Engineering Papers⌕ Search

Engineering topics

Nachtsheim, P. R.

Publications and source records attributed to Nachtsheim, P. R..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

A knowledge-based expert system for scheduling of airborne astronomical observations

KAOS (Kuiper Airborne Observatory Scheduler) is a knowledge-based expert system developed at NASA Ames Research Center to assist in route planning of a C-141 flying astronomical observatory. This program determines a sequence of flight legs that enables sequential observations of a set of heavenly bodies derived from a list of desirable objects. The possible flight legs are constrained by problems of observability, avoiding flyovers of warning and restricted military zones, and running out of fuel. A significant contribution of the KAOS program is that it couples computational capability with a reasoning system.

Nachtsheim, P. R.↗
NASA NTRS1985

A knowledge-based expert system for scheduling of airborne astronomical observations

The Kuiper Airborne Observatory Scheduler (KAOS) is a knowledge-based expert system developed at NASA Ames Research Center to assist in route planning of a C-141 flying astronomical observatory. This program determines a sequence of flight legs that enables sequential observations of a set of heavenly bodies derived from a list of desirable objects. The possible flight legs are constrained by problems of observability, avoiding flyovers of warning and restricted military zones, and running out of fuel. A significant contribution of the KAOS program is that it couples computational capability with a reasoning system.

Nachtsheim, P. R.↗
NASA NTRS1980

Unified treatment of lifting atmospheric entry

This paper presents a unified treatment of the effect of lift on peak acceleration during atmospheric entry. Earlier studies were restricted to different regimes because of approximations invoked to solve the same transcendental equation. This paper shows the connection between the earlier studies by employing a general expression for the peak acceleration and obtains solutions to the transcendental equation without invoking the earlier approximations. Results are presented and compared with earlier studies where appropriate.

Nachtsheim, P. R.↗
NASA NTRS1976

Atmospheric entry into Jupiter's atmosphere in view of recent flyby results

The paper examines the heating levels experienced by a probe entering Kliore's (1974) model of Jupiter's atmosphere and compares the results with those of the Jupiter model atmospheres given elsewhere (NASA SP-8069, 1971), with the heating levels of Tauber (1969) and Tauber and Wakefield (1971). The computations are made using a point-mass atmospheric entry trajectory program, i.e., the Allen-Eggers (1958) analysis and simple correlations of heating. Results of heating calculations are compared and discussed. It is found that the warm temperature bulge exists at a level too low in the atmosphere to affect any heating and that the nominal atmosphere fits Kliore's model atmosphere best insofar as heating is concerned. Previous estimates of the heating levels to be expected for a probe entering Jupiter's atmosphere are therefore unaffected by Kliore's postulated atmospheres.

Nachtsheim, P. R.↗
NASA NTRS1975

Outer planet atmospheric entry probes - An overview of technology readiness

Entry probe systems for characterizing, by in situ measurements, the atmospheric properties, chemical composition, and cloud structure of the planets Saturn, Uranus, and Jupiter are examined from the standpoint of unique mission requirements, associated subsystem performance, and degree of commonality of design. Past earth entry vehicles (PAET) and current planetary spacecraft (Pioneer Venus probes and Viking lander) are assessed to identify the extent of potential subsystem inheritance, as well as to establish the significant differences, in both form and function, relative to outer planet requirements. Recent research results are presented and reviewed for the most critical probe technology areas, including: science accommodation, telecommunication, and entry heating and thermal protection. Finally presented is a brief discussion of the use of decision analysis techniques for quantifying various probe heat-shield test alternatives and performance risk.

Vojvodich, N. S.↗
NASA NTRS1975

Shuttle launched flight tests - Supporting technology for planetary entry missions

The feasibility of conducting Space Shuttle-launched earth entry flight tests to enhance the technology base for second generation planetary entry missions is examined. Outer planet entry environments are reviewed, translated into earth entry requirements and used to establish entry test system design and cost characteristics. Entry speeds up to those needed to simulate radiative heating levels of more than 30 kW/sq cm are shown to be possible. A standardized recoverable test bed concept is described that is capable of accommodating a wide range of entry technology experiments. The economic advantage of shared Shuttle launches are shown to be achievable through a test system configured to the volume constraints of a single Spacelab pallet using existing propulsion components.

Vetter, H. C.↗
NASA NTRS1974

Volume-reflecting dielectric heat shield

White, volume-reflecting dielectric material absorbs essentially none of the incident radiant energy, and continues to reflect even though in severe environment its surface is melted and is being vaporized. Process of overall reflectance in dielectric material, involving internal refractions and reflections, is similar to process of reflection in paints.

Nachtsheim, P. R.↗
NASA NTRS1973

Shooting method for solution of boundary-layer flows with massive blowing

A modified, bidirectional shooting method is presented for solving boundary-layer equations under conditions of massive blowing. Unlike the conventional shooting method, which is unstable when the blowing rate increases, the proposed method avoids the unstable direction and is capable of solving complex boundary-layer problems involving mass and energy balance on the surface.

Liu, T.-M.↗
NASA NTRS1973

Numerical stability of boundary layers with massive blowing.

A basis is provided for examining the stability of so-called 'shooting methods' and to examine the stability of the method successfully applied by Nachtsheim and Green (1970) to boundary-layer flow with large injection and heat transfer. The stability of that method is examined and confirmed.

Liu, T.-M.↗
NASA NTRS1972

Numerical method for the solution of large systems of differential equations of the boundary layer type

A numerical method for the solution of large systems of nonlinear differential equations of the boundary-layer type is described. The method is a modification of the technique for satisfying asymptotic boundary conditions. The present method employs inverse interpolation instead of the Newton method to adjust the initial conditions of the related initial-value problem. This eliminates the so-called perturbation equations. The elimination of the perturbation equations not only reduces the user's preliminary work in the application of the method, but also reduces the number of time-consuming initial-value problems to be numerically solved at each iteration. For further ease of application, the solution of the overdetermined system for the unknown initial conditions is obtained automatically by applying Golub's linear least-squares algorithm. The relative ease of application of the proposed numerical method increases directly as the order of the differential-equation system increases. Hence, the method is especially attractive for the solution of large-order systems. After the method is described, it is applied to a fifth-order problem from boundary-layer theory.

Green, M. J.↗
NASA NTRS1972

Reflecting ablating heat shields for planetary entry.

Heat shielding for planetary entry probes of future Jovian and Venusian missions will encounter heating levels well beyond those previously experienced. These entries are typically dominated by radiative heating from the shock layer. This paper demonstrates the potential of reflecting this incident radiation diffusely from an ablating material. This technique contrasts with the absorption experienced by char-forming or graphitic ablators. Two dielectric materials, Teflon (polytetra-fluoroethylene) and boron nitride, are examined for their ablative performance, including reflection, in a combined convective- and radiative-heating environment. For Teflon, at the conditions obtained, superimposition of radiative heating upon a convective stream causes no additional increase in surface recession over the convective only results. For boron nitride, an excellent room-temperature reflector in the visible spectrum, a decrease in reflectivity from 90 to 55 percent is experienced when the surface undergoes sublimation at high temperatures. The process of reflection in each of these materials is described in terms of backscattering from crystals. The significance of a sizable reflection as a mode of energy accommodation is demonstrated for Venusian entries as a potential reduction in mass loss due to ablation.

Peterson, D. L.↗