Engineering topics
Publications and source records attributed to Nash, Connor.
Cu/BEA was synthesized via incipient wetness impregnation with Cu(NO)3-2.5H2O to achieve 5 wt.% Cu loading. Bronsted acid sites were quantified with isopropylamine temperature programmed desorption.
The conversion of lignocellulosic-derived carbon sources via the creation of a CO2 rich syngas stream provides means to produce liquid hydrocarbon fuels, with advancements intended to create a cost-competitive method of sequential conversion via methanol and dimethyl ether intermediates. Previously developed methods with Cu/Beta zeolites enabled the conversion of dimethyl ether to linear and branched hydrocarbons, with high selectivities towards products with high-octane fuel properties. Through process intensification, use of a single reactor to convert syngas to methanol and DME, then further to hydrocarbons, allows for reduced capitol and operation cost for the same chemistries that typically use 3 reactors instead of one. Utilization of commercially available methanol synthesis catalyst (Megamax 800, Clariant, CZA) and methanol dehydration catalyst with the Cu/Beta catalyst allowed for conversion into hydrocarbon products in this single reactor set up. Reactor configuration with CZA and alumina catalysts mixed with or stacked in a bed physically above the Cu/Beta catalyst provided a system for the direct conversion of the syngas to hydrocarbons with improved yields and selectivities with higher net C1 conversions for stacked bed configurations. Through control of the process conditions, greater conversion of C1 oxygenate intermediates (i.e., methanol and dimethyl ether) was achieved with concomitant increase in selectivities towards gasoline and jet fuel range olefin and paraffin products. Lower hydrocarbon number products and less naphthenes were observed for the conversion of syngas compared to DME conversion on only the Cu/Beta system with prominent selectivities observed for C4, C5, and C7 hydrocarbons. The DME and methanol formation rates, with understanding of the equilibria for both processes, were determined as important factors to allow for improved performance of the Cu/Beta. Determination of the factors which allow for tuning of selectivities and yields created an intensified process which allows for a "market-responsive" biorefinery design, which can produce high octane gasoline or jet fuel range hydrocarbons to meet demands for a more sustainable route to liquid fuels.
Advanced catalytic materials play an enabling role in producing renewable fuels and chemicals from biomass, thereby helping meet the global climate-change goals set forth by the Intergovernmental Panel on Climate Change. Herein, we present a multiscale approach to accelerate the catalyst-process development cycle for catalytic fast pyrolysis (CFP) of biomass over Mo2C. Mo2C has been shown to possess co-localized acidic and metallic sites and exhibit high activity for deoxygenation of biomass pyrolysis model compounds. However, critical knowledge gaps remain regarding the effectiveness of this catalyst for CFP of whole biomass. We address these knowledge gaps and demonstrate that Mo2C is effective at deoxygenating biomass-pyrolysis products in the presence of H2 but that it undergoes rapid selective and non-selective deactivation. The knowledge gaps addressed from this integrated study, targeting appropriate experiments across scales and feed types, enabled identification of critical modifications for advancing the CFP catalyst-process development cycle.