Murthy, Durbha V. — Page 2 | Engineering Papers

NASA NTRS1990

Concurrent processing adaptation of aeroplastic analysis of propfans

Discussed here is a study involving the adaptation of an advanced aeroelastic analysis program to run concurrently on a shared memory multiple processor computer. The program uses a three-dimensional compressible unsteady aerodynamic model and blade normal modes to calculate aeroelastic stability and response of propfan blades. The identification of the computational parallelism within the sequential code and the scheduling of the concurrent subtasks to minimize processor idle time are discussed. Processor idle time in the calculation of the unsteady aerodynamic coefficients was reduced by the simple strategy of appropriately ordering the computations. Speedup and efficiency results are presented for the calculation of the matched flutter point of an experimental propfan model. The results show that efficiencies above 70 percent can be obtained using the present implementation with 7 processors. The parallel computational strategy described here is also applicable to other aeroelastic analysis procedures based on panel methods.

Janetzke, David C.↗

NASA NTRS1990

Concurrent processing adaptation of aeroelastic analysis of propfans

This paper reports on a study involving the adaptation of an advanced aeroelastic analysis program to run concurrently on a shared memory multiple processor computer. The program uses a three-dimensional compressible unsteady aerodynamic model and blade normal modes to calculate aeroelastic stability and response of propfan blades. The identification of the computational parallelism within the sequential code and the scheduling of the concurrent subtasks to minimize processor idle time are discussed. Processor idle time in the calculation of the unsteady aerodynamic coefficients was reduced by the simple strategy of appropriately ordering the computations. Speedup and efficiency results are presented for the calculation of the matched flutter point of an experimental propfan model. The results show that efficiencies above 70 percent can be obtained using the present implementation with 7 processors. The parallel computational strategy described here is also applicable to other aeroelastic analysis procedures based on parallel methods.

Murthy, Durbha V.↗

NASA NTRS1989

Solution and sensitivity analysis of a complex transcendental eigenproblem with pairs of real eigenvalues

This paper considers complex transcendental eigenvalue problems where one is interested in pairs of eigenvalues that are restricted to take real values only. Such eigenvalue problems arise in dynamic stability analysis of nonconservative physical systems, i.e., flutter analysis of aeroelastic systems. Some available solution methods are discussed and a new method is presented. Two computational approaches are described for analytical evaluation of the sensitivities of these eigenvalues when they are dependent on other parameters. The algorithms presented are illustrated through examples.

Murthy, Durbha V.↗

NASA NTRS1989

A computational procedure for automated flutter analysis

A direct solution procedure for computing the flutter Mach number and the flutter frequency is applied to the aeroelastic analysis of propfans using a finite element structural model and an unsteady aerodynamic model based on a three-dimensional subsonic compressible lifting surface theory. An approximation to the Jacobian matrix that improves the efficiency of the iterative process is presented. The Jacobian matrix is indirectly approximated from approximate derivatives of the flutter matrix, which are updated only in the direction of the last move. Examples are used to illustrate the convergence properties. The direct solution procedure facilitates the automated flutter analysis in addition to contributing to the efficient use of computer time as well as the analyst's time.

Murthy, Durbha V.↗

NASA NTRS1988

Experimental investigation of propfan aeroelastic response in off-axis flow with mistuning

Measured vibratory strain amplitudes from off-axis flow are compared for the blades of two, 8-bladed propfan model rotors with mistuning. One rotor had inherent mistuning. The other was intentionally mistuned by replacing every other blade of the first rotor with a blade of same geometry but different frequencies and mode shapes. The data shows that the intentional mistuning had a beneficial effect on the aeroelastic response of the propfan motors for a wide range of off-axis flow angles, blade pitch angles, and rotational speeds. Statistical trends of blade strain amplitudes are compared for both the rotors in terms of the ratio of the maximum to the mean and the coefficient of variation.

Mehmed, Oral↗

NASA NTRS1988

A computational procedure for automated flutter analysis

A direct solution procedure for computing the flutter Mach number and the flutter frequency is applied to the aeroelastic analysis of propfans using an unsteady aerodynamic model based on a three-dimensional subsonic compressible lifting surface theory. An approximation to the Jacobian matrix that improves the efficiency of the iterative process is presented. The Jacobian matrix is indirectly approximated from approximate derivatives of the flutter matrix. Examples are used to illustrate the convergence properties. The direct solution procedure facilitates the automated flutter analysis in addition to contributing to the efficient use of computer time as well as the analyst's time.

Murthy, Durbha V.↗

NASA NTRS1988

Derivatives of eigenvalues and eigenvectors of a general complex matrix

A survey of methods for sensitivity analysis of the algebraic eigenvalue problem for non-Hermitian matrices is presented. In addition, a modification of one method based on a better normalizing condition is proposed. Methods are classified as Direct or Adjoint and are evaluated for efficiency. Operation counts are presented in terms of matrix size, number of design variables and number of eigenvalues and eigenvectors of interest. The effect of the sparsity of the matrix and its derivatives is also considered, and typical solution times are given. General guidelines are established for the selection of the most efficient method.

Murthy, Durbha V.↗

NASA NTRS1988

A semianalytical technique for sensitivity analysis of unsteady aerodynamic computations

A semianalytical approach is developed for the sensitivity analysis of linear unsteady aerodynamic loads. The semianalytical approach is easier to implement than the analytical approach. It is also computationally less expensive than the finite difference approach when used with panel methods, which require a large number of panels. The semianalytical approach is applied to an isolated airfoil in a 2-D flow and rotating propfan blades in 3-D flow. Sensitivity coefficients with respect to non-shape-dependent variables are shown for some cases. It is expected that the semianalytical approach will be useful in aeroelastic design procedures particularly when mistuning is present, and that it is potentially useful for shape sensitivity analysis of linear unsteady aerodynamics.

Murthy, Durbha V.↗

NASA NTRS1988

Experimental investigation of propfan aeroelastic response in off-axis flow with mistuning

Measured vibratory strain amplitudes from off-axis flow are compared for the blades of two, 8-bladed propfan model rotors with mistuning. One rotor had inherent mistuning. The other was intentionally mistuned by replacing every other blade of the first rotor with a blade of same geometry but different frequencies and mode shapes. The data shows that the intentional mistuning had a beneficial effect on the aeroelastic response of the propfan motors for a wide range of off-axis flow angles, blade pitch angles, and rotational speeds. Statistical trends of blade strain amplitudes are compared for both the rotors in terms of the ratio of the maximum to the mean and the coefficient of variation.

Mehmed, Oral↗

NASA NTRS1988

Application of a semianalytical technique for sensitivity analysis of unsteady aerodynamic computations

A semianalytical approach is developed for the sensitivity analysis of linear unsteady aerodynamic loads. The semianalytical approach is easier to implement than the analytical approach. It is also computationally less expensive than the finite difference approach when used with panel methods which require a large number of panels. The semianalytical approach is applied to an isolated airfoil in a two-dimensional flow and rotating propfan blades in three-dimensional flow. Sensitivity coefficients with respect to nonshape-dependent variables are shown for some cases.

Murthy, Durbha V.↗

NASA NTRS1987

A computational procedure for automated flutter analysis

A direct solution procedure for computing the flutter Mach number and the flutter frequency is applied to the aeroelastic analysis of propfans using a finite element structural model and an unsteady aerodynamic model based on a three-dimensional subsonic compressible lifting surface theory. An approximation to the Jacobian matrix that improves the efficiency of the iterative process is presented. The Jacobian matrix is indirectly approximated from approximate derivatives of the flutter matrix. Examples are used to illustrate the convergence properties. The direct solution procedure facilitates the automated flutter analysis in addition to contributing to the efficient use of computer time as well as the analyst's time.

Murthy, Durbha V.↗

NASA NTRS1987

Survey of methods for calculating sensitivity of general eigenproblems

A survey of methods for sensitivity analysis of the algebraic eigenvalue problem for non-Hermitian matrices is presented. In addition, a modification of one method based on a better normalizing condition is proposed. Methods are classified as Direct or Adjoint and are evaluated for efficiency. Operation counts are presented in terms of matrix size, number of design variables and number of eigenvalues and eigenvectors of interest. The effect of the sparsity of the matrix and its derivatives is also considered, and typical solution times are given. General guidelines are established for the selection of the most efficient method.

Murthy, Durbha V.↗

NASA NTRS1987

Approximations to eigenvalues of modified general matrices

The reanalysis of non-self-adjoint dynamic models is computationally very expensive in design optimization applications. This paper describes several approximations that can be applied to eigenvalues of non-hermitian matrices to reduce that computational cost. Approximations based on eigenvalue derivatives, generalized Rayleigh quotient and the trace theorem are presented and their accuracy and computational cost are estimated. The accuracy and cost estimates are verified by applying the approximations to random matrices and matrices arising in flutter analysis of compressor blades. Recommendations are made for selection of the best approximation when the derivatives are available and when they are not. In particular, it is concluded that the quadratic approximation for eigenvalues should never be used as higher order approximations are always more accurate as well as more efficient.

Murthy, Durbha V.↗