Engineering topics
Publications and source records attributed to Newman, W. H..
The method by which a commercial 4K CMOS PROM with polysilicon fuses was hardened and the feasibility of applying this method to a 16K PROM are presented. A description of the process and the necessary minor modifications to the original layout are given. The PROM circuit and discrete device characteristics over radiation to 1000K rad-Si are summarized. The dose rate sensitivity of the 4K PROMs is also presented.
An 0.8 percent fuel savings was achieved by a reduction in engine bleed air through the use of cabin air recirculation. The recirculation system was evaluated in revenue service on a DC-10. The cabin remained comfortable with reductions in cabin fresh air (engine bleed air) as much as 50 percent. Flight test verified the predicted fuel saving of 0.8 percent.
It is noted that a significant fuel savings can be achieved by reducing bleed air used for cabin air conditioning. Air in the cabin can be recirculated to maintain comfortable ventilation rates but the quality of the air tends to decrease due to entrainment of smoke and odors. Attention is given to a development system designed and fabricated under the NASA Engine Component Improvement Program to define the recirculation limit for the DC-10. It is shown that with the system, a wide range of bleed air reductions and recirculation rates is possible. A goal of 0.8% fuel savings has been achieved which results from a 50% reduction in bleed extraction from the engine.
A free-streamline potential flow model is developed for the flowfield external to a stationary jet or fan inlet in proximity to a ground plane. It is assumed that the flow is steady, incompressible, and irrotational. A two-dimensional flat plate geometry models the inlet configuration, and free streamline theory is used to avoid unrealistic infinite flow velocities at the lips of the inlet, and to account somewhat for flow separation. A water table experiment is used to verify the analytical results. The fact that the solutions are found to be limited to only a certain range of diameter-height ratios implies an overdetermination of the problem by free streamline theory. Also studied are the convective properties of small vortical disturbances superimposed on the ideal flow solution.