Engineering PapersSearch

Engineering topics

Mysoor, Narayan R.

Publications and source records attributed to Mysoor, Narayan R..

Ka-Band SiGe Receiver Front-End MMIC for Transponder Applications

A fully integrated, front-end Ka-band monolithic microwave integrated circuit (MMIC) was developed that houses an LNA (low noise amplifier) stage, a down-conversion stage, and output buffer amplifiers. The MMIC design employs a two-step quadrature down-conversion architecture, illustrated in the figure, which results in improved quality of the down-converted IF quadrature signals. This is due to the improved sensitivity of this architecture to amplitude and phase mismatches in the quadrature down-conversion process. Current sharing results in reduced power consumption, while 3D-coupled inductors reduce the chip area. Improved noise figure is expected over previous SiGe-based, frontend designs

Venkatesan, Jaikrishna

Ka-Band Transponder for Deep-Space Radio Science

A one-page document describes a Ka-band transponder being developed for use in deep-space radio science. The transponder receives in the Deep Space Network (DSN) uplink frequency band of 34.2 to 34.7 GHz, transmits in the 31.8- to 32.3 GHz DSN downlink band, and performs regenerative ranging on a DSN standard 4-MHz ranging tone subcarrier phase-modulated onto the uplink carrier signal. A primary consideration in this development is reduction in size, relative to other such transponders. The transponder design is all-analog, chosen to minimize not only the size but also the number of parts and the design time and, thus, the cost. The receiver features two stages of frequency down-conversion. The receiver locks onto the uplink carrier signal. The exciter signal for the transmitter is derived from the same source as that used to generate the first-stage local-oscillator signal. The ranging-tone subcarrier is down-converted along with the carrier to the second intermediate frequency, where the 4-MHz tone is demodulated from the composite signal and fed into a ranging-tone-tracking loop, which regenerates the tone. The regenerated tone is linearly phase-modulated onto the downlink carrier.

Dennis, Matthew S.

Antenna cluster for spacecraft high effective isotropic radiated power (EIRP)

The results of a trade study comparing the single-antenna approach with the antenna-cluster approach are given, using a cluster of four antennas. The system architecture and the high-EIRP cluster concept are described. Advantages pf the cluster concept over a single antenna include electronic beam steering, reduced antenna mass, higher antenna efficiency, lower point density in the transmit system components, spatial power combing and graceful degradation.

spacecraft

Package Holds Five Monolithic Microwave Integrated Circuits

Packages protect and hold monolithic microwave integrated circuit (MMIC) chips while providing dc and radio-frequency (RF) electrical connections for chips undergoing development. Required to be compact, lightweight, and rugged. Designed to minimize undesired resonances, reflections, losses, and impedance mismatches.

Mysoor, Narayan R.

High Power Photodetectors for Space Communications Applications

High power photodetectors in coplanar waveguide and distributed traveling-wave structures have been under development for communications applications. The distributed photodetectors demonstrated 70percent efficiency with a linear response up to 25 mW of optical power input.

High Power Photodetectors

Wideband Linear Phase Modulator

Phase modulator for transmission in X band provides large phase deviation that remains nearly linear with voltage over relatively wide range. Operates with low loss over wide frequency band and with stable characteristics over wide temperature range. Phase modulator contains two varactor-diode phase shifters coupled via circulators. Separate drive circuit applies modulating voltages to varactor diodes. Modulation voltages vary in accordance with input to drive circuit.

Mysoor, Narayan R.

Performance results of a 300-deg linear phase modulator for spaceborne communications applications

A phase modulator capable of large linear phase deviation, low loss, and wide band operation with good thermal stability was developed for deep space spacecraft transponder (DST) applications at X-band (8.415 GHz) and Ka-band (32 GHz) downlinks. The design uses a two-stage circulator-coupled reflection phase shifter with constant gamma hyperabrupt varactors and an efficient modulator driver circuit to obtain a phase deviation of +/- 2.5 rad with better than 8 percent linearity. The measured insertion loss is 6.6 dB +/- 0.35 dB at 8415 MHz. Measured carrier and relative sideband amplitudes resulting from phase modulation by sine wave and square modulating functions agree well with the predicted results.

Mysoor, Narayan R.

An X-band spacecraft transponder for deep space applications - Design concepts and breadboard performance

The design concepts and measured performance characteristics are summarized of an X band (7162 MHz/8415 MHz) breadboard deep space transponder (DSP) for future spacecraft applications, with the first use scheduled for the Comet Rendezvous Asteroid Flyby (CRAF) and Cassini missions in 1995 and 1996, respectively. The DST consists of a double conversion, superheterodyne, automatic phase tracking receiver, and an X band (8415 MHz) exciter to drive redundant downlink power amplifiers. The receiver acquires and coherently phase tracks the modulated or unmodulated X band (7162 MHz) uplink carrier signal. The exciter phase modulates the band (8415 MHz) downlink signal with composite telemetry and ranging signals. The receiver measured tracking threshold, automatic gain control, static phase error, and phase jitter characteristics of the breadboard DST are in good agreement with the expected performance. The measured results show a receiver tracking threshold of -158 dBm and a dynamic signal range of 88 dB.

Mysoor, Narayan R.

Miniature X-band GaAs MMIC analog and bi-phase modulators for spaceborne communications applications

The design concepts, analyses, and the development of GaAs monolithic microwave integrated circuit (MMIC) linear-phase and digital modulators for the next generation of spaceborne communications systems are summarized. The design approach uses a very compact lumped-element, quadrature hybrid, and MESFET-varactors to provide low-loss and well-controlled phase performance for deep-space transponder (DST) applications. The measured results of the MESFET-diode show a capacitance range of 2:1 under reverse bias, and a Q of 38 at 10 GHz. Three cascaded sections of hybrid-coupled reflection phase shifters have been modeled and simulations performed to provide an X-band (8415 +/- 50 MHz) DST phase modulator with +/-2.5 radians of peak phase deviation.

Mysoor, Narayan R.

MMIC linear-phase and digital modulators for deep space spacecraft X-band transponder applications

The design concepts, analyses, and development of GaAs monolithic microwave integrated circuit (MMIC) linear-phase and digital modulators for the next generation of space-borne communications systems are summarized. The design approach uses a compact lumped element quadrature hybrid and Metal Semiconductor Field Effect Transistors (MESFET)-varactors to provide low loss and well-controlled phase performance for deep space transponder (DST) applications. The measured results of the MESFET-diode show a capacitance range of 2:1 under reverse bias, and a Q of 38 at 10 GHz. Three cascaded sections of hybrid-coupled reflection phase shifters were modeled and simulations performed to provide an X-band (8415 +/- 50 MHz) DST phase modulator with +/- 2.5 radians of peak phase deviation. The modulator will accommodate downlink signal modulation with composite telemetry and ranging data, with a deviation linearity tolerance of +/- 8 percent and insertion loss of less than 8 +/- 0.5 dB. The MMIC digital modulator is designed to provide greater than 10 Mb/s of bi-phase modulation at X-band.

Mysoor, Narayan R.

Design concepts and performance of NASA X-band transponder (DST) for deep space spacecraft applications

The design concepts and measured performance characteristics of an X band (7162 MHz/8415 MHz) breadboard deep space transponder (DST) for future spacecraft applications, with the first use scheduled for the Comet Rendezvous Asteroid Flyby (CRAF) and Cassini missions in 1995 and 1996, respectively. The DST consists of a double conversion, superheterodyne, automatic phase tracking receiver, and an X band (8415 MHz) exciter to drive redundant downlink power amplifiers. The receiver acquires and coherently phase tracks the modulated or unmodulated X band (7162 MHz) uplink carrier signal. The exciter phase modulates the X band (8415 MHz) downlink signal with composite telemetry and ranging signals. The receiver measured tracking threshold, automatic gain control static phase error, and phase jitter characteristics of the breadboard DST are in good agreement with the expected performance. The measured results show a receiver tracking threshold of -158 dBm and a dynamic signal range of 88 dB.

Mysoor, Narayan R.

Design and analysis of low-loss linear analog phase modulator for deep space spacecraft X-band transponder (DST) application

This paper summarizes the design concepts, analyses, and the development of an X-band transponder low-loss linear phase modulator for deep space spacecraft applications. A single section breadboard circulator-coupled reflection phase modulator has been analyzed, fabricated, and evaluated. Two- and three-cascaded sections have been modeled and simulations performed to provide an X-band DST phase modulator with +/- 2.5 radians of peak phase deviation to accommodate down-link signal modulation with composite telemetry data and ranging with a deviation linearity tolerance +/- 8 percent and insertion loss of less than 10 +/- 0.5 dB. A two-section phase modulator using constant gamma hyperabrupt varactors and an efficient modulator driver circuit was breadboarded. The measured results satisfy the DST phase modulator requirements, and excellent agreement with the predicted results.

Mysoor, Narayan R.

An electronically tuned, stable 8415 MHz dielectric resonator FET oscillator for space applications

A voltage-controlled 8415-MHz FET oscillator stabilized by a dielectric resonator is described. The oscillator provides over 3.2-MHz linear electronic tuning range with a flat power output equal to +1.8 dBm (27 C, nominal), a single-sideband noise-to-carrier ratio of -68 dBc/Hz at 1 kHz off carrier, and a frequency-temperature coefficient of 0.54 parts per million/C over a -24 C to 75 C range. The oscillator withstood 150 Krads (Si) of gamma radiation with no significant performance degradation. The overall performance of the FET oscillator is far superior in many ways to that of an equivalent bipolar oscillator for space applications. For space applications, the FET dielectric resonator oscillator (DRO) is preferred over bipolar DRO because of its lower DC power consumption, better thermal frequency stability, linear electronic tunability, and higher RF output power capability.

Mysoor, Narayan R.