Engineering Papers⌕ Search

Engineering topics

Nakamura, Y.

Publications and source records attributed to Nakamura, Y..

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Seismic structure of the moon - A summary of current status

A seismic model of the moon, refined from previous models with the aid of new data and analyses for seismic events recorded by four Apollo lunar seismic stations and a gravimeter, is outlined. The current model has five zones. The crust is 55-60 km thick. The surface is covered by regolith of varying thicknesses and low seismic velocity. The seismic Q's are extremely high. The upper mantle, 250 km thick, is characterized by seismic velocities close to those of the earth's upper mantle, and shear wave Q of about 4000. Tidally controlled deep moonquakes are concentrated near the boundary of the middle mantle, 600-700 km thick. A lower mantle extending to an undetermined depth is characterized by high attenuation of shear waves. The existence of a low-velocity core is only tentatively proposed.

Nakamura, Y.↗
NASA NTRS1975

Shallow lunar structure determined from the passive seismic experiment

Data relevant to the shallow structure of the moon obtained at the Apollo seismic stations are compared with previously published results of the active seismic experiments. It is concluded that the lunar surface is covered by a layer of low seismic velocity which appears to be equivalent to the lunar regolith defined previously by geological observations. This layer is underlain by a zone of distinctly higher seismic velocity at all of the Apollo landing sites. The regolith thicknesses at the Apollo 11, 12, and 15 sites are estimated from the shear-wave resonance to be 4.4, 3.7, and 4.4 m, respectively. These thicknesses and those determined at the other Apollo sites by the active seismic experiments appear to be correlated with the age determinations and the abundances of extralunar components at the sites.

Nakamura, Y.↗
NASA NTRS1975

Meteoroid flux from passive seismic experiment data

The meteoroid flux hitting the moon is recomputed using new information on the decrease of seismic signal amplitude with range. The new data are principally 17 large meteoroid impacts whose locations have been computed from recordings at all four of the operating Passive Seismic Experiment stations. These data suggest a rapid decrease in amplitudes beyond about 2200 km (chord range) which was not suspected earlier. The new estimate predicts the abundance of meteoroids with masses between 500 and 50,000 g. The result is considerably lower than estimates from earth-based observations, and close to our previous estimate from long-period lunar seismic data.

Duennebier, F.↗
NASA NTRS1974

Deep lunar interior inferred from recent seismic data

Analysis of recent data from lunar seismic events shows significant deviations of P- and S-wave travel times from those expected if the lunar interior were homogeneous below the crust. The interpretation of these data results in a lunar model consisting of at least four and possibly five distinguishable zones whose probable characteristics are discussed.

Nakamura, Y.↗
NASA NTRS1974

Explosive propulsion applications

The feasibility and application of an explosive propulsion concept capable of supporting future unmanned missions in the post-1980 era were examined and recommendations made for advanced technology development tasks. The Venus large lander mission was selected as the first in which the explosive propulsion concept can find application. A conceptual design was generated and its performance, weight, costs, and interaction effects determined. Comparisons were made with conventional propulsion alternatives. The feasibility of the explosive propulsion system was verified for planetology experiments within the dense atmosphere of Venus as well as the outer planets. Additionally, it was determined that the Venus large lander mission could be augmented ballistically with a significant delivery margin.

Nakamura, Y.↗
NASA NTRS1974

Lunar seismicity, structure, and tectonics

Natural seismic events have been detected by the long-period seismometers at Apollo stations 16, 14, 15, and 12 at annual rates of 3300, 1700, 800, and 700, respectively, with peak activity at 13- to 14-day intervals. The data are used to describe magnitudes, source characteristics, and periodic features of lunar seismicity. In a present model, the rigid lithosphere overlies an asthenosphere of reduced rigidity in which present-day partial melting is probable. Tidal deformation presumably leads to critical stress concentrations at the base of the lithosphere, where moonquakes are found to occur. The striking tidal periodicities in the pattern of moonquake occurrence and energy release suggest that tidal energy is the dominant source of energy released as moonquakes. Thus, tidal energy is dissipated by moonquakes in the lithosphere and probably by inelastic processes in the asthenosphere.

Lammlein, D. R.↗
NASA NTRS1974

Seismic scattering and shallow structure of the moon in Oceanus Procellarum

Scattering in a high-Q medium has been the best hypothesis to date for explaining the observation of a long, reverberating train of waves in lunar seismographs. To test this hypothesis qualitatively, two experiments were devised which simulated this scattering and reproduced actual lunar seismographs. Pulses were propagated across a plate with grooves cut half-way through, and then were propagated along the edge of a plate with holes drilled within a skin depth of the edge. The seismographs of near impacts and moonquakes recorded by the Apollo 12 station in two frequency bands were studied. The impacts were those of S4B Saturn boosters and LM ascent stages. Interpretation of these data suggests the existence of a scattering layer 25 km thick with a Q of 5000. The density of the scatterers decreases with depth, suggesting that they are associated with cratering, or that they consist of cracks which anneal with depth.

Dainty, A. M.↗
NASA NTRS1974

Results from the Apollo passive seismic experiment

Recent results from the Apollo seismic network suggest that primitive differentiation occurred in the outer shell of the moon to a depth of approximately 300 km; and the central region of the moon is presently molten to a radius of between 200 and 300 km. If early melting to a depth of 300 to 400 km was a consequence of accretional energy, very short accretion times are required. The best model for the zone of original differentiation appears to be a crust 40 to 80 km thick, ranging in composition from anorthositic gabbro to gabbro; overlying an ultramafic cumulate (olivine-pyroxene) about 250 km thick. The best candidate for the molten core appears to be iron or iron sulphide. A new class of seismic signals has recently been identified that may correspond to shallow moonquakes. These are rare, but much more energetic than the more numerous, deep moonquakes.

Lathum, G.↗
NASA NTRS1974

High-frequency lunar teleseismic events

A small number of seismic signals, including some of the strongest observed to date, have been identified as representing a fourth principal category of natural lunar seismic events with characteristics distinct from those produced by normal meteoroid impacts, deep moonquakes, and thermal moonquakes. These signals are much richer in high frequencies than other events observed at comparable distances, and display relatively impulsive P- and S-wave beginnings, indicating negligible seismic-wave scattering near the source. Source depths of these events may range between 0 and perhaps 300 km. These and other characteristics could represent either (1) meteoroids impacting upon outcrops of competent lunar crystal rock, (2) rare impacting objects that penetrate to competent rock below a scattering zone, or (3) shallow tectonic moonquakes.

Nakamura, Y.↗
NASA NTRS1973

Solid motor diagnostic instrumentation

A review of typical surveillance and monitoring practices followed during the flight phases of representative solid-propellant upper stages and apogee motors was conducted to evaluate the need for improved flight diagnostic instrumentation on future spacecraft. The capabilities of the flight instrumentation package were limited to the detection of whether or not the solid motor was the cause of failure and to the identification of probable primary failure modes. Conceptual designs of self-contained flight instrumentation packages capable of meeting these reqirements were generated and their performance, typical cost, and unit characteristics determined. Comparisons of a continuous real time and a thresholded hybrid design were made on the basis of performance, mass, power, cost, and expected life. The results of this analysis substantiated the feasibility of a self-contained independent flight instrumentation module as well as the existence of performance margins by which to exploit growth option applications.

Nakamura, Y.↗
NASA NTRS1973

New seismic data on the state of the deep lunar interior.

Direct shear-wave arrivals from seismic events originating on the far side of the moon are not observed at some of the stations of the Apollo seismic network. These data suggest that the material in the lunar interior at a depth of 1000 to 1100 kilometers is more dissipative for seismic shear waves than the lithosphere above, and possibly exists in a partially molten state akin to the earth's asthenosphere.

Nakamura, Y.↗
NASA NTRS1973

Passive seismic experiment

The network of seismometers installed by the Apollo 17 and other Apollo missions is described. The effects of the impacts of lunar modules and S-4B stages on the lunar surfaces are discussed. The information concerning lunar composition which is obtained by analyzing the seismic signals generated by moonquakes and meteoroid impacts are analyzed. It is concluded that the seismic activity within the moon is extremely low compared to that with the earth. The moon is characterized by a rigid, dynamically inactive outer shell, approximately 1000 kilometers thick, surrounding a core that has markedly different elastic properties.

Latham, G. V.↗
NASA NTRS1973

Moonquakes, meteoroids, and the state of the lunar interior

Analysis of data returned from the four stations of the Apollo Seismic Network has revealed that the lunar interior can be divided into two major zones: a rigid, dynamically inactive outer shell, about 1000 km thick (the lunar lithosphere); and a relatively weak central zone (the lunar asthenosphere) in which partial melting is probable. The transition between these two zones is gradual. Seismic activity within the moon is far below that of the earth. The small moonquakes that do occur originate near the base of the lithosphere, and appear to fall within two major belts. Tidal energy appears to be an important, if not the dominant, source of energy released as moonquakes. A secular component of moonquake energy release may result from slight thermal expansion or contraction of the moon, weak convection in the asthenosphere, or secular recession of the moon from the earth. Lack of shallow moonquake activity implies that the moon is neither expanding nor contracting at an appreciable rate at present.

Latham, G.↗
NASA NTRS1973

Study of acoustic emission during mechanical tests of large flight weight tank structure

A PPO-insulated, flight-weight, subscale, aluminum tank was monitored for acoustic emissions during a proof test and during 100 cycles of environmental test simulating space flights. The use of a combination of frequency filtering and appropriate spatial filtering to reduce background noise was found to be sufficient to detect acoustic emission signals of relatively small intensity expected from subcritical crack growth in the structure. Several emission source locations were identified, including the one where a flaw was detected by post-test x-ray inspections. For most source locations, however, post-test inspections did not detect flaws; this was partially attributed to the higher sensitivity of the acoustic emission technique than any other currently available NDT method for detecting flaws. For these non-verifiable emission sources, a problem still remains in correctly interpreting observed emission signals.

Mccauley, B. O.↗
NASA NTRS1972

Solid propulsion powered spacecraft concept.

The feasibility and application of a solid propulsion powered spacecraft concept to implement high-energy missions independent of multiplanetary swingby opportunities are assessed. The characteristics of suitable missions and spacecraft were formulated to determine their effects upon propulsion system selection and design. A cost-effectiveness analysis was conducted to provide a meaningful basis of comparing candidate designs. The results substantiated the feasibility of the powered spacecraft concept when used in conjunction with several intermediate-sized launch vehicles as well as energy margins by which to exploit extended mission capabilities. An outgrowth of this study included a new high-mass-fraction solid motor staging design whose performance predictions further enhanced the candidacy of the baseline configuration.

Nakamura, Y.↗
NASA NTRS1972

Moonquakes and lunar tectonism.

Review of the major discoveries that have resulted to date from the analysis of seismic data from a network of geophysical stations on the moon. It is found that lunar seismic signals differ greatly from typical terrestrial seismic signals; the moon possesses a crust and a mantle, at least in the region of the Apollo 12 and 14 stations; natural lunar events detected by the Apollo seismic network are moonquakes and meteoroid impacts; and in addition to the repeating moonquakes, moonquake 'swarms' have been discovered.

Latham, G.↗
NASA NTRS1972

Solid propulsion advanced concepts

The feasibility and application of a solid propulsion powered spacecraft concept to implement high energy missions independent of multiplanetary swingby opportunities are assessed and recommendations offered for future work. An upper stage, solid propulsion launch vehicle augmentation system was selected as the baseline configuration in view of the established program goals of low cost and high reliability. Spacecraft and propulsion system data that characterize mission performance capabilities were generated to serve as the basis for subsequent tradeoff studies. A cost effectiveness model was used for the preliminary feasibility assessment to provide a meaningful comparative effectiveness measure of the various candidate designs. The results substantiated the feasibility of the powered spacecraft concept when used in conjunction with several intermediate-sized launch vehicles as well as the existence of energy margins by which to exploit the attainment of extended mission capabilities. Additionally, in growth option applications, the employment of advanced propulsion systems and alternate spacecraft approaches appear promising.

Nakamura, Y.↗