which must be addressed for species measurement in aerothermodynamic investigations on models at reentry stream velocities, are gas sampling effects, instrument limitations, and problems with data acquisition. The present investigation is concerned with a concentrated effort to quantitatively identify and correct for instrument and sampling system effects, and to develop a miniaturized high performance mass spectrometer for on-model real-time analysis of the boundary layer and its associated atmosphere.

Wood, G. M., Jr.↗

NASA NTRS1982

Flightweight radiantly and actively cooled panel: Thermal and structural performance

A 2- by 4-ft flightweight panel was subjected to thermal/structural tests representative of design flight conditions for a Mach 6.7 transport and to off-design conditions simulating flight maneuvers and cooling system failures. The panel utilized Rene 41 heat shields backed by a thin layer of insulation to radiate away most of the 12 Btu/ft2-sec incident heating. A solution of ethylene glycol in water circulating through tubes in an aluminum-honeycomb-sandwich panel absorbed the remainder of the incident heating (0.8 Btu/sq ft-sec). The panel successfully withstood (1) 46.7 hr of radiant heating which included 53 thermal cycles and 5000 cycles of uniaxial inplane loading of + or - 1200 lfb/in; (2) simulated 2g-maneuver heating conditions and simulated cooling system failures without excessive temperatures on the structural panel; and (3) the extensive thermal/structural tests and the aerothermal tests reported in NASA TP-1595 without significant damage to the structural panel, coolant leaks, or hot-gas ingress to the structural panel.

Shore, C. P.↗

NASA NTRS1978

Recent advances in convectively cooled engine and airframe structures for hypersonic flight

A hydrogen-cooled structure for a fixed-geometry, airframe-integrated scramjet is described. The thermal/structural problems, concepts, design features, and technological advances are applicable to a broad range of engines. Convectively cooled airframe structural concepts that have evolved from an extensive series of investigations, the technology developments that have led to these concepts, and the benefits that accrue from their use are discussed.

Kelly, H. N.↗

NASA NTRS1978

Radiative, actively cooled panel tests results

The radiative, actively cooled panel designed to withstand a uniform incident heat flux of 136 kW/sq m to a 444 K surface temperature was evaluated. The test program consisted of preliminary static thermal mechanical loading and aerothermal flow tests. Test results are briefly discussed.

Shore, C. P.↗

NASA NTRS1978

Recent advances in convectively cooled engine and airframe structures for hypersonic flight

Research over the past decade has identified critical thermal/structural design problems and has produced viable design concepts for a second generation experimental scramjet. The design concepts for the hydrogen fuel-cooled engine structure involve a variety of innovative features to accommodate the harsh aerothermal environment encountered within the engine. The baseline concept which has evolved has reasonable mass characteristics, and cooling requirements which permit engine operation to Mach 9-10 without additional hydrogen for engine cooling. Studies have identified fabrication techniques and coolant passage configurations that increase fatigue life of the structure an order of magnitude over previous configurations.

Kelly, H. N.↗

NASA NTRS1976

Actively cooled airframe structures for high-speed flight

An assessment of forced convectively cooled aircraft structures is presented based on recent and on-going studies. Particular emphasis is given to contractual efforts in which large panels of three different concepts are being designed and fabricated for cyclic thermal-structural tests at the Langley Research Center. Results of ambient temperature fatigue tests of small specimens of these concepts are reviewed. Aspects of conceptual and detail designs, material selection, fabrication, reliability, and heat-load/hydrogen fuel heat-sink matching are discussed. Results to date indicate that active cooling significantly impacts the structural design process, and, despite the use of conventional aluminum materials, advanced complex fabrication processes are required.

Nowak, R. J.↗

NASA NTRS1972

Magnetogasdynamic heat transfer to a hemispherical body in a supersonic argon plasma.

Measurements of the heat transfer to a hemispherical body in a Mach 4.6, low density, argon plasma are reported. The experiments demonstrated that local wall currents affected the heat flux to the electrically conducting surface, both without and with internally applied magnetic fields. Such currents were induced by a nonuniform shock-layer plasma potential; but with applied fields, Hall currents dominated. Magnetic fields significantly increased the stagnation-region heat flux while causing a reduction over the remainder of the hemisphere. For an electrically nonconducting surface, the local heat flux was reduced, and magnetic fields insignificantly affected the heat flux. Analytical treatments indicate that joule and radiation heating were negligible.

Nowak, R. J.↗

NASA NTRS1966

Magnetoaerodynamic re-entry.

Entry flight, relation between laboratory flows, in-flight conditions and MGD effects on flow field, drag and heat transfer

FLOW FIELD↗